Essential University Physics Plus Mastering Physics with eText -- Access Card Package (3rd Edition)
3rd Edition
ISBN: 9780321975973
Author: Richard Wolfson
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 12, Problem 48P
A rectangular block twice as high as it is wide is resting on a board. The coefficient of static friction between board and incline is 0.63. If the board's inclination angle θ (shown in Fig. 12.27) is gradually increased, will the block first tip over or first begin sliding?
FIGURE 12.27 Problem 48, 49 and 50
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
One end of a uniform rod of weight w = 73.5 N and length L = 2.55 m is supported by a cable at an angle of ? = 37.0°above the rod. The other end rests on a small frictionless support and presses into a wall as shown in the figure.
Determine the magnitude n of the vertical normal force exerted by the support on the rod and find the magnitude T of the tension in the cable.
a uniform rod of mass m is hinged to a building at its lower end, while its upper end is held in place by a rope attached to the wall. If angle u1 = 60°, what value must angle u2 have so that the tension in the rope is equal to mg/2?
A uniform ladder of mass (m= 13.5 kg) and length (L) leans against a frictionless wall. If the angle ©60.0°, find the static friction force between the ladder and the floor when a 60.0-kg person stands two-third of the wayup the ladder?
Chapter 12 Solutions
Essential University Physics Plus Mastering Physics with eText -- Access Card Package (3rd Edition)
Ch. 12.1 - The figure shows three pairs of forces acting on...Ch. 12.2 - Prob. 12.2GICh. 12.3 - The figure shows a person in static equilibrium...Ch. 12.4 - Prob. 12.4GICh. 12 - Give an example of an object on which the net...Ch. 12 - Give an example of an object on which the net...Ch. 12 - Prob. 3FTDCh. 12 - Pregnant women often assume a posture with their...Ch. 12 - When you carry a bucket of water with one hand,...Ch. 12 - Is a ladder more likely to slip when you stand...
Ch. 12 - How does a heavy keel help keep a boat from...Ch. 12 - Does choosing a pivot point in an equilibrium...Ch. 12 - If you take the pivot point at the application...Ch. 12 - A short dog and a tall person are standing on a...Ch. 12 - Prob. 11FTDCh. 12 - A body is subject to three forces; F1=1i+2jN,...Ch. 12 - To demonstrate that the choice of pivot point...Ch. 12 - In Fig. 12.11 the forces shown all have the same...Ch. 12 - Figure 12.12a shows a thin, uniform square plate...Ch. 12 - Repeat the preceding problem for the equilateral...Ch. 12 - A 23-m-long log of irregular cross section lies...Ch. 12 - A 60-kg uniform board 2.4 m long is supported by a...Ch. 12 - Where should the child in Fig. 12.14 sit if the...Ch. 12 - A 4.2-m-long beam is supported by a cable at its...Ch. 12 - Figure 12.15 shows how a scale with a capacity of...Ch. 12 - A portion of a roller-coaster track is described...Ch. 12 - Prob. 23ECh. 12 - Youre a highway safety engineer, and youre asked...Ch. 12 - Figure 12.17a shows an outstretched arm with mass...Ch. 12 - A uniform sphere of radius R is supported by a...Ch. 12 - You work for a garden equipment company, and youre...Ch. 12 - Figure 12.20 shows the fool and lower leg of a...Ch. 12 - A uniform 5.0-kg ladder is leaning against a...Ch. 12 - The boom in the crane of Fig. 12.21 is free to...Ch. 12 - A uniform board of length L and weight W is...Ch. 12 - Figure 12.23 shows a 1250-kg car that has slipped...Ch. 12 - Repeat Example 12.2, now assuming that the...Ch. 12 - You are headwaiter at a new restaurant, and your...Ch. 12 - Climbers attempting to cross a stream place a...Ch. 12 - A crane in a marble quarry is mounted on the...Ch. 12 - A rectangular block measures w w L, where L is...Ch. 12 - The potential energy as a function of position for...Ch. 12 - A rectangular block of mass m measures w w L,...Ch. 12 - A 160-kg highway sign of uniform density is 2.3 m...Ch. 12 - A 5.0-m-long ladder has mass 9.5 kg and is leaning...Ch. 12 - Prob. 42PCh. 12 - A uniform, solid cube of mass m and side s is in...Ch. 12 - An isosceles triangular block of mass m and height...Ch. 12 - Youre investigating ladder safety for the Consumer...Ch. 12 - A 2.0-m-long rod has density in kilograms per...Ch. 12 - What horizontal force applied at its highest point...Ch. 12 - A rectangular block twice as high as it is wide is...Ch. 12 - What condition on the coefficient of friction in...Ch. 12 - A uniform solid cone of height h and base diameter...Ch. 12 - Prove the statement in Section 12.1 that the...Ch. 12 - Three identical books of length L are stacked over...Ch. 12 - A uniform pole of mass M is at rest on an incline...Ch. 12 - For what angle does the situation in Problem 53...Ch. 12 - Figure 12.31 shows a popular system for mounting...Ch. 12 - The nuchal ligament is a thick, cordlike structure...Ch. 12 - A 4.2-kg plant hangs from the bracket shown in...Ch. 12 - The wheel in Fig. 12.34 has mass M and is weighted...Ch. 12 - An interstellar spacecraft from an advanced...Ch. 12 - Youre called to testify in a product liability...Ch. 12 - Youre designing a vacation cabin at a ski resort....Ch. 12 - Prob. 62PCh. 12 - Engineers designing a new semiconductor device...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...
Additional Science Textbook Solutions
Find more solutions based on key concepts
The pV-diagram of the Carnot cycle.
Sears And Zemansky's University Physics With Modern Physics
3. What is free-fall, and why does it make you weightless? Briefly describe why astronauts are weightless in th...
The Cosmic Perspective
Two parallel conducting plates are separated by 10.0 cm, and one of them is taken to be at zero volts. (a) What...
College Physics
5. Why is it advantageous, in karate, to apply a force for a short time?
Conceptual Physical Science (6th Edition)
Standing at the base of one of the cliffs of Mt. Arapiles in Victoria, Australia, a hiker hears a rock break lo...
University Physics Volume 1
Choose the best answer to each of the following. Explain your reasoning. If we represent the solar system on a ...
Cosmic Perspective Fundamentals
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A uniform L = 6.71 m long horizontal beam that weighs WB= 363N is attached to a wall by a pin connection that allows the beam to rotate. Its far end is supported by a cablewith tension Tthat makes an angle of 50.0° with the horizontal, and a person of weight WP= 427.5N is standing d = 2.38m from the pin. Find the magnitude of the force R exertedon the beam by the wall if the beam is in equilibrium. A)532N B)534N C)536N D)538Narrow_forwardTwo ladders, 4.00 m and 3.00 m long, are hinged at point A and tied together by a horizontal rope 0.90 m above the floor. The ladders weigh 600 N and 450 N, respectively, and the center of gravity of each is at its center. Assume that the floor is freshly waxed and frictionless. (a) Find the upward force at the bottom of each ladder. (b) Find the tension in the rope.arrow_forwardA sign is supported by a uniform horizontal boom of length 3.10 m and weight 72.0 N. A cable, inclined at an angle of 16 °with the boom, is attached at a distance of 2.71 m from the hinge at the wall. The weight of the sign is 108.0 N. What is the tension in the cable and what are the horizontal and vertical forces Fx and Fy exerted on the boom by the hinge? Comment on the magnitude of Fy. T= In N Fx= in N Fy= in N The magnitude of Fy is select (small or large) compared to that of Fx and T.arrow_forward
- A ladder is leaning against a vertical wall, and both ends of the ladder are at the point of slipping. The coefficient of friction between the ladder and the horizontal surface is ?1=0.165 and the coefficient of friction between the ladder and the wall is ?2=0.153 . Determine the maximum angle α with the vertical that the ladder can make without falling on the ground.arrow_forwardA uniform ladder 10.0 m long and weighing 50.0 N rests against a smooth vertical wall. (a) If the ladder is just on the verge of slipping when it makes a 50.0° with the ground, find the coefficient of static friction between the ladder and ground. (b) If the coefficient of static friction is 0.360, and the same ladder makes a angle with respect to the horizontal, how far along the length of 60.0° the ladder can a 65-kg painter climb before the ladder begins to slip?arrow_forwardA uniform horizontal beam with a length of ℓ = 8.00 m and a weight of Wb =200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of φ = 53.0° with the beam (as shown). A person of weight Wp = 600 N stands a distance d = 2.00 m from the wall. Find the tension in the cable as well as the magnitude and direction of the force exerted by the wall on the beam.arrow_forward
- a uniform beam of length 12.0 m is supported by a horizontal cable and a hinge at angle u =50.0°. The tension in the cable is 400 N. In unit-vector notation, what are (a) the gravitational force on the beam and (b) the force on the beam from the hinge?arrow_forwardA 100-N uniform ladder, 8.0 m long, rests against a smooth vertical wall. The coefficient of static friction between ladder and floor is 0.40. What minimum angle can the ladder make with the floor before it slips?arrow_forwardA uniform beam of length L = 11.7 meters and mass of 109.3 kg is pinned at one end and is being supported by a wire as shown. The wire is connected to the beam x = 3.3 meters from the pin. A person of mass 81.6 kg is standing all the way out on the edge of the beam. If θ = 17.3 degrees and φ = 79.4 degrees, what is the tension in the wire?arrow_forward
- Determine the magnitude P of the vertical force required to lift the wheelbarrow free of the ground at point B. The combined weight of the wheelbarrow and its load is 200 lb with center of gravity at G. 11.13 lb 13.11 lb 31.11 lb 33.13 lbarrow_forwardA ladder of uniform density and mass m rests against a frictionless vertical wall, making an angle of 60.0° with the horizontal...arrow_forwardOne end of a 2.00 m uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle θ with the stick. The coefficient of static friction between the end of the meter stick and the wall is 0.530. What is the maximum value that θ can have if the stick is to remainin equilibrium?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
An Introduction to Stress and Strain; Author: The Efficient Engineer;https://www.youtube.com/watch?v=aQf6Q8t1FQE;License: Standard YouTube License, CC-BY