I need the answer as soon as possible Q: A tank is shown figure below will be filled with water and the water drains by gravityfrom small orifice ro = 3 cm & ca = 0.65 at bottom. Find the time required to empty tank?L=2m0.6 mR=0.3 m

Given: ro=3 cmCd=0.65L=2 mR=0.3 m

Answered: Q: A tank is shown figure below will be…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A two storey building has two faucets, one in the basement and one in the firstfloor. The maximum water (ρ = 1000 kg/m3) velocity at the basement faucet, when the first floor faucet is closed, is 13 m/s. The faucet diameter is 1.5 cm.Neglect all losses. What would be a maximum height (from the basement floor) for a faucet,to still get a maximum exit velocity of 6 m/s?
A pipe 50 cm in diameter carries water (l0°C} at a rate of 0.5 m 3 / s. A pump in the pipe isused to move the water from an elevation of 30 m to 40 m. The pressure at section 1 is 70kPa gauge, and the pressure at section 2 is 350 kPa gauge. What power in kilowatts and inhorsepower must be supplied to the flow by the pump? Assume h L = 3 m of water and α 1 =α 2 = 1. Find the following Draw the Schematic diagram Drive the energy equation Calculate pump head Power requirement
The water is flowing through a pipe having diameters 20 cm and 10 cm at sections 1and 2 respectively. The rate of flow through pipe is 35 litres/s. The section 1 is 6 m above datum and section 2 is 4 m above datum. If the pressure at section 1 is 39.24 N/cm2, find the intensity of pressure at section 2. Sketch the arrangement.
The penstock of hydroelectric turbine is 0.5m x 0.5m with velocity of 5.5m/s and head of 20m. What is the output of the turbine if the turbine efficiency is 92%?
The inlet and throat diameters of a horizontal venturimeter are 30 cm and 10 cm respectively. The liquid flowing through the venturimeter is water. The Pressure intensity at inlet is 13.734 N/cm² while the vacuum pressure head at the throat is 37 cm of mercury. Find the rate of flow. Assume that 4% of the differential head is lost between the inlet and throat. Find also the value of Ca for the venturimeter.
A pump has a head of 20m at 450rpm. What is the increase in head developed by the pump if speed increase to 1000rpm? ANSWER: 78.76 m
A pump was installed with a suction head of 6 meter and a discharge head of 10 meters. The discharge rate of the pump is 60 liters per minute. What is the water horsepower of the pump?
A manufacturer states that their gear pump requires 0.85 hp to pump 9 gpm of oil (sg=0.90) with a total head of 266 feet. What is the mechanical efficiency of this pump? Report your result in percent.
A horizontal pipe of diameter 0.2 m is suddenly enlarged to 0.3 m. If the rate of flow of water through the pipe is 0.2 m3/s and the intensity of pressure in the smaller pipe is 100 kPa, then find (i) the head loss due to sudden enlargement, (ii) power loss due to enlargement and (iii) intensity of pressure in the larger diameter pipe.
In an industrial cooling process, water is circulated through a system. If water is pump from the first floor through a 6cm diameter pipe with a speed of 0.45 m/s under a pressure of 400torr, what will be the pressure on the nest floor 4m above into a pipe with diameter 2cm? Show your solution
A cylindrical tank 0.9 m in radius rests atop a platform 6 m high. Initially the tank is filled with water (p = 1 x 103kg/m3) to a depth ho= 3 m. A plug whose area is 6.3 cm2 is removed from an orifice in the side of the tank at the bottom. What is the speed of the stream as it strikes the ground?
Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level inside the tank remains constant at 3m and the pressure at the top of the tank is 30KPa. If the jet strikes the ground horizontally by 4.5m and below the vena contracta by 1m, determine the coefficient of velocity.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Q: A tank is shown figure below will be filled with water and the water drains by gravity from small orifice ro = 3 cm & ca = 0.65 at bottom. Find the time required to empty tank? L=2m 0. 6 m R=0.3 m