The figure shows a roof truss and the detail of the connection at joint B. Members BC and BE are angle sections with the thicknesses shown in the figure. The working stresses are 70 MPa for shear in the rivets and 140 MPa for bearing stress due to the rivets. How many 20-mm-diameter rivets are required to fasten the following members to the gusset plate: (a) BC; and (b) BE?

The figure shows a roof truss and the detail of the connection at joint B. Members BC and BE are angle sections with the thicknesses shown in the figure. The working stresses are 70 MPa for shear in the rivets and 140 MPa for bearing stress due to the rivets. How many 20-mm-diameter rivets are required to fasten the following members to the gusset plate: (a) BC; and (b) BE?

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter40: Drive Axles And Differentials

Section: Chapter Questions

Problem 1RQ

See similar textbooks

Similar questions

Large cars with long drive shafts often use a double U-joint arrangement called a_____. a. Spicer style U-joint b. constant velocity U-joint c. Cleveland style U-joint d. none of the above
With FBD per joints
Large cars with long drive shafts often use a double-U-joint arrangement called a __ .a. Spicer style U-jointb. constant velocity U-jointc. Cleveland style U-jointd. none of the above
Which of the following thread designs typically has tapered threads to provide for sealing at a joint? UNC NPT UNF UNEF
The single Cardan/Spicer universal joint is also known as the_____. a. cross joint b. four-point joint c. both a and b d. neither a nor b
Draw and design a bushed pin type flexible coupling
Number of half joints (J2)?
Identify atleast 10 work holding or clamping devices and their use.
Which type of joint has a flatter design than anyother?a. Double-offsetb. Discc. Cross grooved. Fixed tripod
Pressure vessel having 20in diameter is under a repeated load with a maximum pressure of 350psi per cycle. The vessel is made of AISIC1095. Determine its thickness.
Words: Cage, Centre, Changes, Drive, Flange, Inner, Joint, Race, PropellerA Löbro constant-velocity __________________, has an outer race, an inner race and a __________________ with steel balls.The outer race is bolted to the __________________ of the front propeller shaft, and the inner race is splined to the front endof the rear __________________ shaft. The joint is enclosed by a dust shield and boot. The front shaft is supported by a__________________ bearing.This type of joint is designed to allow __________________ in propeller shaft angle and also changes in propeller shaft length.Both the __________________ race and the outer race have angular grooves for the balls. The balls transfer__________________ from one race to the other but, at the same time, the inner __________________ is able to move in orout in the grooves or change its angle.
Question No.14: (a) Explain the Classification of Welded joints. (b) Explain the design of eccentrically loaded riveted joints. (c) The lead screw of a lathe has Acme threads of 50 mm outside diameter and 8 mm pitch. The screw must exert an axial pressure of 2500 N in order to drive the tool carriage. The thrust is carried on a collar 110 mm outside diameter and 55 mm inside diameter and the lead screw rotates at 30 r.p.m. Determine (a) the power required to drive the screw; and (b) the efficiency of the lead screw. Assume a coefficient of friction of 0.15 for the screw and 0.12 for the collar.