PHYSICS:F/SCI.+ENGRS-W/WEBASSIGN
10th Edition
ISBN: 9781337888479
Author: SERWAY
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 19, Problem 25P
Two lightbulbs have cylindrical filaments much greater in length than in diameter. The evacuated bulbs are identical except that one operates at a filament temperature of 2 100°C and the other operates at 2 000°C. (a) Find the ratio of the power emitted by the hotter lightbulb to that emitted by the cooler lightbulb. (b) With the bulbs operating at the same respective temperatures, the cooler lightbulb is to be altered by making its filament thicker so that it emits the same power as the hotter one. By what factor should the radius of this filament be increased?
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Two lightbulbs have cylindrical filaments much greater in length than in diameter. The evacuated bulbs are identical except that one operates at a filament temperature of 2 100°C and the other operates at 2 000°C. (a) Find the ratio of the power emitted by the hotter lightbulb to that emitted by the cooler lightbulb. (b) With the bulbs operating at the same respective temperatures, the cooler lightbulb is to be altered by making its filament thicker so that it emits the same power as the hotter one. By what factor should the radius of this filament be increased?
Assume that the efficiency of the portable solar panel shown in the figure is 19%.(a)(a)What is the amount of solar radiation required to provide rated output power?(b)(b)The camper connects the panel to a hot water heater in a 1L water container in sunlight according to (a). How long does it take to raise the temperature of this water from 1 degree Celsius to 100 degrees Celsius? Suppose there is no heat loss.
To heat a room with dimensions width a=3 m, length b=5 m, height h=2,2 m, approximately an electrical power of P=10 W per square meter is needed. At a cost of 0.2 soles per kW.h, how much will it cost per day to use this heater?
Chapter 19 Solutions
PHYSICS:F/SCI.+ENGRS-W/WEBASSIGN
Ch. 19.2 - Prob. 19.1QQCh. 19.3 - Suppose the same process of adding energy to the...Ch. 19.5 - Prob. 19.3QQCh. 19.5 - Characterize the paths in Figure 19.12 as...Ch. 19.6 - Prob. 19.5QQCh. 19 - Prob. 1PCh. 19 - The highest waterfall in the world is the Salto...Ch. 19 - Prob. 3PCh. 19 - The temperature of a silver bar rises by 10.0C...Ch. 19 - You are working in your kitchen preparing lunch...
Ch. 19 - If water with a mass mk at temperature Tk is...Ch. 19 - An aluminum calorimeter with a mass of 100 g...Ch. 19 - An electric drill with a steel drill bit of mass m...Ch. 19 - A 3.00-g copper coin at 25.0C drops 50.0 m to the...Ch. 19 - How much energy is required to change a 40.0-g ice...Ch. 19 - Prob. 11PCh. 19 - A 3.00-g lead bullet at 30.0C is fired at a speed...Ch. 19 - In an insulated vessel, 250 g of ice at 0C is...Ch. 19 - Prob. 14PCh. 19 - One mole of an ideal gas is warmed slowly so that...Ch. 19 - (a) Determine the work done on a gas that expands...Ch. 19 - A thermodynamic system undergoes a process in...Ch. 19 - Why is the following situation impossible? An...Ch. 19 - A 2.00-mol sample of helium gas initially at 300...Ch. 19 - (a) How much work is done on the steam when 1.00...Ch. 19 - A 1.00-kg block of aluminum is warmed at...Ch. 19 - In Figure P19.22, the change in internal energy of...Ch. 19 - A student is trying to decide what to wear. His...Ch. 19 - A concrete slab is 12.0 cm thick and has an area...Ch. 19 - Two lightbulbs have cylindrical filaments much...Ch. 19 - Prob. 26PCh. 19 - (a) Calculate the R-value of a thermal window made...Ch. 19 - Prob. 28PCh. 19 - Gas in a container is at a pressure of 1.50 atm...Ch. 19 - Prob. 30APCh. 19 - You have a particular interest in automobile...Ch. 19 - You are working in a condensed-matter laboratory...Ch. 19 - Prob. 33APCh. 19 - Prob. 34APCh. 19 - Prob. 35APCh. 19 - Prob. 36APCh. 19 - An ice-cube tray is filled with 75.0 g of water....Ch. 19 - Prob. 38APCh. 19 - An iron plate is held against an iron wheel so...Ch. 19 - One mole of an ideal gas is contained in a...Ch. 19 - Prob. 41APCh. 19 - Prob. 42APCh. 19 - Prob. 43APCh. 19 - A student measures the following data in a...Ch. 19 - (a) The inside of a hollow cylinder is maintained...Ch. 19 - A spherical shell has inner radius 3.00 cm and...Ch. 19 - Prob. 47CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A small electric immersion heater is used to heat 100 g of water for a cup of instant coffee. The heater is labeled “200 watts”. Calculate the time required to bring all this water from 23.0 °C to 100 °C, ignoring any heat losses. Assume specific heat of water is 4.187 J/g-°C.arrow_forwardA cylindrical resistor element on a circuit board dissipates 0.15 W of power in an environment at 40°C. The resistor is 1.2 cm long, and has a diameter of 0.3 cm. Assuming heat to be transferred uniformly from all surfaces, determine the amount of heat this resistor dissipates during a 24 h period;arrow_forwardA 2 ohm heater takes 5 amperes while submerged in 1400 grams of water contained in a vessel with a water equivalent to 100 grams. What is the efficiency of the system if the time required for the temperature to change by 80 degrees celsius is 3.1007 hours.arrow_forward
- A bulb delivers 33 W of radiant energy when its filament is at 1900 °C . If the temperature increases by 100 °C , what is the new rate of energy radiated by this bulb? O 39.51 W 36.11 W O 27.56 W O 40.52 Warrow_forwardAn incandescent lamp filament has area 40 mm and operates at a temperature of 1127°C.Assume that all the energy furnished to the bulb is radiated from it. If the filament's emissivityis 0.83, how much power must be furnished to the bulb when it is operatingarrow_forwardA hot water heater in a residential home runs for an average of 2.5 hours per day with a heat energy input of 4 kW. What would be the annual cost for hot water in this home using a gas hot water heater if the cost of natural gas is $0.38/m3? The gas water heater can get 26 MJ of energy from 1 m3 of natural gas. [round your final answer to zero decimal places]?arrow_forward
- A hot water heater in a residential home runs for an average of 3.2 hours per day with a heat energy input of 3.7 kW. What would be the annual cost for hot water in this home using a gas hot water heater if the cost of natural gas is $0.33/m3? The gas water heater can get 23 MJ of energy from 1 m3 of natural gas. [round your final answer to zero decimal places]?arrow_forwardA technician measures the specific heat of an unidentified liquid by immersing an electrical resistor in it. Electrical energy is converted to heat, which is then transferred to the liquid for 125 s at a constant rate of 67.9 W. The mass of the liquid is 0.770 kg, and its temperature increases from 18.58°C to 22.57° C. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Circuit meltdown. Part A Find the average specific heat of the liquid in this temperature range. Assume that negligible heat is transferred to the container that holds the liquid and that no heat is lost to the surroundings. Express your answer in joules per kilogram per kelvin. V AZO ? C = J/(kg K) Submit Request Answer Part B Suppose that in this experiment heat transfer from the liquid to the container or its surroundings cannot be ignored. Is the result calculated in part (a) an overestimate or an underestimate of the average specific heat? underestimate O overestimatearrow_forwardAt winter design conditions, a house is projected to lose heat at a rate of 60,000 Btu/h. The internal heat gain from people, lights, and appliances is estimated to be 6000 Btu/h. If this house is to be heated by electric resistance heaters, determine the required rated power of these heaters in kW to maintain the house at constant temperature.arrow_forward
- Water flows through a shower head steadily at a rate of 10 L/min. An electric resistance heater placed in the water pipe heats the water from 16 to 43°C. Taking the density of water to be 1 kg/L, determine the electric power input to the heater, in kW. In an effort to conserve energy, it is proposed to pass the drained warm water at a temperature of 39°C through a heat exchanger to preheat the incoming cold water. If the heat exchanger has an effectiveness of 0.50 (i.e., it recovers only half of the energy that can possibly be transferred from the drained water to incoming cold water), determine the electric power input required in this case. If the price of the electric energy is 11.5 ¢/kWh, determine how much money is saved during a 10-min shower as a result of installing this heat exchanger.arrow_forward(a) How much energy is necessary to heat 7.0 kg of water from room temperature (20°C) to its boiling point? (Assume no energy loss.)(b) If electrical energy were used, how much would this cost at 19¢ per kWh?arrow_forwardA 50 liter hot-water tank is used in the laundry service of a hospital clinic. The water in the tank is heated up using an electrical heater that is operated from 200V (mains) power line. The heater draws 8,2 A from the mains. Assume that the thermal resistance of the tank is Rt=0.04 ℃/W. The temperature of the tap water is 10℃. Maximum temperature of the water in the tank in the steady state is …. ?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers, Technology ...
Physics
ISBN:9781305116399
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Heat Transfer: Crash Course Engineering #14; Author: CrashCourse;https://www.youtube.com/watch?v=YK7G6l_K6sA;License: Standard YouTube License, CC-BY