Two compounds were separated using gas chromatography. The retention times were 628 and 642 s, and the widths at half-height were 8.3 and 9.4 s, correspondingly. Find the resolution for these two compounds. Are the peaks well resolved? О 1.6, yes О 3.8, yes O 1.6, no O 7.5, yes O 0.93, no What is the pH for a solution with an OH concentration of 1.7 x 10 M? O4.77 7.00 5.23 9.23 8.76

Two compounds were separated using gas chromatography. The retention times were 628 and 642 s, and the widths at half-height were 8.3 and 9.4 s, correspondingly. Find the resolution for these two compounds. Are the peaks well resolved? О 1.6, yes О 3.8, yes O 1.6, no O 7.5, yes O 0.93, no What is the pH for a solution with an OH concentration of 1.7 x 10 M? O4.77 7.00 5.23 9.23 8.76

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter91: Gas Chromatography

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

a) What would you see if you ran a Thin Layer Chromatography (TLC) on a mixture of the three solids shown below using silica gel as the stationary phase and ethyl acetate/hexanes as the mobile phase? Whichsolid would have the highest Rf and which would have the lowest Rf? Explain b) Would changing the mobile phase (from part a) and increasing thepolarity by introducing small amount of methanol to the mobile phase change the order ofRf of the above 3 compounds? Explain c) Another type of chromatography is Reverse Phase Chromatography. In this type ofchromatography, the stationary phase is non-polar and the mobile phase is polar. If astudent performed Reverse Phase TLC on the mixture of 3 solids (from part a),what would be the order of Rf’s of the compounds? Which would have the lowest Rf andwhich would have the highest Rf?
What are the conditions for a successful gravimetric analysis. Define nucleation. What conditions are important for this stage.
A particular mixture was seperated into three components usin paper chromatography. the Rf value of dye A is 0.78, the Rf of dye B is 0.43 and the Rf of dye C is 0.19. What component of the mixture A,B,C is most soluble in the mobile phase and why?
We use reverse phase column chromatography with a non-polar C18 stationary phase and a mixture of acetonitrile and methanol as mobile phase in order to separate the dye molecules methyl fuchsin, parafuchsin, basic fuchsin and malachite green. What will be the order of elution of these molecules. Explain. Why won't these compounds separate using normal phase chromatography with silica and acetone?
Very low concentrations of perchlorate gave the following ion chromatography readings: 174, 178, 153, 192, 180, 166, 105 Seven blanks had a mean reading of 45.0 What is the signal detection limit for this method? report your answer to the nearest whole number
What is the principle of the instrumental method of analysis of Kool Aid Chromatography? Describe the components' (allura red and brilliant blue) separation of Kool Aid based on mobile and stationary phases.
1. What is paper chromatograpy?2. What are the stationary phase and mobile phase in paper chromatograpy?3. What is the principle underlying the paper chromatograpy?4. What is Rf value of a dye or pigment?5. Would you expect that changing the solvent will change the Rf value of the specific solute? Why?6. Suggest simple reasons why the Ni2+ and Fe3+ ions have different Rf values?7. What forces causes the eluting solution to move the chromatographic support material?
How does the dielectric constants relate to the polarity of the compounds separated and obtained via column chromatography?
The purpose of this experiment is to use both extraction and crystallization techniques to separate a solid mixture of organic compounds. You will receive a packet with 1 g of a unknown (pH is basic) amide solid sample which will contain three components, one from each group: Group 1 (~50% wt): ethyl 4-aminobenzoate, ortho-toluic acid, or benzoic acid Group 2 (~40% wt): fluorene, 1,4-dibromobenzene, benzil, benzoin Group 3 (~10% wt): fluorene, 1,4-dibromobenzene, benzil, benzoin (but not the same as Group 2 compound) Create a lab procedure that will allow you to successfully isolate, purify, and identify the two major (Group 1 and Group 2) components of the unknown amide sample. reagents that can be used are 1M HCl, 6M HCl, 1M NaOH, 6M NaOH, diethyl ether, and methylene chloride
A thin layer chromatography experiment is planned to determine the Rf values of four compounds. List the following compounds in order of increasing Rf values from shortest to longest. (If B is shortest, then A, C, and D is longest, enter BACD )
A student developed a chromatogram and found that the eluent front traveled 69 mm and the Zinc cation traveled 24 mm. In the development of a chromatogram of a mixture of cations, the eluent front traveled 52mm. If the Zinc cation is a cation of the unknown mixture, where will its band appear in the chromatogram?
How do you report the average and %RSD for the %w/w of acetic acid in an unknown solution after titrating with NaOH in triplicate? Just explain the process, and how these values can be reported via the colorimetric and potentiometric endpoints.