Explanation Draw the T − s diagram of the given regenerative Rankine cycle as shown in Figure 1. Here, water (steam) is the working fluid of the regenerative Rankine cycle. The cycle involves two pumps. Write the formula for work done by the pump during process 1-2. w pI,in = v 1 ( P 2 − P 1 ) (I) Here, the specific volume is v , the pressure is P , and the subscripts 1 and 2 indicates the process states. Write the formula for enthalpy ( h ) at state 2. h 2 = h 1 + w pI,in (II) Write the formula for work done by the pump during process 3-4. w pII,in = v 3 ( P 4 − P 3 ) (III) Here, the specific volume is v , the pressure is P , and the subscripts 3 and 4 indicates the process states. Write the formula for enthalpy ( h ) at state 4. h 4 = h 3 + w pII,in (IV) At state 6: The steam expanded to the pressure of 0.4 MPa and the steam is at the state of saturated mixture. The quality of water at the exit of the turbine (state 6) is expressed as follows. x 6 = s 6 − s f , 6 s f g , 6 (V) The enthalpy at state 6 is expressed as follows. h 6 = h f , 6 + x 6 h f g , 6 (VI) Here, the enthalpy is h , the entropy is s , the quality of the water is x , the suffix f indicates the fluid condition, the suffix f g indicates the change of vaporization phase; the subscript 6 indicates the state 6. At state 7: The steam enters the condenser at the pressure of 20 kPa and at the state of saturated mixture. The quality of water at state 7 is expressed as follows. x 7 = s 7 − s f , 7 s f g , 7 (VII) The enthalpy at state 7 is expressed as follows. h 7 = h f , 7 + x 7 h f g , 7 (VIII) Here, the subscript 7 indicates the process state 7. Write the formula for heat in ( q in ) and heat out ( q out ) of the cycle. q in = h 5 − h 4 (IX) q out = ( 1 − y ) ( h 7 − h 1 ) (X) Here, the mass fraction steam extracted from the turbine to the inlet mass of the boiler ( m ˙ 6 / m ˙ 3 ) is y . Write the general equation of energy balance equation. E ˙ in − E ˙ out = Δ E ˙ system (XI) Here, the rate of net energy inlet is E ˙ in , the rate of net energy outlet is E ˙ out and the rate of change of net energy of the system is Δ E ˙ system . At steady state the rate of change of net energy of the system ( Δ E ˙ system ) is zero. Δ E ˙ system = 0 Refer Equation (XI). Write the energy balance equation for open feed water heater. E ˙ in − E ˙ out = 0 E ˙ in = E ˙ out ∑ m ˙ in h in = ∑ m ˙ out h out m ˙ 6 h 6 + m ˙ 2 h 2 = m ˙ 3 h 3 (XII) Rewrite the Equation (XII) in terms of mass fraction y . y h 6 + ( 1 − y ) h 2 = 1 h 3 y h 6 + h 2 − y h 2 = h 3 y ( h 6 − h 2 ) = h 3 − h 2 y = h 3 − h 2 h 6 − h 2 (XIII) Write the formula for exergy destruction of the cycle. x destroyed, cycle = T 0 ( q out T L − q in T H ) (XIV) Here, the surrounding temperature is T 0 , the sink temperature is T L , and the source temperature is T H . The surrounding temperature is equal to the sink temperature. T 0 = T L At state 1: (Pump I inlet) The water exits the condenser as a saturated liquid at the pressure of 20 kPa . Hence, the enthalpy and specific volume at state 1 is as follows. h 1 = h f @ 20 kPa v 1 = v f @ 20 kPa Refer Table A-5, “Saturated water-Pressure table”. The enthalpy ( h 1 ) and specific volume ( v 1 ) at state 1 corresponding to the pressure of 20 kPa is 251.42 kJ/kg and 0.001017 m 3 /kg respectively. At state 3: (Pump II inlet) The water exits the open feed water heater as a saturated liquid at the pressure of 0.4 MPa ( 400 kPa ) . Hence, the enthalpy and specific volume at state 3 is as follows. h 3 = h f @ 400 kPa v 3 = v f @ 400 kPa Refer Table A-5, “Saturated water-Pressure table”. The enthalpy ( h 3 ) and specific volume ( v 3 ) at state 3 corresponding to the pressure of 0.4 MPa ( 400 kPa ) is 604.66 kJ/kg and 0.001084 m 3 /kg respectively. At state 5: The steam enters the turbine as superheated vapor. Refer Table A-6, “Superheated water”. The enthalpy ( h 5 ) and entropy ( s 5 ) at state 5 corresponding to the pressure of 6 MPa ( 6000 kPa ) and the temperature of 450 ° C is as follows. h 5 = 3302.9 kJ/kg s 5 = 6.7219 kJ/kg ⋅ K Refer Figure 1. s 5 = s 6 = s 7 = 6.7219 kJ/kg ⋅ K At state 6: The steam expanded to the pressure of 0.4 MPa ( 400 kPa ) and in the state of saturated mixture. Refer Table A-5, “Saturated water-Pressure table”. Obtain the following properties corresponding to the pressure of 0.4 MPa ( 400 kPa ) . h f , 6 = 604.667 kJ/kg h f g , 6 = 21334 kJ/kg s f , 6 = 1.7765 kJ/kg ⋅ K s f g , 6 = 5.1191 kJ/kg ⋅ K At state 7: The steam enters the condenser at the pressure of 20 kPa and at the state of saturated mixture. Refer Table A-5, “Saturated water-Pressure table”. Obtain the following properties corresponding to the pressure of 20 kPa . h f , 7 = 251.42 kJ/kg h f g , 7 = 2357.5 kJ/kg s f , 7 = 0.8320 kJ/kg ⋅ K s f g , 7 = 7.0752 kJ/kg ⋅ K Conclusion: Substitute 0.001017 m 3 / kg for v 1 , 20 kPa for P 1 , and 400 kPa for P 2 in Equation (I). w pI,in = ( 0.001017 m 3 / kg ) ( 400 kPa − 20 kPa ) = 0

9th Edition

ISBN: 9781264446889

Author: CENGEL

Publisher: MCG

See similar textbooks

Videos

Question

Chapter 10.9, Problem 67P

To determine

The exergy associated with the cycle.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Chapter 10.9, Problem 66P

Chapter 10.9, Problem 68P

Students have asked these similar questions

Solve a question in the shortest possible time

In a steam plant operating according to an ideal Rankine cycle, water vapor enters the turbine at a pressure of 3.0 MPa and a temperature of 600 oC and exits the turbine with a dryness of 100 kPa and 0.8. By removing heat from the condenser to the surrounding environment, the water is provided to be saturated liquid at 100 kPa. In this case, what would be the amount of heat released from the Condenser to the surrounding environment per unit mass?

Consider a 150-MW steam power plant that operates on a simple Rankine cycle. Steam enters the turbine at 7 MPa and 500°C and is cooled in the condenser at 10 kPa. Calculate the plant monthly consumption of coal if its heating value is 26,450 kJ/kg and the boiler has an efficiency of 90%. Assume an isentropic efficiency of 87% for both the turbine and the pump.

Chapter 10 Solutions

THERMODYNAMICS LLF W/ CONNECT ACCESS

Ch. 10.9 - Why is the Carnot cycle not a realistic model for...Ch. 10.9 - Why is excessive moisture in steam undesirable in...Ch. 10.9 - A steady-flow Carnot cycle uses water as the...Ch. 10.9 - A steady-flow Carnot cycle uses water as the...Ch. 10.9 - Consider a steady-flow Carnot cycle with water as...Ch. 10.9 - Water enters the boiler of a steady-flow Carnot...Ch. 10.9 - What four processes make up the simple ideal...Ch. 10.9 - Consider a simple ideal Rankine cycle with fixed...Ch. 10.9 - Consider a simple ideal Rankine cycle with fixed...Ch. 10.9 - Consider a simple ideal Rankine cycle with fixed...

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

The exergy associated with the cycle.

Solution Summary: The author illustrates the regenerative Rankine cycle by drawing the T-s diagram of water (steam) as the working fluid of the cycle.

Videos

The exergy associated with the cycle.

Want to see the full answer?

Chapter 10 Solutions