Interpretation:
The energy released when
Concept introduction:
Specific heat is the property of a pure substance. Specific heat is the heat flow required to change the temperature of
Answer to Problem 79E
The energy released when
Explanation of Solution
The specific heat,
Where,
•
•
•
The value of
Where,
•
•
The specific heat of gold
The mass of the gold
The relation between
The probable conversion factors are given below.
The conversion factor to deermine
Therefore, the mass is calculated below.
The value of
The value of
Substitute the value of
Substitute the value of
The relation between
The probable conversion factors are given below.
The conversion factor to determine
Therefore, the amount of energy released is calculated below.
Therefore, the energy released when
The energy released when
Want to see more full solutions like this?
Chapter 15 Solutions
Introductory Chemistry: An Active Learning Approach
- The equation for the fermentation of glucose to alcohol and carbon dioxide is: C6H12O6(aq) 2C2H5OH(aq) + 2CO2(g) The enthalpy change for the reaction is 67 kJ. Is this reaction exothermic or endothermic? Is energy, in the form of heat, absorbed or evolved as the reaction occurs?arrow_forwardHow many kilojoules of heat will be released when exactly 1 mole of iron, Fe, is burned to form Fe2O3(s) at standard state conditions?arrow_forwardHow much heat is absorbed by a 44.7-g piece of leadwhen its temperature increases by 65.4°C?arrow_forward
- A rebreathing gas mask contains potassium superoxide, KO2, which reacts with moisture in the breath to give oxygen. 4KO2(s)+2H2O(l)4KOH(s)+3O2(g) Estimate the grams of potassium superoxide required to supply a persons oxygen needs for one hour. Assume a person requires 1.00 102 kcal of energy for this time period. Further assume that this energy can be equated to the heat of combustion of a quantity of glucose, C6H12O6, to CO2(g) and H2O(l). From the amount of glucose required to give 1.00 102 kcal of heat, calculate the amount of oxygen consumed and hence the amount of KO2 required. The ff0 for glucose(s) is 1273 kJ/mol.arrow_forwardWhat mass of acetylene, C2H2(g), must be burned to produce 3420 kJ of heat, given that its enthalpy of combustion is 1301 kJ/mol? Compare this with the answer to Exercise 5.91 and determine which substance produces more heat per gram.arrow_forwardThe standard enthalpy of formation of solid barium oxide, BaO, is 553.5 kJ/mol, and the standard enthalpy of formation of barium peroxide, BaO2, is 634.3 kJ/mol. (a) Calculate the standard enthalpy change for the following reaction. Is the reaction exothermic or endothermic? 2 BaO2(s) 2 BaO(s) + O2(g) (b) Draw an energy level diagram that shows the relationship between the enthalpy change of the decomposition of BaO2, to BaO and O2, and the enthalpies of formation of BaO2(s) and BaO2(s).arrow_forward
- When one mole of ethylene gas, C2H4, reacts with fluorine gas, hydrogen fluoride and carbon tetrafluoride gases are formed and 2496.7 kJ of heat are given off. What is Hf for CF4(g)?arrow_forwardEnthalpy a A 100.-g sample of water is placed in an insulated container and allowed to come to room temperature at 21C. To heat the water sample to 41C, how much heat must you add to it? b Consider the hypothetical reaction,2X(aq)+Y(l)X2Y(aq)being run in an insulated container that contains 100. g of solution. If the temperature of the solution changes from 21C to 31C, how much heat does the chemical reaction produce? How does this answer compare with that in part a? (You can assume that this solution is so dilute that it has the same heat capacity as pure water.) c If you wanted the temperature of 100. g of this solution to increase from 21C to 51C, how much heat would you have to add to it? (Try to answer this question without using a formula.) d If you had added 0.02 mol of X and 0.01 mol of Y to form the solution in part b, how many moles of X and Y would you need to bring about the temperature change described in part c. e Judging on the basis of your answers so far, what is the enthalpy of the reaction 2X(aq) + Y(l) X2Y(aq)?arrow_forwardA piece of unknown solid substance weighs 437.2 g, and requires 8460 J to increase its temperature from 19.3 °C to 68.9 °C. (a) What is the specific heat of the substance? (b) If it is one of the substances found in Table 5.1, what is its likely identity?arrow_forward
- Using the data in Appendix G, calculate the standard enthalpy change for each of the following reactions: (a) Si(s)+2F2(g)SiF4(g) (b) 2C(s)+2H2(g)+O2(g)CH3CO2H(l) (c) CH4(g)+N2(g)HCN(g)+NH3(g) ; (d) CS2(g)+3Cl2(g)CCl4(g)+S2Cl2(g)arrow_forwardClassify each process as exothermic or endothermic. (a) ice melts (b) gasoline burns (c) steam condenses (d) reactants products, H = 50 kJarrow_forwardInsoluble PbBr2(s) precipitates when solutions of Pb(NO3)2(aq) and NaBr(aq) are mixed. Pb(NO3)2(aq) + 2 NaBr(aq) PbBr2(s) + 2 NaNO3(aq) rH = ? To measure the enthalpy change, 200. mL. of 0.75 M Pb(NO3)2(aq) and 200. mL of 1.5 M NaBr(aq) are mixed in a coffee-cup calorimeter. The temperature of the mixture rises by 2.44 C. Calculate the enthalpy change for the precipitation of PbBr2(s), in kJ/mol. (Assume the density of the solution is 1.0 g/mL., and its specific heat capacity is 4.2 J/g K.)arrow_forward
- Chemistry: Matter and ChangeChemistryISBN:9780078746376Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl WistromPublisher:Glencoe/McGraw-Hill School Pub CoGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStax
- Introductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage LearningWorld of ChemistryChemistryISBN:9780618562763Author:Steven S. ZumdahlPublisher:Houghton Mifflin College DivChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage Learning