Answered: Explain (with the aid of one or more…

Explain (with the aid of one or more equations) why a LOWER selectivity coefficient for an interfering ion means an ISE is actually MORE selective for the target ion.

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter12: Atomic X-ray Spectrometry

Section: Chapter Questions

Problem 12.7QAP

See similar textbooks

Related questions

Q: Which of the following is NOT a detector used with HPLC?

A: Light Scattering Detector: Light scattering detection does not require analytes to have…

Q: Describe the principle and operation of anodic stripping voltammetry (ASV). How does it differ from…

A: Here we have to understand three points 1. Anodic Stripping Voltammetry (ASV) 2. adsorptive…

Q: Why is the absorbance spectrum of the iron (II) complex obtained first prior to measuring the…

A: Absorbance is measure of incident light absorbed by a compound. It is proportional to concentration…

Q: ) trans-[Co(en)2C12]Cl is a chiral compound ) The coordination number for the anionic complex in…

A: Few question based on general chemistry that is to be accomplished.

Q: Identify the maximum intrabeam permissible exposure (MPE) for the eye: a. CO2 laser for 10 seconds…

A: MPE (Maximum Permissible exposure ) is the maximum level of laser radiation to which a person may be…

Q: explain why concerted 1,3 sigmotropic shift of hydrogen is thermally forbidden

Q: A student collects the following data for the absorbance of a complex measured in 1.00 cm…

A: Absorbance ( A ) = molar absorptivity ( ε) x concentration(c) x path length (l) or, A = εcl…

Q: UV-visible spectroscopy provides information about cobalt(III) complexes. A blue cobalt complex has…

A: d-d transitions are forbidden by Laporte Selection rule. Due to this, in octahedral complexes, the…

Q: Which of the following describes molar extinction coefficient (ɛ)? I. ɛ is an intrinsic property II.…

A: Ans. Molar extinction coeffient(ε): The molar attenuation coefficient(ε ) is a measurement of how…

Q: The UV-vis. absorption spectrum of an aqueous solution of [Mn(OH2)6]²* displays a large number of…

A: Given: We have to tell ground state term for Mn(II) free ion and we have to discuss the selection…

Q: Operating Wavelength : 462.8 nm Preparation of Standard Calibration Curve of [FeSCN]2+ Sample…

A: We are given with the following data:Sample NumberAbsorbanceFinal Concentration of…

Q: Fluorescence from the energy donor pyrene isquenched by the acceptor dye coumarin. In an…

A: Introduction: The Forster energy transfer is the process in which an excited donor transfer energy…

Q: Sodium has a distinct pair of emission bands which are observed at 589.1583 nm and 589.7758 nm.…

A: The wavelength of the two sodium doublets are given. To calculate the energy difference in…

Q: important is it to embed the 'emitter recoilness emission of a Y-ray. How The Mossbauer effect…

A: Emitter nucleus is embedded in a bulky, rigid crystal lattice to ensure that energy don't get lost…

Q: 6. Titanium reacts with hydrogen peroxide in 1.00 M sulfuric acid to form a colored complex. If a…

Q: (c) The Mössbauer effect depends upon the recoilness of a y-ray. How important is it to embed the…

A: In Mossbauer Spectroscopy the isolated atom in an excited energy state Eγ decays to give away γ…

Q: n analysis of Zn2+ in food sample by atomic absorption spectroscopy gave a calibration curve of A =…

A: Limit of detection LOD =3.3×Standard deviationSlope of Caliberation curve

Q: The disadvantages of graphite furnace atomic absorption spectroscopy over flame atomic absorption…

A: Two important techniques for sample atomization are flame atomization and graphite furnace…

Q: A solution of a certain dye has a concentration of 0.000100 mol L-1 and gives an absorbance of 1.234…

A: Answer:- This question is answered by using the simple concept of Beer's law which involves the…

Q: (b). Atomic abs orption spectroscopy (AAS) is used for the quantitative determination of chemical…

A: A question based on AAS, which is to be accomplished.

Q: You are working with metal thiocyanate complex, M(SCN)+, with a molar absorptivity constant, ε, of…

A: Beer–Lambert’s law equation:

Q: The molar absorptivity for the complex formed between bismuth(III) and thiourea is 9.32 × 103 L…

A: Since you have posted multiple questions, we'll answer the first one. If you want any other…

Q: Exactly 5.00 mL aliquots of a solution containing analyte X were transferred into 50.00-mL…

Q: A solution in part C initially contains (4.1000x10^-4) molar SCN¯ and (1.180x10^-1) molar Fe3+. This…

A: Given that: absorbance = 5.150×10-1 initial concentration of Fe3+ = 1.180×10-1 M initial…

Q: Which of the following statement is incorrect? The quality of grating of the monochromator affects…

A: In the Atomic Absorption Spectroscometer, the following instrumentation is used and their uses are…

Q: Calculate the number of Schottky defects per m3 in KCl at 500oC. Energy required for the formation…

A: Given: The energy required for the formation of each Schottky defect = 2.6 eV/atom The density of…

Q: spectra for EI, field ionization, and CI sources differ from one another?

Q: As pH changes, ho will absorbance change t the wavelength of the isosbestic point?

A: An isosbestic point is a specific wavelength, wavenumber or frequency at which the total absorbance…

Q: 1. Using the graphs of the food dyes created from your data, use the Imax to determine the amount of…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Explain why the zinc ion should not interfere with absorbance measurements of the copper ion.

A: Interference of Zinc ion in the absorbance measurements of Copper ion.

Q: o measure the absorbance of Fe(SCN)2+, write a procedure (detailed in steps) to accurately determine…

A: The wavelength and intensity of electromagnetic radiation is determine by the colorimetry.

Q: When pyridine is added to a solution of iodine in carbon tetrachloride the 520 nm band of absorption…

A: The invariant point at which the absorbance will be constant even if the reactant concentration is…

Q: In a photochemical experiment it is observed that 5.78×10-5 mol of uranyl oxalate is decomposed at a…

A: Quantum yield of a reaction is defined as: Quantum yield=ϕ=number of moles of reactant reactednumber…

Q: (iii) Write out the expression for the approximate form of the Marcus-Hush equation for a…

Q: Palladium (II) and gold (III) can be analyzed simultaneously through reaction with methiomeprazine…

A: Beer Lambert's Law help us to find the molar concentrations of Pd(II), CPd and Au(III), CAu in the…

Q: e) Rationalize the trends in CO stretching frequencies of the: following sets of IR-active compounds…

A: Soln

Q: Wavelength selector in atomic absorption spectrometer will limit the radiation absorbed by a sample…

A: 2 a) A common wavelength selector used in an atomic absorption spectroscopy (AAS) is filters,…

Q: If you conducted a cyclic voltammetry experiment of a species in vivo (in the body) at 37°C, what…

A: For the given problem we can use the formula as: delta Ep = 0.0565/n where n is the number of…

Q: 5. Describe the principle on which each of the following GC detectors are based: (a) flame…

A: A chromatography detector is a tool used in liquid or gas chromatography (GC/LC) to identify mixture…

Q: A solution containing 1.00mg iron (as the thiocyanate complex) in 100mL was observed to transmit…

A: Given transmittance of the solution is 70.0%. The solution contains 1.00 mg of iron as thiocyanate…

Q: An aqueous solution of a triphosphate derivative of molar mass 502 g mol-1, was prepared by…

A: Beer Lambert's Law: This law states that there is a linear relationship between the concentration…

Q: 5 2. RED ORANDE YELLOW OREEN BLUE BROWN IL 6 9 4

A: The Retention factor of brilliant blue can be calculated as follows

Q: In Monochromators the entrance slit transmits a single A the exit slit transmits a single A the…

A: A monochromator is an optical device used in the spectrometer.

Q: You wish to determine the fluorescence lifetime of your sample using Time Correlated Single Photon…

A: Time-correlated single photon counting (TCSPC) is a common technique to measure fluorescence decays…

Q: When is the procedure of the transfer of the electron used? How is it useful?

A: When is the procedure of the transfer of the electron used? How is it useful?

Q: The following is true with regard to phosphorescence. It is slow due to a change in multiplicity. It…

A: The phosphorescence is slow as the transition is spin forbidden. The correct option is option a.

Q: Describe a practical that shows black surfaces are better emitters than white ones.

A: The black material performs as a perfect absorber of electromagnetic radiation on exposure to it.…

Q: Operating Wavelength : 462.8 nm Preparation of Standard Calibration Curve of [FeSCN]2+ Sample…

A: According to Beer-Lambert's law, the absorbance of a solution is related to its concentration as:

Q: A student is working with a metal thiocyanate complex, M(SCN)+, with a molar absorptivity constant,…

A: Beer-Lambert law states that, the absorbance of a monochromatic radiation by a solution is directly…

Question

Explain (with the aid of one or more equations) why a LOWER selectivity coefficient for an interfering ion means an ISE is actually MORE selective for the target ion.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

You are working with metal thiocyanate complex, M(SCN)+, with a molar absorptivity constant, ε, of 2700 cm−1M−1 at 500 nm. If you are is using a 1.00 cm cuvette for absorbance measurements at 500 nm, what concentration of M(SCN)+ will give an absorbance value of 0.280?
Calculate the number of Schottky defects per m3 in KCl at 500oC. Energy required for the formation of each Schottky defect is 2.6 eV / atom, the density of KCl at 500oC is 1.995 g / cm3, k = 8.62x10-5eV / K.
The measurement of Li in brine (salt water) is used by geochemists to help determine the origin of this fluid in oil fields. Flame atomic absorption of Li is subject to interference by other elements. Atomic absorption of analysis of replicate sample of Li in a brine sample gave results in the table. d. Suggest another method for removing interferences in this analysis. e. What value do you recommend for reporting the real concentration of Li in the sample?
List the 3 types of EMR scattering and give the relationship between the particle size and wavelength for each.
You have been asked to determine which heavy metals, if any are in a sample of sewage sludge. Why is atomic absorption spectroscopy not a good technique for the job and why is ICP- atomic emission spectroscopy a better choice?
The term masking generally refers to: A) Masking generally refers to the transformation of an interfering species into a form that is not detected. B) Selecting samples from which the identity has been masked. This procedure prevents the analyst from prejudging the outcome of the analysis. C) Removing any material that may interfere with an analysis.
Atomic absorption spectroscopy with graphite furnace atomization is an extremely sensitive technique. The standard addition method is used with this technique to determine the concentration of copper in urine. A 20.00 mL sample of urine is spiked with 1.00 mL of 300. ppb Cu²+ and this mixture gives a response of 0.168. Another 1.00 mL aliquot of 300. ppb Cu²+ is added to this mixture and gives a reading of 0.235Determine the concentration of copper in the urine sample
When pyridine is added to a solution of iodine in carbon tetrachloride the 520 nm band of absorption shifts toward 450 nm. However, the absorbance of the solution at 490 nm remains constant: this feature is called an isosbestic point. Show that an isosbestic point should occur when two absorbing species are in equilibrium.
A 2.845 g sample of an unknown compound containing cobalt(II) ion was dissolved in water in a 250 mLvolumetric flask. The absorbance of this solution was found to be 0.2195 at 515 nm in a 1 cm cell.Using the values of absorbance obtained, calculate the percentage of cobalt in the unknown compound.
Radiation of wavelength 300 nm was passed through a chemical actinometer containing 10 ml of a 0.05M oxalic acid solution and 0.01M uranyl sulphate. The concentration of oxalic acid solution became 0.03M after absorption of 80J radiation energy. Calculate the quantum yield of the photodecomposition of the oxalic acid?
the absorbance of an equilibrium mixture of Fescn2+ was measured at 447nm and found to be 0.319. What is the equilibrium concentration of FeSCN2+?
What is the purpose of cobalt blue glass in spectroscopy?