Concept explainers
(I) A tower crane (Fig. 12–48a) must always be carefully balanced so that there is no net torque tending to tip it. A particular crane at a building site is about to lift a 2800-kg air-conditioning unit. The crane’s dimensions are shown in Fig. 12–48b. (a) Where must the crane’s 9500-kg counterweight be placed when the load is lifted from the ground? (Note that the counter-weight is usually moved automatically via sensors and motors to precisely compensate for the load.) (b) Determine the maximum load that can be lifted with this counterweight when it is placed at its full extent. Ignore the mass of the beam.
Want to see the full answer?
Check out a sample textbook solutionChapter 12 Solutions
Modified Mastering Physics without Pearson eText-- Instant Access -- for Physics for Scientists & Engineers with Modern Physics
Additional Science Textbook Solutions
University Physics with Modern Physics (14th Edition)
University Physics (14th Edition)
University Physics Volume 2
College Physics
The Cosmic Perspective (8th Edition)
The Cosmic Perspective Fundamentals (2nd Edition)
- (II) A uniform steel beam has a mass of 940 kg. On it is resting half of an identical beam, as shown in Fig. 9-60. What is the vertical support force at each end? •M •Marrow_forwardFB (I) Three forces are applied to a tree sapling, as shown in Fig. 9–46, to stabilize it. If FA = 385 N and FB = 475 N, find Fc in magnitude 105° and direction. FA FIGURE 9–46 Éc. Problem 1.arrow_forward(III) A uniform ladder of mass m and length l leans at an angle 0 against a frictionless wall, Fig. 9–70. If the coefficient of static friction between the ladder and the ground is µs, determine a formula for the minimum angle at which the ladder will not slip. FIGURE 9-70 Problem 30.arrow_forward
- The uniform 19.0 kg beam below is 6.4 m long and is perfectly balanced about a point 1.4 m from the left end. What is the mass of the block? (Hint: when calculating the torque due to the weight of the beam, consider all of its mass to be located at its center of mass.)arrow_forward- 5. Two identical, uniform beams of length 3 m and weighing 260 N each are connected at one end by a frictionless hinge. A light horizontal crossbar, attached at the midpoints of the beams maintains an angle 50° between the beams. The beams are suspended from the ceiling by vertical wires so they form a V. See figure. (a) What force does the crossbar exert on each beam? (b) Is the crossbar under compression or tension, i.e. are the ends of the crossbar being pushed together or stretched farther apart? (c) What force (magnitude and direction) does the hinge exert on each beam? Crossbar Hingearrow_forward(I) A marble column of cross-sectional area 1.4 m2supports a mass of 25,000 kg. (a) What is the stress within the column?(b) What is the strain?arrow_forward
- Two identical, uniform beams are symmetrically set up against each other (Fig. 9–87) on a floor with which they have a coefficient of fric- tion µs = 0.50. What is the minimum angle the beams can make with the floor and still not fall? FIGURE 9-87 Problem 71.arrow_forward(II) A 110-kg horizontal beam is supported at each end.A 320-kg piano rests a quarter of the way from one end.What is the vertical force on each of the supports?arrow_forward(II) Find the tension in the two cords shown in Fig. 9-45. Neglect the mass of the cords, and assume 9. that the angle e is 33° and the mass m is 170 kg. FIGURE 9-45 Problem 11.arrow_forward
- (II) If a compressive force of 3.3x104 N is exerted on the end of a 22-cm-long bone of cross-sectional area 3.6 cm2 (a) will the bone break, and (b) if not, by how much does it shorten?arrow_forward(24) Assuming the lower arm has a mass of 2.8 kg and its CG is 12 cm from the elbow- joint pivot, how much force must the extensor muscle in the upper arm exert on the lower arm to hold a 7.5 kg shot put (Fig. 12-7)? 11) 2.5 cm F M A) 100 N 30.0 cm- Elbow joint B) 750 N C) 1500 N D) 500 N E) 1000 Narrow_forwardA uniform beam of length ? and mass ? is inclined at an angle ? to the horizontal. Itsupper end is connected to a wall by a rope, and its lower end rests on a rough, horizontal surface.arrow_forward
- University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning