Example: A small rocket with an initial mass of 400 kg, is to be launched vertically. Upon ignition the rocket consumes fuel at a rate of 5 kg/s and ejects gas at atmospheric pressure with a speed of 3500 m/s relative to the rocket. Determine the initial acceleration of the CV rocket and the rocket speed after 10 seconds, if the air resistance is neglected.

Example: A small rocket with an initial mass of 400 kg, is to be launched vertically. Upon ignition the rocket consumes fuel at a rate of 5 kg/s and ejects gas at atmospheric pressure with a speed of 3500 m/s relative to the rocket. Determine the initial acceleration of the CV rocket and the rocket speed after 10 seconds, if the air resistance is neglected.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

What is momentum equation? Describe the properties of Newtonian fluid.
Derive an expression for the capillary- height change h, as shown, for a fluid of surface tension Y and contact angle 0 be- tween two parallel plates W apart. Evaluate for water at 20°C if W = 0.5 mm.
A 3-in diameter horizontal water jet having a velocity of 140 ft/s strikes a curved plate, which deflects the water 180 degrees at the same speed. Ignoring the frictional effects, determine the force required to hold the plate against the water stream. Please no conversion need it, only the 3in into .25feet, please. for me, I got 3.71KN on the x-axis.
04/13/2021 For this exercise Study and Derive the Bernoulli equation starting with the application of Newton’s second law to a fluid particle.
A 1-m-diameter sphere is being towed at speed V in freshwater at 20°C as shown in Fig. Assuming inviscidtheory with an undistorted free surface, estimate the speedV in m/s at which cavitation will first appear on the spheresurface. Where will cavitation appear? For this condition,what will be the pressure at point A on the sphere, which is45° up from the direction of travel?
Explain what the terms in the theorem mean by writing the Reynolds Transport Theorem (RTT) for Conservation of Mass, Conservation of Energy, Conservation of Linear Momentum and Conservation of Angular Momentum.
A cart with frictionless wheels and a large tank shoots water at a deflector plate, turning it by angle ? as sketched. The cart tries to move to the left, but a cable prevents it from doing so. At the exit of the deflector, the water jet area Ajet, its average velocity Vjet, and its momentum flux correction factor ?jet are known. Generate an expression for the tension T in the cable in terms of the given variables.
The entrance flow between two parallel plates (gap h) has a velocity that varies linearly at the entrance and develops into a fully parabolic profile at the exit. What is the relationship between the maximum velocity at the entrance and that at the exit? You can show by symmetry that the maximum velocity is attained at the mid-plane between the two plates.
An 8-cm-diameter horizontal water jet having a velocity of 35 m/s strikes a vertical stationary flat plate. The water splatters in all directions in the plane of the plate. How much force is required to hold the plate against the water stream?
A siphon is a convenient device for removingliquids from containers. To establish the flow, the tube must be initiallyfilled with fluid. Let the fluid have density r, and let the atmosphericpressure be patm. Assume that the cross-sectional area of the tube is thesame at all points along it. (a) If the lower end of the siphon is at adistance h below the surface of the liquid in the container, what is thespeed of the fluid as it flows out the lower end of the siphon? (Assumethat the container has a very large diameter, and ignore any effects ofviscosity.) (b) A curious feature of a siphon is that the fluid initiallyflows “uphill.” What is the greatest h
Consider a commercial airliner flying at a speed of 540 mph (relative to the air) at analtitude of 30,000 feet. (c) With a mean molar mass of M = 28.9 g/mol, determine the Reynolds number andMach number in flight. Justify your choice of characteristic length by referencinga commercial aircraft currently in service.(d) Is this flow inviscid or viscous? Is this flow subsonic or supersonic? Qualitativelydescribe the differences between these flight regimes.
5. Consider a Pitot probe in high-speed flow.(a) Give the value of the stagnation pressure to the freestream pressure p0/p∞ for airand M∞ = 1. Assume stagnation is reached isentropically.(b) How is the value found in part (a) important for Pitot problems? As part ofyour discussion, include what the flow field looks like for different cases and thedifferent assumptions that have to be made.