Given the following data for the titration ofchromate ion with silver ion, write the titrationreaction, and calculate the following:VCrO42-= 20.20 mL [CrO42-] = 0.1530 M[Ag+] = 0.220 M Ksp= 1.17x 10-11a) Balanced Reactionb) Equivalence point volume (VEP)c)pAg @ 18.00 mLd)pAg @ VEPe)pAg @ 31.0 mL

Since we only answer up to 3 subparts, we'll answer the first 3. Please resubmit the question and…

Given the following data for the titration of chromate ion with silver ion, write the titration reaction, and calculate the following: VCr042-= 20.20 mL [CrO42-] = 0.1530 M [Ag+] = 0.220M Ksp= 1.17x 10-11 a) Balanced Reaction b) Equivalence point volume (VEP) c)pAg @ 18.00 mL d)pAg @ VEP e)pAg @ 31.0 mL

Given the following data for the titration of chromate ion with silver ion, write the titration reaction, and calculate the following: VCr042-= 20.20 mL [CrO42-] = 0.1530 M [Ag+] = 0.220M Ksp= 1.17x 10-11 a) Balanced Reaction b) Equivalence point volume (VEP) c)pAg @ 18.00 mL d)pAg @ VEP e)pAg @ 31.0 mL

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter10: Potentiometry And Redox Titrations

Section: Chapter Questions

Problem 8P

See similar textbooks

Similar questions

pls complete the table using given dataEffect of Common Ions on the Solubility of Ca(OH)21. Add Ca(OH)2 to 250.0 mL of 0.010 M CaCl2 with stirring until equilibrium is achieved.2. Filter the undissolved precipitate. Measure out 50.0 mL of the filtrate in a 250-mL Erlenmeyer flask. 3. Add a few drops of phenolphthalein indicator and titrate with standardized HCl solution until endpoint is achieved. 4. Record the volume of HCl solution used. Perform two more trials.
Calculate the silver ion concentration in terms of pAg during the titration of 70.00 mL of 0.07000 M NaCl with 0.1000 M AgNO3 after the addition of the following volumes of reagent: (a) in the preequivalence point region at 20.00 mL, (b) at the equivalence point (25.00 mL), (c) after the equivalence point at 50.00 mL. For AgCl, Ksp = 1.82E10-10. Show your answer with three significant figures.
Calculate the silver ion concentration after the addition of 5.00, 30.00, 40.00, 45.00 and 50.00 ml of 0.05000 M AgNO3 to 50.0 mL of 0.0400 M KBr. Construct a titration curve from these data plotting pAg as a function of titrant volume (Ksp (AgBr)=5.0 x 10-13 )
1.Given that the solubility products (Ksp) of silver chloride(AgCl),silver iodide(AgI) and silver bromide (AgBr) are 1.82×10^-10,1×10-16,5.2×10^-13 and 1.82×10^-10 respectively.Plot an arbitrary titration curve of pAg versus volume of AgNO3 for each of the above on the same set of axis.You may assume that the concentration and volume of starting materials the same. 2.Using the information above,predict the order in which each species would precipitate from first to last
Consider only the first dissociation constant of a 10-4 M solution of boric acid(H3BO3):a) develop the appropriate ionization fraction equations,b) draw a species distribution plot for H3BO3,c) develop the appropriate equations for the buffer capacity of H3BO3,d) plot the buffer capacity versus pH,e) develop the appropriate equations for the titration of H3BO3 with NaOH,f) plot pH versus equivalent fraction,g) at which pH is β a maximum? and,h) at which value of α0 and α1 is β a maximum?
Calculate the molar solubility of calcium oxalate in a solution that has been buffered so that its pH is constant and equal to 4.00. Data: Kps of CaC2O4 = 1.7x10 -9 ; Ka1 of H2C2O4 = 5.60x10-2 and Ka2 = 5.42x10-5 . Use systematic treatment.
1) Calculate the total hardness for the first sample (Sample Volume,V : 50 mL,Volume of EDTA titrant used for the sample, A:9.6 mL) 2)Calculate the calcium and magnesium concentrations for the first sample in the video in meq/L and mg CaCO3/L.(Sample Volume= 50 mL, Magnesium hardness titrant volume = 0 mL, Calcium hardness titrant volume:2,6 mL) 3)Assuming the pH and alkalinity of the first sample in the video are 7.5 and 100 mg CaCO3/L, respectively, calculate the temporary and permanent hardness values for this sample 4How much CaCL2 in meq/L should be added to the sample to equalize calcium and magnesium hardness? Which hardness level (soft, medium, hard, very hard) does the sample belong to after this addition?
Use the data below to determine the % by mass of Fe to TWO decimal places, if a 0.02 M KMnO4 solution was used for the titration. gH * + MnO 4 + 5Fe 2+ -> SFe 3+ + Mn 2+ + 4H 20 (MM Fe = 56 a/moll mass of iron compound (g) 0.604 initial buret reading (mL) 0.94 Tinal buret reading (mL 16.21
A sample is analyzed for chloride by the Volhard method. From the following data, calculate the percentage of chloride present:Weight of sample = 6.0000 g dissolved and diluted to 200 mLAliquot used = 25.00 mL AgNO3 added = 40.00ml of 0.1234MKSCN for back titration = 13.20ml of 0.0930M
A solution containing Mg2+ was buffered to pH 9.81 and titrated with EDTA. Eriochrome black T, with p?a1 = 6.3 and p?a2 = 11.6 was used as the indicator. It is a diprotic acid, H2E What is the fraction of the predominant form of eriochrome black T in solution at this pH? (To answer this, report the alpha fraction of the indicator’s most prevalent species at this pH)
Following the monograph procedure, determine the weight in grams of sodium carbonate (MW-106 g/mol) used to standardize a 0.987 N sulfuric acid solution. 1. What specific type of titration is involved? A. Direct Acidemetry B. Direct Alkalimetry C. Residual Acidemetry D. Residual Alkalimetry 2. What is the analyte- titrant chemical reaction involved? A. Strong Base+Weak Acid B. Weak Acid+Strong Base C. Strong Acid+Weak Base D. Weak Base+Strong Acid 3. What is the preferred indicator for the chosen type of reaction above? A. Methyl Orange B. Penolphtalein C. Methyl Red 4. Consider that the burette was completely filled to the 0mp mark before titrating. What is the volume of titrant consumed based from the image below? A. 22.9 mL B. 22.2 mL C. 21.3 mL D. 22.7 mL 5. What is the unknown weight (grams) the problem? Your Answer:
For the titration of 50.00 mL of 0.300 M RbC7H5O2 (WB) with 0.200 M HNO3 (SA).Ka (HC7H5O2) = 6.3 x 10-5Express pH value to two decimal places.Determine the pH after the addition 25.00 mL of HNO3.