You are working in a condensed-matter laboratory for your senior project. Several of the ongoing projects use liquid helium, which is contained in a thermally insulated vessel that can hold up to a maximum of Vmax = 240 L of the liquid at Tc = 4.20 K. Because some of the liquid helium has already been used, someone asks you to check to see if there is enough for the next day, on which four different experimental groups will need liquid helium. You are not sure how to measure the amount of liquid remaining, so you insert an aluminum rod of length L = 2.00 m and with a cross-sectional area A = 2.50 cm2 into the vessel. By seeing how much of the lower end of the rod is frosted when you pull it out, you can estimate the depth of the liquid helium. After inserting the rod, however, one of the experimenters calls you over to perform a task and you forget about the rod, leaving it in the liquid helium until the next morning. How much liquid helium is available for the next day’s experiments? (Aluminum has thermal
Want to see the full answer?
Check out a sample textbook solutionChapter 19 Solutions
PHYSICS:F/SCI.+ENGRS-W/WEBASSIGN
- A Type K Thermocouple has the hot junction connected to the exhaust gas duct of a steam turbine. The cold junction is at a temperature of 25 ºC. If the potential difference between the hot and the cold junctions is measured to be 6.3 mV, what is the temperature of the ductarrow_forwardA sample of an ideal gas is in a tank of constant volume. The sample gains heat energy and its temperature changes from 300 K to 900 K. If v, is the average speed of the gas molecules before absorption of heat and v2 the average speed after absorption of heat, what is the ratio v2/v, ? A 3/2 B V3 30. D 1/3arrow_forwardA 6.2 L balloon is filled with He at 1.00bar pressure and 298 K. How many He atoms are in the balloon? Answer:arrow_forward
- Suppose a tank contains 521 m³ of neon (Ne) at an absolute pressure of 1.01×105 Pa. The temperature is changed from 293.2 to 294.4 K. What is the increase in the internal energy of the neon?arrow_forwardThe density of gray and white tin are 5.77 × 10³ kg/m³ and 7.37 × 10³ kg/m³. The latent heat for the transition between gray and white tin is 2.20 x 10³ J/mol. The atomic weight of tin is 118.7. Calculate the slope of the tangent of the coexistence curve of gray and white tin at T = 366 K. Select one: dP dT a. b. d. dT dP dP = -15.8 Pa/K = -14.7 atm/K = -13.3 atm/K = -16.6 Pa/Karrow_forwardA copper-constantan thermocouple generates a voltage of 4.75 x 10-3 volts when the temperature of the hot junction is 110 °C and the reference junction is kept at 0 °C. If the voltage is proportional to the difference in temperature between the junctions, what is the temperature in degrees Celsius of the hot junction when the voltage is 2.45 x 10-³ volts? Number i eTextbook and Media GO Tutorial Units ✪arrow_forward
- Problem #1: An ideal gas of initial volume V=1m^3, initial temperature T=1000C and initial pressure P=10,000 Pa is heated up to a final temperature T=3000C and allowed to expand into a final volume V=3m^3. What is the final pressure?arrow_forward*7. 00 A copper-constantan thermocouple generates a voltage of 4.75 x 10- volts when the temperature of the hot junction is 110.0 °C and the refer- ence junction is kept at a temperature of 0.0 °C. If the voltage is propor- tional to the difference in temperature between the junctions, what is the temperature of the hot junction when the voltage is 1.90 × 10-³ volts?arrow_forwardPresents the diagram of the problem, necessary formulas, clearance and numerical solution: A poorly designed electronic device has two screws attached to different parts of the device that almost touch each other inside. steel bolts and brass are at different electrical potentials and if they touch, a short circuit will develop will damage the device. The initial separation between the ends of the screws is 5 μm to 27 ◦C. At what temperature will the screws touch? Assume that the distance between the walls of the device is not affected by temperature change and the coefficient coefficients of linear expansion αlaton = 19x10−6 ◦C −1 and αsteel = 11x10−6 ◦C −1arrow_forward
- Suppose a tank contains 649 m³ of neon (Ne) at an absolute pressure of 1.01×105 Pa. The temperature is changed from 293.2 to 295.9 K. What is the increase in the internal energy of the neon? AU =arrow_forwardAn automobile tire contains 0.038 m² of air at a gauge pressure of 2.41 × 10³ N/m2. The composition of air is about 78% nitrogen (N2) and 21% oxygen (O2), both diatomic molecules. How much more internal energy, in joules, does the air in the tire have than the same volume of air has at zero gauge pressure outside the tire? Emt,2 - Ent,1 Jarrow_forwardA tank of compressed air of volume 1.00 m3 is pressurized to 24.6 atm at T = 273 K. A valve is opened, and air is released until the pressure in the tank is 12.9 atm. How many molecules were released? Boltzmann constant is 1.38 × 10−23 J/K. in moleculesarrow_forward
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning