What does the %RSD, listed in the spectral data, as well as the correlation coefficient of your standard curve, tell you about the quality of the data and integrity of the results? my standard % RSD is 36.4%, I had to calculate manually from the 5 standard solutions I did have on the spectra. The R squared value from the standard curve is 0.7282

What does the %RSD, listed in the spectral data, as well as the correlation coefficient of your standard curve, tell you about the quality of the data and integrity of the results? my standard % RSD is 36.4%, I had to calculate manually from the 5 standard solutions I did have on the spectra. The R squared value from the standard curve is 0.7282

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter8: Sampling, Standardization, And Calibration

Section: Chapter Questions

Problem 8.16QAP

See similar textbooks

Similar questions

What are the differences between systematic and random errors and how do they effect accuracy and precision? In what circumstances would you use standard addition (versus a normal calibration curve) to determine the amount of an analyte in a sample? A urine sample, containing analyte Z is analysed by the standard addition method where 5 mL of the original sample was mixed with increasing amounts of a Z standard and each solution diluted to a volume of 50 mL prior to analysis. A plot of the final concentration of the standard in each of the 50 mL samples (x axis) versus The measured signal from the analysis of each 50 mL sample (on y axis) produced a straight line with the general equation: y = 44.72x + 4.06 what was the final concentration of Z in the 50 mL standard addition sample? what was the initial concentration of Z in the original urine sample?
One method for the quantitative determination of the concentration of constituents in a sample analyzed by gas chromatography is area normalization. Here, complete elution of all the sample constituents is necessary. The area of each peak is then measured and corrected for differences in detector response to the different eluates. This correction involves dividing the area by an empirically determined correction factor. The concentration of the analyte is found from the ratio of its corrected area to the total corrected area of all peaks. For a chromatogram containing three peaks, the relative areas were found to be 16.4, 45.2 and 30.2, in order of increasing retention time. Calculate the percentage of each compound if the relative detector responses were 0.60, 0.78 and 0.88, respectively.
If an instrument gives a response of 1240 for a standard containing 8 ppm of a substance, how much if this substance is in a sample that gives a response of 1705? Are any assumptions needed?
a sample of butyl benzoate is prepared to use as an internal standard. The results of a preliminary run, which used a solution known to contain 1.53 mg/mL of methyl benzoate (peak A) and1.68 mg/mL of butyl benzoate (peak B), are shown. The area of peak A is determined to be 352 and the area of peak B is determined to be 416 measured in arbitrary units by the computer. To measure the sample, 1.00 mL of a standard sample of butyl benzoate containing 2.19 mg/mL is mixed with 1.00 mL of the plant stream material. Analysis of the mixture gave a peak area of 449 for peak A and 411 for peak B. What is the concentration of methyl benzoate in the plant stream? concentration of methyl benzoate = ____________________ mg/mL
1. What is the MW of the analyte?2. What is the meq of the analyte?3. What will be the weight (in grams) of the analyte if the standardization is to be quartered?4. What will be Normality of the solution if 7.5ml of the titrant was consumed in the standardization?5. What is the average Normality if two or more trials were conducted with the values of 0.102N and 0.105N?
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample. The stated should be 104.5, how??
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample.
What are the types of gravimetric methods? Give an examples where each method is used in an analysis.
How can I get question 8 - Calculate the percent error for the separation of your mixture- equation 3 How can I get question 9 - Calculate the mean percent for determinations 1 and 2 - equation 4
One method for quantitative determination of the concentration of constituents in a sample analyzed by gas chromatography is the area normalization method. In this method, complete elution of all of the sample constituents is necessary. The area of each peak is then measured and corrected for differences in detector response to the different eluates. This correction is accomplished by dividing the area by an empirically determined correction factor. The concentration of the analyte is found from the ratio of its corrected area to the total corrected area of all peaks. For a chromatogram containing three peaks, the relative areas were found to be 16.4, 45.2, and 30.2 in the order of increasing retention time. Calculate the percentage of each compound if the relative detector responses were 0.60, 0.78, and 0.88, respectively
Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.
25 ml of pickled brine was taken from an apple pickled with vinegar and diluted to 500 ml, 25 ml of this was taken and acidity was determined with 0.2 N (Factor: 1.05) NaOH. In the main trials, 6.3 ml - 6.5 ml - 6.9 ml, respectively, 0.1 ml base was used in the analysis without using the sample.For example, how many ppm is its acidity?