Q.4/ A tank has pure water flowing into it at 10 L/min. The contents of the tank are kept thoroughly mixed, and the contents flow out at 10 L/min. Initially, the tank contains 10 kg of salt in 100 L of water. What is the differential equation that could represent the rate change of the salt over timet and what the amount of salt as a function to time t?

Q.4/ A tank has pure water flowing into it at 10 L/min. The contents of the tank are kept thoroughly mixed, and the contents flow out at 10 L/min. Initially, the tank contains 10 kg of salt in 100 L of water. What is the differential equation that could represent the rate change of the salt over timet and what the amount of salt as a function to time t?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 26P: SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the...

See similar textbooks

Similar questions

A tank initially contains 100 gallons of water. A salt solution containing 2lbs of salt per gallon flows in at the rate of 3 gallons per minute and the well stirred mixture flows cut at the same rate. When will the tank have 100 lbs of salt?a. 23.6 minutesb. 24.5 minutesc.23.1 minutes d. 20.5 minutessolve using the application of differential equation
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?
The capacities of two hemispherical tanks are in the ratio of 64:125. If 4.8 kg of paint is required to paint the outer surface of the smaller tank, then how many kg of paint will be needed to paint the outer surface of the larger tank? a. 4.6 b. 7.5 c. 6.4 d. 5.7
the reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. if the tank is 30 cm. deep, and is contaminated with 3.42 cm. of water at the bottom, how many meters of air remains at the top when the gage indicates "FULL"? use weight of: gasoline = 6.62 kN/m^3; air = 14.67 N/m^3. the tank is closed.
help, with complete solu 1. If a cup of cream with a density of 1008 kg/m3 is turned into 3 cups of whipped cream, determine the unit weight of the whipped cream.2. If 6 m3 of oil weighs 49 kN, calculate its specific weight γ, density ρ, and specific gravity.
a.) If the specific weight of a liquid is 55 lb/ft3, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft3/slug, what is its specific weight in lb/ft³?
USING FOL Differential Equation APPLICATION SOLVE THE FOLLOWING PROBELM AND SHOW COMPLETE SOLUTION AND FINAL ANSWER.In a tank of 100 liters of brine containing 50 kg total dissolved salt. Pure water is allowedto run into the tank at the rate of 3 liters a minute. Brine runs out of the tank at the rateof 2 liters a minute. The instantaneous concentration in the tank is kept uniform bystirring. How much salt is in the tank at the end of 1hour?
50 lb. of salt is dissolved in a large tank holding 200 gallons of water. A solution is in at a rate of 2.5 gallons/minute and pump out a 2 gallons/minute. The concentration of the solution entering is a 2 gallons/minute. How much salt in the tank at time t?
An open cylindrical tank 800mm in diameter and 2000mm high contains water to a depth of 1.6m. It is rotated about its vertical axis at 13 rad/s. How many liters of water are spilled? Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3
how much salt (NaCl) is carried by a river flowing at 25.0 m3/s and containing 40.0 mg/L? Give answer in kg/day
Solve the mixing problem using first order differential equations. A 200-gallon tank initially holds 50 gallons of salt solution containing 20 lbs dissolved salt. A pipe fills the tank with 2 lbs of salt per gallon at a rate of 5 gpm. The mixture is stirred uniformly and 3 gpm of brine runs out of the tank. a. Draw the schematic diagram of the system showing the values given in the problem. b. Determine the amount of salt in the tank at the end of 85 minutes.
Oil is filled within a tall cylindrical tank. A flat disk with a height of 1 cm and with a diameter of 5 cm is placed into the oil. There occurs a narrow spacing of 0.1 mm between the disk and the tank wall. Due to the forces acting on the disk, it moves downward, and after some time, the speed of the disk reaches a terminal velocity. Beyond this moment, measurements reveal that the disk moves 30 cm in 4 seconds. If the oil density is 600 kg/m3and the specific gravity of the disk is 1.5, determine the oil’s viscosity.