Commercial perchloric acid is an aqueous solution containing 70% by mass HCIO, (100.46 g mol") and has a density of 1.664 g mL. How many mL of commercial perchloric acid should be usedto prepare a 340 mL 0.365 M HCIO,(ag) solution?Do not write units, only enter numerical values.Use two digits at most for decimal numbers, use dot (.) as decimal separator (i.e. two-point-fifty-one should be entered as 2.51). Do not use comma () as decimal separator.

Mass percentage or percentage by weight is one of the concentration terms that indicates the mass of…

Commercial perchloric acid is an aqueous solution containing 70% by mass HCIO, (100.46 g mol") and has a density of 1.664 g mL. How many mL of commercial perchloric acid should be used to prepare a 340 mL 0.365 M HCIO,(aq) solution? Do not write units, only enter numerical values. Use two digits at most for decimal numbers, use dot (.) as decimal separator (i.e. two-point-fifty-one should be entered as 2.51). Do not use comma (,) as decimal separator.

Commercial perchloric acid is an aqueous solution containing 70% by mass HCIO, (100.46 g mol") and has a density of 1.664 g mL. How many mL of commercial perchloric acid should be used to prepare a 340 mL 0.365 M HCIO,(aq) solution? Do not write units, only enter numerical values. Use two digits at most for decimal numbers, use dot (.) as decimal separator (i.e. two-point-fifty-one should be entered as 2.51). Do not use comma (,) as decimal separator.

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 62QAP

See similar textbooks

Similar questions

What mass of HCl is contained in 45.0 mL of an aqueous HCl solution that has a density of 1.19 g cm-3 and contains 37.21% HCl by mass?
The units of parts per million (ppm) and parts per billion (ppb) are commonly used by environmental chemists. In general, 1 ppm means 1 part of solute for every 106 parts of solution. Mathematically, by mass: ppm=gsolutegsolution=mgsolutekgsolution In the case of very dilute aqueous solutions, a concentration of 1.0 ppm is equal to 1.0 g of solute per 1.0 mL, which equals 1.0 g solution. Parts per billion is defined in a similar fashion. Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O
A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
A throat spray is 1.40% by mass phenol, C6H5OH, in water. If the solution has a density of 0.9956 g/mL, calculate the molarity of the solution.
D5W is a solution used as an intravenous fluid. It is a 5.0% by mass solution of dextrose (C6H12O6) in water. If the density of D5W is 1.029 g/mL, calculate the molarity of dextrose in the solution.
A student wants to prepare 1.00 L of a 1.00-M solution of NaOH (molar mass = 40.00 g/mol). If solid NaOH is available, how would the student prepare this solution? If 2.00 M NaOH is available, how would the student prepare the solution? To help ensure three significant figures in the NaOH molarity, to how many significant figures should the volumes and mass be determined?