Draw the reactance diagram for the following power system. Consider a base of 13.8 KV and 44 MVA in the circuit of generator 1. G 1 : 20 MVA, 13.8 KV, X // = 20% G 2 : 30 MVA, 18 KV, X // = 20% G 3 : 30 MVA, 20 KV, X // = 20% T 1: 25 MVA, 220Y/13.8Δ KV, x = 10% T 2: 30 MVA, 220Y/18Δ KV, x = 10% Reactance of the transmission line = j 0.8 p.u on a base of 220 KV and 30 MVA

Draw the reactance diagram for the following power system. Consider a base of 13.8 KV and 44 MVA in the circuit of generator 1. G 1 : 20 MVA, 13.8 KV, X // = 20% G 2 : 30 MVA, 18 KV, X // = 20% G 3 : 30 MVA, 20 KV, X // = 20% T 1: 25 MVA, 220Y/13.8Δ KV, x = 10% T 2: 30 MVA, 220Y/18Δ KV, x = 10% Reactance of the transmission line = j 0.8 p.u on a base of 220 KV and 30 MVA

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10P: For the circuit element of Problem 2.3, calculate (a) the instantaneous power absorbed, (b) the real...

See similar textbooks

Similar questions

A 210V, 50 Hz, single phase radial distribution system, the resistance of the wire is 0.0008 ohm/m supply and return. Two loads are connected and it consumes 10 and 10 A respectively and are fed from the cable at distance of 15 and 15 respectively. Calculate the voltage available across load 1 and 2
In a house there is a three-wire system configured as follows: A refrigerator with an impedance of (10 + j 10) Ω is connected to line L1 and to a neutral. And to line L2 and neutral all the lighting in the house consisting of 10 luminaires of 20 W each. In addition, there is a 240 V dryer that consumes 8 kW connected between the two lines. Calculate current in line L1, line L2 and neutral total power consumed Problem was Initially stated in spanish, i will add it in case it works. En una vivienda se tiene un sistema trifilar configurado de la siguientemanera. Se tiene conectada a la línea L1 y a neutro una refrigeradora con impedancia de (10 + j 10)Ω y a la línea L2 y neutro toda la iluminación de la casa consistente en 10 luminarias de 20 W cadauna. Además, se tiene una secadora a 240 V que consume 8 kW. Calcule a) corriente de la línea L1 yde la línea L2 y de neutro b) potencia total consumida.
Given a 400sq.m single family dwelling unit to be provided with 230V, 1-phase, 2-wire be service, andhaving the following loads: 2-1.5hp A/C, 2-1.0hp A/C, 1-0.5hp water pump, 4-800W water heater, 2-6kWelectric range and 2-1kW microwave oven, determine a) the total connected load, b) the total demand load,c) the overall %demand factor, d) the size of THW feeder conductor, ground wire and IMC conduit, e) therating of feeder overcurrent protection using inverse time circuit breaker
(1) Given a 400sq.m single family dwelling unit to be provided with 230V, 1-phase, 2-wire service, and having the following loads: 2-1.5hp A/C, 2-1.0hp A/C, 1-0.5hp water pump, 4-800W water heater, 2-6kW electric range and 2-1kW microwave oven, determine the total connected load in volt-ampere (VA). (2) Given a 400sq.m single family dwelling unit to be provided with 230V, 1-phase, 2-wire service, and having the following loads: 2-1.5hp A/C, 2-1.0hp A/C, 1-0.5hp water pump, 4-800W water heater, 2-6kW electric range and 2-1kW microwave oven, determine the rating of feeder overcurrent protection in ampere-trip (AT) using inverse time circuit breaker. Write your answer in numerical format without decimal places
Given a 400sq.m single family dwelling unit to be provided with 230V, 1-phase, 2-wire service, and having the following loads: 2-1.5hp A/C, 2-1.0hp A/C, 1-0.5hp water pump, 4-800W water heater, 2-6kW electric range and 2-1kW microwave oven, determine the total connected load in volt-ampere (VA). Write your answer in numerical format without decimal places.
(II) If 35 MW of power at 45 kV (rms) arrives at a town froma generator via 4.6Ω transmission lines, calculate (a) theemf at the generator end of the lines, and (b) the fractionof the power generated that is wasted in the lines.
The following data were obtained from a short-circuit test performed upon a 50 kVA, 2300/115 V, 60 Hz transformer: Esc = 87 V, Isc = 21.75 A, Psc = 590 W. Calculate (a) equivalent resistance, reactance and impedance referred to the primary, and (b) voltage regulation at a power factor of 0.866 lagging. Subject: Electrical Apparatus and Devices
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
A circuit feeding a single-phase load of 2.75 kW at 0.85 power factor and 240 V at an ambient temperature of 55°C by means of a 27 m single-core PVC insulated cable run in conduit along with another circuit. 1) Determine the installation method 2) Compute the circuit design current (/g) 3) Determine the nominal current (Za) of the circuit breaker 4) Find the temperature correction factor (C;) and adjust current for temperature 5) Find the grouping correction factor (Cy) and adjust current for grouping of cables 6) Select cable size and determine its current carrying capacity (/z) 7) Check voltage drop (V.D.) and correct cable size if V.D. > 6 V
For transferring electrical power at 220 kV, six conductors of ACSR Drake constitute a 60Hz double circuit three phase line arranged as shown below. The vertical spacing between consecutive conductors is 14ft; the longer horizontal distance is 32ft whereas the shorter horizontal distance is 25ft. a. Find the inductance per phase per mile and the inductive reactance per phase in ohms per mile. b. Find the capacitive reactance to neutral in ohm-miles. c. Find the resistance per phase per mile in ohms per miles. d. If the length of the line is 90 miles then draw an equivalent circuit of the line and analyse the open circuit and short circuit performance of the line. e. Find the maximum power we can transmit over the line. f. If the line is delivering power to a load of 20MW at 0.8 power factor lagging then find the voltage at the receiving end of the line. Also, Determine the voltage regulation, losses and efficiency of the line. g. If a fixed shunt compensation of 3 MVAr is attached at…
A three phase,Y connected, 215 V (line to line), 7.5 kW, 60 Hz, three pole IM has the following parameter values in Ohm/phase referred to the statorR₁ = 0.294 Ohm, R₂ = 0.144 Ohm, X₁ = 0.203 Ohm, X₂ = 0.409 Ohm, Xm = 10.25 Ohm.The total friction,windage and core losses may be assumed to be constant at 350 W independent of load. For a slip s = 0.02, compute the followingsa) Stator Currentb) Power Factor(pf)c) Rotor Speedd) Power Output(Shaft)e) Output(Shaft) Torquef) Efficiency(n)
The resistance and reactance of the single-phase 60Hz transmission line conductors are 8.8 ohm and 10.4 ohm respectively. The transmission line delivers 55MW at a power factor of 0.78 lagging to the load with 50kV receiving end voltage. Determine the following a) The inductance of the transmission line in mH Answer for part 1 b) Sending end power factor Answer for part 2 c) Percentage voltage regulation Answer for part 3 d) Percentage Efficiency Answer for part 4