Below is the procedure described for determination of paracetamol according to BP: "Weigh and powder 20 tablets. Add a quantity of powder equivalent to about 0.35 g paracetamol to 50 ml of 0.1 M NaOH, dilute with water to 200 ml and shake for 15 min. Add sufficient water to make up 250 ml. Filter the solution and dilute 5 ml of the filtrate to 100 ml with water. Dilute further 10 ml to 100 ml. Measure the absorbance at 257 nm. The A, = 715 at 257 nm". Which of the following is correct? %3D O a. An analyst can take 0.37g of the powdered tablets instead of 0.35. O b. An analyst can replace NaOH with HCI O C. An analyst can skip the shaking step O d. B andC e. All of the above

Below is the procedure described for determination of paracetamol according to BP: "Weigh and powder 20 tablets. Add a quantity of powder equivalent to about 0.35 g paracetamol to 50 ml of 0.1 M NaOH, dilute with water to 200 ml and shake for 15 min. Add sufficient water to make up 250 ml. Filter the solution and dilute 5 ml of the filtrate to 100 ml with water. Dilute further 10 ml to 100 ml. Measure the absorbance at 257 nm. The A, = 715 at 257 nm". Which of the following is correct? %3D O a. An analyst can take 0.37g of the powdered tablets instead of 0.35. O b. An analyst can replace NaOH with HCI O C. An analyst can skip the shaking step O d. B andC e. All of the above

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter11: Isolation Of Caffeine From Tea Le

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

25 ml of pickled brine was taken from an apple pickled with vinegar and diluted to 500 ml, 25 ml of this was taken and acidity was determined with 0.2 N (Factor: 1.05) NaOH. In the main trials, 6.3 ml - 6.5 ml - 6.9 ml, respectively, 0.1 ml base was used in the analysis without using the sample.For example, how many ppm is its acidity?
Determine a procedure to accurately create a 1.5•10^-6 mg Fe/mL solution using a 0.0500 mg Fe/mL standard solution and only having access to 100.0 mL volumetric flasks and 1.00, 2.00, 3.00, 4.00, 5.00 and 10.00 mL volumetric pipets. (You may have it make more than one solution by dilution to accomplish this)
During an assay of paracetamol by UV an analyst prepares a series of calibration solutions containing approximately 3-15 mcg/mL paracetamol as follows: 140.1 mg of pure paracetamol was added to a 200 mL volumetric flask. 0.1 M NaOH (50 mL) was added, the mixture well shaken and made up to volume with deionized water 10 mL of the above solution was diluted to 100 mL 1)What is the concentration of the final diluted solution in mcg/mL?(1 decimal) 2) What volume of the diluted solution is required to prepare 100 mL of a 8 mcg/mL standard solution? (1 decimal)
11. How much caffeine can be extracted using 50.0ml of DCM if a tea bag contains 15 grams of tea leaves with 0.9% of caffeine? And has undergone solid-liquid extraction with 100ml of distilled water followed by liquid-liquid extraction using DCM. The solubility of caffeine requires 15 ml of water and 2.0ml of DCM for 40.0mg. a 6.1 x 10^-5 b 6.0 x 10^-5 c 7.0 x 10^-5 d 7.1 x 10^-5
Make a schematic diagram for the procedure below: B. % SO3 determination Dry the soluble sulfate sample at 100° C for 1-2 hours, and cool in desiccator. Weigh out 0.5 – 0.7 g (± 0.3 mg) duplicates sample. Transfer to 400-mL beakers. Dissolve each in 200 mL of dist. H2O + 4 mL of 6 m HCl. Precipitant is prepared by dissolving 1.3 g BaCl2 ∙ H2O in 100 mL water. Filter if solution is not perfectly clear. Heat the BaCl2 solution and sulfate sample solution nearly to boiling, and then add the entire amount to the HOT sulfate sample solution while stirring vigorously. Wash stirring rod with distilled water and include washings in your final mixture. Digest by letting stand 1-2 hours. Overnight standing is acceptable. Filter through an ash less filter paper of fine porosity (Whatman no. 42). Slowly pour the supernatant liquid through the filter paper.
From a 10-mL sample, a 1-mL aliquot was taken and diluted to 100mL. From this, a 5-mL aliquot was taken and diluted to 20mL.The final 20mL was found to have a concentration of 0.004M analyte X.What is the concentration of analyte X in the 10-mL sample?
why is it necessary to test the ph? PROCEDURE To a six inch test tube was added thiamine hydrochloride (0.65 g), followed by water (2mL). The mixture was gently shaken until homogeneous, and then ethanol (7.5 mL)was added. Finally, sodium hydroxide (10%, 1.5 mL) was added and the mixture wasgently stirred to ensure complete mixing.Benzaldehyde (3.8 mL) was then added at room temperature in one portion with gentlestirring. The pH of the resulting reaction mixture was determined and adjusted to >10by dropwise addition of 10% sodium hydroxide.
You are given a container with Na3PO3 that is reportedly contaminated. You are asked by your supervisor to determine the percent purity of that sample in order to know the next measures to be taken by the plant. The following are the procedures that you need to do: a. Dissolve sample weighing 1 g in 35 mL water. b. Prepare solution with 45 mL 3% w/v HgCl2, 30 mL 10% w/v C2H3NaO2 and 10 mL CH3COOH. c. Digest sample then filter then rinse the precipitate that weighs 0.2857 g. d. Compute for the % purity.
Indicate the appropriate protocol below to prepare the required solution. a) Solution 5 Preparation: Prepare: 10 mL of 23% mannitol From: solid mannitol Procedure: b) Solution 2 Preparation: Prepare: 0.5 liters of 0.01 mg/mL ascorbic acid From: solid ascorbic acid , MW = 176.1 g/mol Procedure: C) Solution 3 Preparation: Prepare: 1 liter of 150 mM Tris From: 1 Molar Tris stock solution Procedure:
How will you prepare standard solution of catechin (50, 100, 150, 200, 250 and 300 mg/L) scaled down to 50 mL?
From the six analytes listed below, n-octanal, n-octane, 1-chlorooctane, n-octanol, n-heptane, and n-octanoic acid predict retention order (shortest to longest retention times) if the SP is: 100% polyethylene glycol or 100% dimethylpolysiloxane.
Tim is interested in analyzing for Pyraclostrobin (pesticide) in strawberries using QuECHers method for extraction and clean up before analysis with HPLC-uv. The concentration of the Pyraclostrobin in the fruits that he sampled is thought to be between 1-10 ng pesticide per g fruit fresh weight. The HPLC-uv instrument he is using has a LoQ of 5 ppb for Pyraclostrobin. Tim is starting out with 500 mg of the sliced fruit