With the methods and GC columns used in organic labs, the volatility of the nitrotoluene products is the factor that is most responsible for the separation of the products in the GC. Predict the order of the nitrotoluene retention times expected in your chromatogram. Order from lowest (top) to highest (bottom) retention time. Para-Nitrotolulene, Meta-Nitrotolulene, Ortho-Nitrotolulene

With the methods and GC columns used in organic labs, the volatility of the nitrotoluene products is the factor that is most responsible for the separation of the products in the GC. Predict the order of the nitrotoluene retention times expected in your chromatogram. Order from lowest (top) to highest (bottom) retention time. Para-Nitrotolulene, Meta-Nitrotolulene, Ortho-Nitrotolulene

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter90: High-performance Liquid Chromatography (hplc)

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Two compounds A and B from GC on two open tubular columns contains a XY-1 (100% methyl) and a XY-2 (50% methyl, 50% phenyl), with the same diameter, thickness and length under the same experimental conditions. The retention times and peak widths are show in the Table 1.Hint: phenyl groups interact more strongly with polar groups than methyl groups. Which compound is more polar? Explain your answer
Gestation time arrangement of Hegran, Hexanol, and Benzene compounds in the reverse phase of column liquid chromatography.
Retention times in a 1.25m chromatographic column: dead time, 0.395 min; isopropylamine, 4.59 min; and n-propylamine, 4.91 min.Peak widths: 0.365 min for isopropylamine and 0.382 min for n-propylamine. Calculate: (a) Value of the retention factor (k') for each amine (b) Value of the selectivity factor (alpha) between the two amines (c) Number of theoretical column trays (d) Column tray height (e) Resolution between the two amines
Using reversed phase chromatography in order to separate chloroquine and hydroxychloroquine. Which will be the first one to elute out of the column? Or both will elute the same time?
If a column was run on the sample shown in lane 3, what would be the first compound to elute off of the column? (assume the same solvent and stationary phase are used) Which of the lanes on this TLC plate show pure compounds? Select all that apply.
SEE PHOTO: Effectiveness of separation. Based on the TLC analysis, did the isolated benzoic acidappear pure relative to the starting mixture? Did the isolated naphthalene look pure?How could the purity of the isolated materials be improved? In the picture: Aq- is Benzoic acid O- is Naphthalene both- is both Benzoic acid and Naphthalene
In a gas chromatogram, the retention time of compounds A and B are 1.25 min and 1.45 min, respectively. If both of these compounds have similar structures, which of the compounds has a higher boiling point?
Which two of compounds below will be difficult to be separated by column chromatography (using ethanol as solvent) and why? -p-anisic acid -methyl-4-aminobenzoate -benzoic acid -ethyl-3-hydroxybenzoate -ethyl-4-nitrobenzoate -trans-cinnamic acid -benzanilide -2-methyl-1-nitronapthalene -9-fluorenone -naphthalene -trans-stilbene -vanillin
Determine the order of inhibition time of hexane, hexanol and benzene compounds in the reverse phase liquid chromatography column.
Thin Layer Chromatography why the non-polar compounds move up the plate most rapidly (higher Rf value), whereas polar substances travel up the TLC plate slowly or not at all (lower Rf value)? Please help me explain this question! Thank you so much!
In a reverse phase chromatography setup, which of the following compounds will have the HIGHEST retention time? ethanol water toluene isopropanol
Propose a extraction flowchart capable of seperating this mixture into its pure form