Here is a graph of the molarity of ethanol (C,H¸OH) in a reaction vessel during a certain chemical reaction. Use this graph to answer the questions in the table below. 0.030- 0.0254 0.020 M 0.015 0.010 0.005 500 1000 1500 2000 2500 3000 seconds O created Is C,H,OH being created or destroyed by the chemical O destroyed reaction? O neither created nor destroyed If C,H,OH is being created or destroyed, what is the rate at which it is being created or destroyed 1300 seconds after the reaction starts? Round your answer to 2 significant digits. Also be sure your answer has the correct unit symbol. If C,H,OH is being created or destroyed, what is the average rate at which it is being created or destroyed during the first 1300 seconds of the reaction? Round your answer to 2 significant digits. Also be sure your answer has the correct unit symbol.

Here is a graph of the molarity of ethanol (C,H¸OH) in a reaction vessel during a certain chemical reaction. Use this graph to answer the questions in the table below. 0.030- 0.0254 0.020 M 0.015 0.010 0.005 500 1000 1500 2000 2500 3000 seconds O created Is C,H,OH being created or destroyed by the chemical O destroyed reaction? O neither created nor destroyed If C,H,OH is being created or destroyed, what is the rate at which it is being created or destroyed 1300 seconds after the reaction starts? Round your answer to 2 significant digits. Also be sure your answer has the correct unit symbol. If C,H,OH is being created or destroyed, what is the average rate at which it is being created or destroyed during the first 1300 seconds of the reaction? Round your answer to 2 significant digits. Also be sure your answer has the correct unit symbol.

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter9: Chemical Reactions

Section: Chapter Questions

Problem 139A

See similar textbooks

Similar questions

list at least three quantities that must be conserved in chemical reactions.
What is the difference between a solute and a solvent?
The flasks below illustrated three trials of a reaction between varying amounts of zinc and a constant volume of hydrochloric acid solution of constant concentration. The table gives the initial amount of zinc added and the observation at the conclusion of each reaction. Mass of Zinc Added g Observation at Conclusion of Reaction 6.10 Balloon inflated completely Some unreacted zinc remains 2.37 Balloon inflated completely No zinc remains 0.41 Balloon not inflated completely No zinc remains The reaction produces an aqueous solution of zinc chloride and hydrogen gas. Explain the observed results.
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
You want to prepare a 1.0 mol/kg solution of ethyleneglycol, C2H4(OH)2, in water. Calculate the mass of ethylene glycol you would need to mix with 950. g water.
The traditional method of analysis for the amount of chloride ion present in a sample is to dissolve the sample in water and then slowly to add a solution of silver nitrate. Silver chloride ¡s very insoluble in water, and by adding a slight excess of silver nitrate, it is possible to effectively remove all chloride ion from the sample. :math>Ag+(aq)+Cl+(aq)AgCl(s) ppose a 1.054-g sample is known to contain 10.3% chloride ion by mass. What mass of silver nitrate must be used to completely precipitate the chloride ion from the sample? What mass of silver chloride will be obtained?
33. For each of the following solutions, the number of moles of solute is given, followed by the total volume of the solution prepared. Calculate the molarity of each solution. a. 0.521 mol NaCl; 125 mL b. 0.521 mol NaCl; 250. mL c. 0.521 mol NaCl; 500. mL d. 0.521 molNaCl; 1.00 L
Molarity is a conversion factor relating moles of solute in solution to the volume of the solution. How does one use molarity as a conversion factor to convert from moles of solute to volume of solution, and from volume of solution to moles of solute present?