A feedback system has an amplifier with a low-frequency open-loop gain of
(a)
Value of frequency at the given values.
Answer to Problem 12.77P
Value of frequency is 1.005×106Hz.
Explanation of Solution
Given information:
Given values are −
The phase of loop gain is 180 degrees
Calculation:
Loop gain can be written as −
Phase of loop gain can be written as −
Value of frequency is −
(b)
Value of ß at the given values.
Answer to Problem 12.77P
Value of ß is 2.83×10-3.
Explanation of Solution
Given:
Given values are −
Calculation:
Value of phase angle of loop gain is −
Magnitude of frequency is −
Value of ß is −
(c)
Value of low frequency closed loop gain.
Answer to Problem 12.77P
Value of low frequency closed loop gain is 350.87.
Explanation of Solution
Given:
Given values are −
Calculation:
Value of closed loop gain is given by −
Value of low frequency gain is −
Want to see more full solutions like this?
Chapter 12 Solutions
MICROELECT. CIRCUIT ANALYSIS&DESIGN (LL)
- For the unity feedback system given below, the damping ratio of the closed looppoles is given by a) 1.5 b) 1 c) 0.5 d) 0.25arrow_forward(a) Calculate the sensitivity of the closed-loop input resistance of the series-shunt feedback amplifier with respect to changes in open-loop gain A:SRinA = A/ Rin ∂Rin/ ∂A (b) Use this formula to estimate the percentage change in closed-loop input resistance if the openloop gain A changes by 10 percent for an amplifier with A = 94 dB and β = 0.01. (c) Calculate the sensitivity of the closed-loop output resistance of the series-shunt feedback amplifier with respect to changes in open-loop gain A:SRout A = A /Rout ∂Rout /∂A (d) Use this formula to estimate the percentage changeinclosed-loopoutputresistanceiftheopenloop gain A changes by 10 percent for an amplifier with A =100 dB and β =0.01.arrow_forwardUse feedback theory to derive an expression for the input impedance of the “shunt-shunt” feedback amplifier as shown.arrow_forward
- State whether the following statement is true or false. “Dominant pole compensation increases the unity-loop-gain bandwidth of a feedback system.” Please answer with few line explanation.arrow_forwardQ1/ (a) A negative-feedback amplifier has a closed-loop gain of Af=100 and an open-loop gain of A =5 x 10*. Determine the feedback transfer function p. (b) If p=10.012 and Af = 80, determine the open-loop gain A.arrow_forwardA. If the forward gain is 5 and feedback gain is 1, determine the close-loop gain of a negative feedback amplifier. answer: B. For a Wien-bridge oscillator (as presented in the lecture), if the feedback resistor has a value of 10-kohm, determine the value of Ri (in kilo-ohm). answer:arrow_forward
- Consider a system with no zeros and only one pole as +5. Place this system in the forward path of a feedback system and add a PD controller in the feedback path with proportional gain 300 and derivative gain 40. Now draw the entire block diagram showing the transfer functions of each block clearly. Then find the closed-loop transfer function of the entire system.arrow_forwardControl Systems, expand on configurations of feedback compensation and give detailed solutions.arrow_forwardA negative feedback closed loop system gain, y(t) /r(t) ), of at least 7.5 is needed with a ß = 0.1. a. What is the minimum value of the forward gain, 4, that will allow this? b. What is the loop gain for this system?arrow_forward
- Given the following amplifier with feedback circuits A, B, C and D shown below... Assuming circuits A and C share the same feedback topology, determine their feedback topology. Assuming circuits B and D share the same feedback topology, determine their feedback topology. Determine whether each circuit utilizes positive or negative feedback. Note: For questions asking for feedback topology, answers can only be shunt-shunt, shunt-series, series-series or series-shuntarrow_forwardThe open-loop transfer function of the unit feedback control system is determined by the root locus method.Please specify. Interpret your results.arrow_forwardLoop gain analysis in a feedback system applies for __________. Option (1) small-signal perturbations Option (2) large-signal perturbations Option (3) both large and small-signal perturbationsarrow_forward
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,