Answered: Imagine that the blue component of a…

Imagine that the blue component of a given mixture moved 2.5 cm from the oigin or starting line, and the solvent had traveled 10.0cm, What is the Rf for the blue dye A .4.4 B 0.25 C. 7.5 D. 25

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter9: Complexometric And Precipitation Titrations

Section: Chapter Questions

Problem 9P

See similar textbooks

Related questions

Q: D- How many extractions of 20 ml portions of DCM are needed to extract 96% of caffeine from 200 ml…

A: The relation between the partition ratio and amount left after n-number of extractions is shown…

Q: 1] What type of precipitate is BaSO4? [2] Why is filter paper preferred over a sintered glass…

A: Given: [1] What type of precipitate is BaSO4?[2] Why is filter paper preferred over a sintered glass…

Q: 1. Which of the following can most likely increase the yield of recrystallized benzoic acid? a. A…

A: Recrystallization is the process of purification of a compound in its purest form by separating the…

Q: 8. Which solution is of known concentration that is used to react completely with an analyte? D.…

A: Standard solution is used to react completely with an analyte.

Q: For standard turbidity measurements, the increase in signal is due to a.) higher amounts of analytes…

A: Its intensity ( scattered light ) can also be measured by this, Precipitate size and shape are…

Q: In glucose estimation using Benedict's Reagent, briefly explain what would happen if the water…

A: In the quantitative estimation of glucose using the quantitative Benedict's reagent, the solution is…

Q: What is the purpose of adding HCI to the aqueous layer in this experiment? To remove the impurity To…

Q: The purity of triphenylmethanol is checked by TLC using 5% ethyl acetate/95% ligroin as the solvent.…

A: Given that, the polarity of the triphenylmethanol is chacked by TLC using 5% ethyl acetate/95%…

Q: Why is there a need to correct conductivity of the sample solution

Q: In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction…

A: Percentage of acetone in the fraction depends on distance of average temperature from the boiling…

Q: what is the difference between liquid phase extraction and solid phase extraction

A: A question based on analytical process that is to be accomplished.

Q: Why line extraction from a point cloud is needed ?

A: Planar structure extraction from point clouds is an important process in many applications.

Q: 10. Consider the following compounds when answering the questions below. Assume these compounds can…

Q: a) Discuss the effect of solvent polarity on Rf-values. b)Explain how the Rf (Retention…

A: Since you have posted two questions, we will solve first question for you. Please repost other…

Q: Find the Rf value from given data. Thank you

A: In Thin Layer Chromatography, the compounds can be separated by the solvents in the TLC plate. The…

Q: An analytical separation technique based on the large differences in solubilities between…

A: Analytical chemistry is used for the detection, identification, characterization of chemical…

Q: Describe briefly on each of the following sample preparation protocols: 1. Dissolve/filtration 2.…

A: Hi, as you have posted multiple subparts in a single question and have not mentioned which subparts…

Q: 2. Please explain what is A and B in the separating funnel when using NaOH to extract…

A: Extraction is a separation technique use to separate any compound from mixture. Common extraction…

Q: 2. The following sketch shows the results of a paper chromatography experiment. At the beginning,…

A: Rf values is more then the compounds are stay in the higher region of the column in paper…

Q: A sterile ophthalmic suspension contains 0.5% timolol maleate (m.w. 433). How many milligrams of the…

A: We have 0.5% w/v opthalmic solution. Solute here is timolol maleate. Mol mass of timolol maleate =…

Q: do you think that a dye with a high retention factor is more soluble or less souluble in the solvent…

A: Retention factor is defined as the ratio of the distance travelled by the solute solution to the…

Q: Assuming 2-naphtholc acid (from Question # 12) is a solid, how can you check that it is pure after…

A: The impure substance is a mixture. To check the purity of the whether after being separated is done…

Q: Order the compound A, B and C from lowest to highest Rr. The sample is spotted on a silica te and…

A: Retardation factor (Rf) is calculated by the distance travelled by solute divided by distance…

Q: Eren, Rochelle, and Sarah were assigned to do a recrystallization experiment using three different…

Q: Write a flow diagram Prepare a written copy of the complete separation scheme for a solution that…

A: The complete separation scheme for a solution that contains Ag+, Fe3+, Cr3+, Ni2+, Zn2+and Ba2+ is…

Q: Given 60.00 g of the compound in 60.00 mL water. Calculate amount extracted using multiple (2 x…

A: Concept- In a multiple extraction procedure, a quantity of solvent is used to extract one layer…

Q: 4. What is the purpose of changing the eluting solvent from pentane to ether between the two…

A: "Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: In a few sentences summarize your results for odor, solubility, acidity and the FeCl3 test for the…

A: Odor= a) rotting garbage smell B) pungent alcoholic C)camphor like D)camphor like

Q: (d) For the analyte shown, list the following stationary phases in order of increasing retention…

A: Reverse phase HPLC is reverse of normal HPLC. Here, Stationary phase is taken as non-polar group and…

Q: Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected…

A: Melting point of crystal depends on arrangement of lattice

Q: Question a) Discuss the effect of solvent polarity on Rf-values.

A: Since you have posted two questions, we will solve first question for you. Please repost other…

Q: The procedure requires the use of a 1.1 molar equivalent of benzyltriphenylphosphonium chloride…

A: Given data, Molar mass of BTPC = 388.90 g/mol Volume of benzaldehyde = 1.86 mL = 1.86cm3 Molar mass…

Q: is mobile phase the eluting solvent?

Q: What is a spectrophotometer used for in a cobalt chloride solution analysis

Q: Using aqueous hydrochloric acid, sodium bicarbonate, or sodium hydroxide solutions, devise a…

Q: |CH,CH,l,Cu-Li THF solvent [+] DIBAL-H, cold THF solvent

A: These two reactions are quite efficient to provide ketone and aldehyde from their corresponding acid…

Q: How is "Characterization and spectroscopic techniques for analyzing" used in a melting point…

A: Melting point is the temperature when a substance starts melting. The melting point of a compound is…

Q: When a pure sample of tert-butyl bromide is analyzed by gas chromatography, two components are…

A: (a) The gas chromatography conditions do not have any reactive molecules that can react with the…

Q: Why must the spots be above the level of the development solvent in the developing chamber?

A: Given statement, The spots be above the level of the development solvent in the developing…

Q: Suppose a particular extraction proceeds with a distribution coefficient of 7.5 The mature consists…

A: volume of water = 100 ml volume of ether = 150 ml amount of caffeine dissolved in water = 0.31 g…

Q: Prelab question

A: The solubility of sulfanilamide in 95% ethyl alcohol at 780C can be known from the figure 11.2 as…

Q: Using the table on slide 7, what ORGANIC solvent could you use to do an extraction of something from…

A: Since you have posted multiple questions, we will answer the first one for you. To get the remaining…

Q: LAL test results could be determined based on ________? I. Color development II. Cloudiness III. Gel…

A: LAL test is used to detect the presence of endotoxins.

Q: Explain your reasons for choosing which solvent would be most effective in separating the green from…

A: From the retention value, it is clear that in mobile phase I the Rf values for both green and blue…

Q: Why is 95% alcohol a good solvent for extraction?

A: The substance which is present in lesser amount is termed as solute. The substance which is present…

Q: Consider the mordant dyes and alizarin red S results, specifically focusing on the use of copper…

A: The substance mordant dye can be described as the dyes that will be utilized for the dyeing of the…

Q: a) What is capillary electrophoresis used for? b) Describe electrophoresis. c) Describe…

A: Since you have posted multipart of question as per the guidelines i have solved first three subparts…

Question

Imagine that the blue component of a given mixture moved 2.5 cm from the oigin or starting line, and the solvent had traveled 10.0cm, What is the Rf for the blue dye

A .4.4

B 0.25

C. 7.5

D. 25

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

1) Please define the term distribution coefficient, Kd? 2) How the value of Kd indicates the potential separation of an organic compound, via extraction
A 25.0 cm portion of 0.200, mol dm^-3 sodium ethanedioate solution was warmed and titrated against a solution of potassium manganate(VII). If 17.2 cm^3 of potassium manganate(VII) are required, what is its concentration?
Explain the function of the different steps in solid-phase extraction method.
Is a Kd value of 10.16 reasonable for the extraction of benzoic Acid between methylene chloride and water? Please explain.
The retention of a carboxylic acid analyte in HILIC will decrease as the pH of the buffer component of the mobile phase is increased, true or false?
What are the conditions for a successful gravimetric analysis. Define nucleation. What conditions are important for this stage.
An analyte has a Rf value of 0.5. What does that say about the solubility of the analyte in the mobile phase as compared to the stationary phase? (please show me all steps)
In order to analyse mercury with AAS, which method will you prefer?
an analytical separation technique based in the large differences in solubility between interference and analyte 1. Separation by extraction 2. Chromatographic separation 3. Separation of species by distillation 4. Separation by precipitation
Q: Write three substances or species that can be determined using each of the following instrumental analysis techniques: 1- pH-measurement 2- Visible spectrophotmetry 3- Turbidity measurement Question: The mention includes three materials or factions that can be estimated for each of these mechanical analysis techniques.
The calibration curve y=0.0218x - 0.0001 for Fe2+ in buffer at 450 nm in a 0.5 cm cuvette. Is Beer's Law obeyed? Explain. and What is the molar extinction coefficient for the Fe2+ complex at 450 nm?
Find how many % of I2 in 1000 mL H2O will still be in its aqueous phase if it was extracted with CHCl3 for a single time. Note: Suppose that KD is 160.