Ethene is converted to ethane by the reaction CHalg) + H,(9) - C,Ho(g) CH, flows into a catalytic reactor at 25.0 atm and 300.°C with a flow rate of 872.8 L/min. Hydrogen at 25.0 atm and 300.°C flows into the reactor at a flow rate of 1500. L/min. If 11.0 kg of C,H, are collected per minute, what is the percent yield of the reaction? Submit Show Hints

Ethene is converted to ethane by the reaction CHalg) + H,(9) - C,Ho(g) CH, flows into a catalytic reactor at 25.0 atm and 300.°C with a flow rate of 872.8 L/min. Hydrogen at 25.0 atm and 300.°C flows into the reactor at a flow rate of 1500. L/min. If 11.0 kg of C,H, are collected per minute, what is the percent yield of the reaction? Submit Show Hints

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter5: Gases

Section: Chapter Questions

Problem 76E

See similar textbooks

Similar questions

5-118 Isooctane, which has a chemical formula C8H18 is the component of gasoline from which the term octane rating derives. (a) Write the balanced chemical equation for the combustion of isooctane. (b) The density of isooctane is 0.792 g/mL. How many kg of C02 are produced each year by the annual U.S. gasoline consumption of L? (c) What is the volume in liters of this CO2 at STP? (d) The chemical formula for isooctane can be represented by (CH3)3CCH2CH(CH3)2. Draw a Lewis structure of isooctane. (e) Another molecule with the same molecular formula is octane, which can be represented by: When comparing isooctane and octane, one structure is observed to have a boiling point of 99°C, while another is known to have a boiling point Of 125°C. Which substance, isooctane or octane, is expected to have the higher boiling point? (f) Determine whether isooctane or octane is expected to have the greater vapor pressure.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
61 As one step in its purification, nickel metal reacts with carbon monoxide to form a compound called nickel tetracarbonyl, Ni(CO)4, which is a gas at temperature above about 316 K. A 2.000-L flask is filled with CO gas to a pressure of 748 torr at 350.0 K, and then 5.00 g of Ni is added. If the reaction describe occurs and goes to completion at constant temperature, what will the final pressure in the falsk be?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
A mixture of chromium and zinc weighing 0.362 g was reacted with an excess of hydrochloric acid. After all the metals in the mixture reacted, 225 mL dry of hydrogen gas was collected at 27C and 750. torr. Determine the mass percent of Zn in the metal sample. [Zinc reacts with hydrochloric acid to produce zinc chloride and hydrogen gas; chromium reacts with hydrochloric acid to produce chromium(III) chloride and hydrogen gas.]
A chemist weighed out 5.14 g of a mixture containing unknown amounts of BaO(s) and CaO(s) and placed the sample in a 1.50-L flask containing CO2(g) at 30.0C and 750. torr. After the reaction to form BaCO3(s) and CaCO3(s) was completed, the pressure of CO2(g) remaining was 230. torr. Calculate the mass percentages of CaO(s) and BaO(s) in the mixture.
97 Homes in rural areas where natural gas service is not available often rely on propane to fuel kitchen ranges. The propane is stored as a liquid, and the gas to be burned is produced as the liquid evaporates. Suppose an architect has hired you to consult on the choice of a propane tank for such a new home. The propane gas consumed in 1.0 hour by a typical range burner at high power would occupy roughly 165 L at 25°C and 1.0 atm, and the range chosen by the client will have six burners. If the tank under consideration holds 500.0 gallons of liquid propane, what is the minimum number of hours it would take for the range to consume an entire tankful of propane? The density of liquid propane is 0.5077 kg/L.
Earths atmosphere is approximately 80 N2 and 20 O2. If the total atmospheric pressure at sea level is about 14.7 lb/in2. where lb/in2 is pounds per square inch, a common but non-SI unit of pressure, what are the partial pressures of N2 and O2 in units lbs/in2?
Butyl mercaptan, C4H9SH, has a very bad odor and is among the compounds added to natural gas to help detect a leak of otherwise odorless natural gas. In an experiment, you burn 95.0 mg of C4H9SH and collect the product gases (SO2, CO2, and H2O) in a 5.25-L flask at 25 C. What is the total gas pressure in the flask, and what is the partial pressure of each of the product gases?
Many nitrate salts can be decomposed by heating. For example, blue, anhydrous copper(II) nitrate produces the gases nitrogen dioxide and oxygen when heated. In the laboratory, you find that a sample of this salt produced a 0.195-g mixture of gaseous NO2 and O2 with a total pressure of 725 mm Hg at 35 C in a 125-mL flask (and black, solid CuO was left as a residue). What is the average molar mass of the gas mixture? What are the mole fractions of NO2 and O2 in the mixture? What amount of each gas b in the mixture? Do these amounts reflect the relative amounts of NO2 and O2 expected based on the balanced equation? Is it possible that the fact that some NO2 molecules combine to give N2O4 plays a role? Heating copper(II) nitrate produces nitrogen dioxide and oxygen gas and leaves a residue of copper(ll) oxide.