In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction averaging 48°C was collected that never exhibited a plateau temperature.Show using temperature as an indicator of purity what the % of acetone is in this fraction.(Hint: this is similar to the question of refractive index in the last assignment)

In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction averaging 48°C was collected that never exhibited a plateau temperature.Show using temperature as an indicator of purity what the % of acetone is in this fraction.(Hint: this is similar to the question of refractive index in the last assignment)

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter87: Steam Distillation

Section: Chapter Questions

Problem 3P

See similar textbooks

Similar questions

4. In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction averaging 48°C was collected that never exhibited a plateau temperature. Show using temperature as an indicator of purity what the % of acetone is in this fraction. (Hint: this is similar to the question of refractive index in the last assignment) Please answer very soon will give rating surely
Why is the Refractive Index of hexane closer to the refractive index of heptane in both simple and fractional distillation?
Why the Refractive Index of hexane and heptane from simple distillation closer to the refractive index of hexane and heptane from fractional distillation?
Please answer all 5 questions (it could be short answers). 5-1. What is the main barrier to separating liquid mixtures of less than 500 mL by distillation? 5-2. A sample mixture of ethyl benzoate (bp 212 Celsius) and dodecane (bp 216.2 Celsius) is injected on two GC columns. Column A has DC710 silicone oil as the stationary phase, and column B uses polyethylene glycol as the stationary phase. Which substance would be certain to elute first from column A and would the same material be expected to elute first from column B? Which column, A or B, would be expected to give the better separation of these two substances? 5-3. Question 5-2 refers to separating a mixture of two high boiling liquids by gas chromatography. These materials have similar boiling points. List several GC variables and conditions that would make it easier to separate thesesubstances by gas chromatography 5-4. Capillary GC columns have better resolution than packed columns even though the enormous surface area…
6.0 mL of cyclohexanol, 8 mL of 85% phosphoric acid, and 10 drops of sulfuric acid are added to a 50-mL round-bottom flask with boiling chips, and the mixture is distilled into an ice-cooled receiver. The distillate is in the form of a colorless bi-phasic mixture. The cyclohexene upper layer is removed from the water layer, and dried over anhydrous calcium chloride. Isolated is cyclohexene as a clear and colorless foul-smelling liquid. Weighing data is given below. Gross mass: 51.24 g Tare mass: 48.04 g Product mass: 3.2g Question: Calculate the theoretical mass of the cyclohexene product, bearing in mind that the cyclohexanol starting material was measured by volume, not by mass (so you must use the density of cyclohexanol to convert milliliters to grams, before calculating the number of moles). Calculate the percent yield of cyclohexene obtained.
Make a results and discussion in Laboratory Report Format of the following: 1. Separation of mixture using different techniques 1.1 Simple distillation: Water + acetone 1.2 Fractional Distillation: Methanol + ethanol 1.3 Chromatography: Separation of mixture of Red ink and blue ink 2. purification of impure samples by crystallization 2.1 Copper sulfate 2.2 Potash alum 2.3 Benzoic acid
Of Aspirin, ethanol, acetaminophen, ethyl acetate, hexane, and water which could go undetected during HPLC analysis, but could result in a lower than expected melting point, why are they not detected by HPLC analysis?
What will be the composition of the vapor when a mixture containing 0.30 of A was subjected to fractional distillation with two theoretical plates? a 0.72 A; 0.28 B b 0.87 A; 0.13 B c 0.50 A; 0.50 B d 0.30 A; 0.70 B
Acetophenone is soluble in diethyl ether, isopropanol, and nhexane. Identify and justify the most suitable solvent for UV- Vis characterization?
Remember how you learned that a pure liquid distills within a narrow boiling point range, but that a narrow boiling point range doesn’t necessarily imply a pure liquid? Keeping that lesson in mind, explain this: you know without a doubt from a spectroscopic technique that your product mixture contains 2 distinct products. .. yet your tlc plate shows only one spot. How can this be possible?
Compare simple and fractional distillation for the separation of HEXANE and TOLUENE
You were analyzing a mixture of volatile solvents using Gas Chromatography and found out that two peaks are unresolved (not well-separated) using your initial program. Which method can you use to obtain a chromatogram with well separated peaks?