Is the assembly language version of a FOR loop, WHILE loop, DO WHILE loop, GOTO loop  function the same or different? If different, identify the differences. Your comparison should be based on:  Number of registers used  Number of jumps (iterations)  Total number of operations

1)Write the following code segment in MARIE assembly and test it. int x, y; scanf(“%d”, &x); If ( x > 1) { y = x + x; x = 0; } y = y + 1; printf(“%d”, y); exit(0);

7. Print 10, 9, 8, ... 0, using loop. a. Write the while loop pseudocode. b. Write it in MARIE's assembly language.

Write an assembly function that uses a for loop to multiply all the numbers from 1 through and including N. Return the result. Print the returned value. Hello I was hoping someone could run through this code step by step as I am new to Assembly language, thank you!

Below you can see a Mealy and Moore design code as well as simulation (test bench) code. Can you write note on side of code illustrating what the line represents and explain how the two codes are behaving differently?    Mealy: Design source code: module mealy #Example of where the notes should go to represent how the lines are behaving ( input shift_start, input shift_stop, input rst, input clk, input d, output reg [7:0] q );   parameter Idle  =2'd0; parameter Start =2'd1; parameter Run   =2'd2; parameter Stop  =2'd3;   reg [1:0] state; reg [4:0] delay_cnt;   always @(posedge clk or negedge rst) begin     if(!rst)     begin         state <= Idle;         delay_cnt <= 0;         q <= 0;     end     else     case(state)         Idle : begin                 if(shift_start)                     state <= Start;                 end         Start : begin                  if(delay_cnt ==5'd99)                  begin                     delay_cnt <= 0;                     state…

The program counter changes after every instruction. True False