The concentration of glucose in an aqueous solution can be determined by oxidation with ferricyanide ion, Fe(CN)6^3–. The absorbance of the ferricyanide ion measured at 420 nm increases as the concentration of glucose increases. TT[Glucose], mg / mL5.00010.00Absorbance0.1320.29020.000.49830.000.64240.000.750a.Using the method of least-squares, give the equation of the best straight line through the points.b. Calculate the concentration of an unknown solution that gave an absorbance of 0.440.C.Give the correlation coefficient R and tell whether it is a good fit line or not.

a) In the given table, the absorbance data of ferricyanide ion is given on varying the concentration…

[Glucose), mg / mL | Absorbance 0.132 5.000 10.00 20.00 30.00 0.290 0.498 0.642 40.00 0.750 a. Using the method of least-squares, give the equation of the best straight line through the points. b. Calculate the concentration of an unknown solution that gave an absorbance of 0.440. c. Give the correlation coefficient R and tell whether it is a good fit line or not.

[Glucose), mg / mL | Absorbance 0.132 5.000 10.00 20.00 30.00 0.290 0.498 0.642 40.00 0.750 a. Using the method of least-squares, give the equation of the best straight line through the points. b. Calculate the concentration of an unknown solution that gave an absorbance of 0.440. c. Give the correlation coefficient R and tell whether it is a good fit line or not.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.16QAP

See similar textbooks

Similar questions

From the data in Problem 26-14, calculate for species C and D) (a) the resolution. (b) the length of column necessary to separate the two species with a resolution of 2.5.
A 131.7 mg sample of powdered Carbamazepine tablets was boiled with ethanol, filtered and then made up to 100 mL with ethanol. 5 mL of this solution was then diluted to 250 mL with ethanol and the absorbance at 285 nm found to be 0.486 in a 1cm path length cell.Calculate the content (% m/m) of Carbamazepine in the powder, taking A(1%, 1 cm) as 490.(State your answer to 1 decimal place and include the units)
A student weighed out 0.150 g of protein powder and dissolved it in 100 mL of water (Solution 1). The student then diluted this solution by transferring 1 mL into a 25 mL flask and diluting with water (Solution 2). Finally, 1 mL of that solution was transferred to a test tube and combined with 4 mL Bradford reagent. The absorbance of the solution in the test tube was 0.144. Assuming that the best fit linear line of the standard curve was y=0.04144x+0.01521 (μgmL), calculate the percent protein by mass in the original protein powder.
A student weighed out 0.150 g of protein powder and dissolved it in 100 mL of water (Solution 1). The student then diluted this solution by transferring 1 mL into a 25 mL flask and diluting with water (Solution 2). Finally, 1 mL of that solution was transferred to a test tube and combined with 4 mL Bradford reagent. The absorbance of the solution in the test tube was 0.187. Assuming that the best fit linear line of the standard curve was y = 0.04144 x + 0.01521 (μ g mL), calculate the percent protein by mass in the original protein powder.
Suppose that a solution has an absorbance of 0.226 at a wavelength of 450 nm. If the concentration of the solution is 24 μM, what is the value of the molar absorptivity? The data were taken with a standard 1-cm cuvette.
A standard curve for glucose analysis was prepared.The slope (m) was found to be 1.341 while the y-intercept (b) was -0.333. Calculate the concentration (x) of glucose having an absorbance (y) of 0.151. 0.067 0.361 0.858 0.136
A green solution containing Ni+2 ions absorbs 580 nm light. Undiluted, a sample of this solution sampled in a 1.00 cm diameter cuvette has an absorbance of 0.9765 a.u.. If the molar absorptivity coefficient for Ni+2 is 6.3 x 104 M -1 cm -1 at 580 nm, how much of the original stock Ni+2 solution (in mL) needs to be added to water to create a total dilute solution volume of 10.00 mL that measures an absorbance of 0.146 a.u. at 580 nm? Report your answer to 3 significant figures. Do not include the "mL' unit label in your response
A spectrophotometric method for the quantitative determination of the concentration ofPb2+ in blood yields an Ssamp of 0.133 for a 1 mL sample of blood that has been diluted to 6 mL. A second sample is spiked with 1 µL of a 1467 ppb Pb2+ standard and diluted to 6 mL, yielding an Sspike of 0.491. Determine the concentration of Pb2+ in the original sample of blood.
A student prepared several solutions of an unknown molecule, each at a different concentration. The absorbance of each solution was measured at 630 nm with a path length of 0.760 cm. The student then plotted the absorbance of each sample vs. its concentration (in uM), and found a best-fit line of y = 0.00626x + 0.00732. Calculate the molar absorptivity of the unknown molecule (in M-1 cm-1).
Please complete Table 2 and show the calculations for protein concentration and the concentration of the undiluted sample. a). Using Excel software, enter data from Table 1 to plot a standard curve (corrected average absorbance on Y-axis and protein concentrations on X-axis). The standard curve must contain correct labels on both axes. b). From the standard curve, obtain a best fit line and equation. c). Use the best fit equation and data from Table 2 to find the concentrations of proteins in sample A2-D2 and E1. [onto your plotted standard curve, indicate where A595 of A2-D2 and E1 are located] d). Calculate the concentrations of proteins in undiluted samples A to E. Thank you very much.
A 10.00 mL of natural water sample containing Ni2+ was pipetted into a volumetric flask and diluted to 50.00 mL with pure water. In the second 10.00 mL of natural water sample transferred into a volumetric flask, exactly 4.00 mL of a Ni2+ solution with a concentration of 5.99 mg/L was added and then diluted to 50.00 mL with pure water. The measured absorbance is A1= 0.436 and A2 = 0.663. What is the Ni2+ concentration in unit of mg/L in the natural water sample?