In a four linkages slider mechanism shown in Figure 2, when the crank turn the connecting rod responsible to rising and lowering a weight that riding against incline plane. When the connecting rod lifting the weight, it has to overcome the gravity and the friction force between the weight and the incline plane. On other hand when the connecting rod lowering the weight the friction force will reduces the force on the connecting rod. Therefore the loading on the connecting rod is fluctuating from 9kN to 2 kN. Find a factor of safety of connecting rod against fatigue for infinite life using Goodman theory. Check the first cycle yield factor of safety. The connecting rod is made of AISI1018 CD? A reliability of 90% is desired.

In a four linkages slider mechanism shown in Figure 2, when the crank turn the connecting rod responsible to rising and lowering a weight that riding against incline plane. When the connecting rod lifting the weight, it has to overcome the gravity and the friction force between the weight and the incline plane. On other hand when the connecting rod lowering the weight the friction force will reduces the force on the connecting rod. Therefore the loading on the connecting rod is fluctuating from 9kN to 2 kN. Find a factor of safety of connecting rod against fatigue for infinite life using Goodman theory. Check the first cycle yield factor of safety. The connecting rod is made of AISI1018 CD? A reliability of 90% is desired.

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter40: Drive Axles And Differentials

Section: Chapter Questions

Problem 12RQ: The drive shaft component that provides a means of connecting two or more shafts together is...

See similar textbooks

Similar questions

The drive shaft component that provides a means of connecting two or more shafts together is the____. a. pinion flange b. U-joint c. yoke d. biscuit
Design of the Screw Jack. Lifting load – W, kN is 45. Hight of lifting– H, mm is 450 Types of threads is Square Material of nut is Bronze
Identify atleast 10 work holding or clamping devices and their use.
Words: Cage, Centre, Changes, Drive, Flange, Inner, Joint, Race, PropellerA Löbro constant-velocity __________________, has an outer race, an inner race and a __________________ with steel balls.The outer race is bolted to the __________________ of the front propeller shaft, and the inner race is splined to the front endof the rear __________________ shaft. The joint is enclosed by a dust shield and boot. The front shaft is supported by a__________________ bearing.This type of joint is designed to allow __________________ in propeller shaft angle and also changes in propeller shaft length.Both the __________________ race and the outer race have angular grooves for the balls. The balls transfer__________________ from one race to the other but, at the same time, the inner __________________ is able to move in orout in the grooves or change its angle.
With FBD per joints
Which of the following describes the double-Cardan universal joint? a. It is most often installed in front-engine rear- wheel-drive luxury automobiles. b. It is classified as a constant velocity U-joint. c. A centering ball socket is inside the coupling yoke between the two universal joints. d. All of the above.
Ass well as the ultimate load on the bar
Crank-rocker mechanism. Determine the length of the link PQ?
MUST SKETCH FREE BODY DIAGRAM (FBD)
Draw and design a bushed pin type flexible coupling
Draw Free body di
Part of the screw thread connecting the adjacent flank on the bottom of the screw thread is known as Root Flank Pitch Crest