Concept explainers
(a)
Interpretation:
The number of significant figures that the answer must have for the conversion of
Concept Introduction:
A general-problem solving method in which the units under consideration is associated with numbers and are used as a guide in setting up calculations is known as Dimensional analysis. The units are treated the way the numbers are treated in this method. Three steps has to be followed for the Dimensional analysis and they are,
- The known or given quantity has to be identified that includes both numerical and units. The unit of the new quantity that has to be determined.
- Multiply the known or given quantity by one or more required conversion factors so that the unwanted units are cancelled leaving the desired units only.
- The mathematical operation has to be performed as indicated by the conversion factor setup.
If an exact number is present in the conversion of one unit into another, then the answer obtained will have the same number of significant figures as the measurement. If an inexact number is present in the conversion means, then the answer obtained will have same number of significant figures as in measurements or least number of significant figures as in conversion factor.
(b)
Interpretation:
The number of significant figures that the answer must have for the conversion of
Concept Introduction:
A general-problem solving method in which the units under consideration is associated with numbers and are used as a guide in setting up calculations is known as Dimensional analysis. The units are treated the way the numbers are treated in this method. Three steps has to be followed for the Dimensional analysis and they are,
- The known or given quantity has to be identified that includes both numerical and units. The unit of the new quantity that has to be determined.
- Multiply the known or given quantity by one or more required conversion factors so that the unwanted units are cancelled leaving the desired units only.
- The mathematical operation has to be performed as indicated by the conversion factor setup.
If an exact number is present in the conversion of one unit into another, then the answer obtained will have the same number of significant figures as the measurement. If an inexact number is present in the conversion means, then the answer obtained will have same number of significant figures as in measurements or least number of significant figures as in conversion factor.
(c)
Interpretation:
The number of significant figures that the answer must have for the conversion of
Concept Introduction:
A general-problem solving method in which the units under consideration is associated with numbers and are used as a guide in setting up calculations is known as Dimensional analysis. The units are treated the way the numbers are treated in this method. Three steps has to be followed for the Dimensional analysis and they are,
- The known or given quantity has to be identified that includes both numerical and units. The unit of the new quantity that has to be determined.
- Multiply the known or given quantity by one or more required conversion factors so that the unwanted units are cancelled leaving the desired units only.
- The mathematical operation has to be performed as indicated by the conversion factor setup.
If an exact number is present in the conversion of one unit into another, then the answer obtained will have the same number of significant figures as the measurement. If an inexact number is present in the conversion means, then the answer obtained will have same number of significant figures as in measurements or least number of significant figures as in conversion factor.
(d)
Interpretation:
The number of significant figures that the answer must have for the conversion of
Concept Introduction:
A general-problem solving method in which the units under consideration is associated with numbers and are used as a guide in setting up calculations is known as Dimensional analysis. The units are treated the way the numbers are treated in this method. Three steps has to be followed for the Dimensional analysis and they are,
- The known or given quantity has to be identified that includes both numerical and units. The unit of the new quantity that has to be determined.
- Multiply the known or given quantity by one or more required conversion factors so that the unwanted units are cancelled leaving the desired units only.
- The mathematical operation has to be performed as indicated by the conversion factor setup.
If an exact number is present in the conversion of one unit into another, then the answer obtained will have the same number of significant figures as the measurement. If an inexact number is present in the conversion means, then the answer obtained will have same number of significant figures as in measurements or least number of significant figures as in conversion factor.
Trending nowThis is a popular solution!
Chapter 2 Solutions
EBK GENERAL, ORGANIC, AND BIOLOGICAL CH
- Give an interpretation for the following graph:arrow_forwardPlease explain thoroughly (8 & 9). Step by step. This is an ungraded assignment (which will not be collected but is used for resources like studying).arrow_forwardThe content of calcium in Al-Jabal Al-Akhdar bottled drinking water is 7.9 mg per liter. How many moles of calcium ions are in 330 mL of this water? O a. 0.065 mol O b. 6.5x10-5 mol O c. 3.9 x10-19 mol O d. 2.0x10-4 mol O e. 0.20 molarrow_forward
- Which of the following setups would give the formula mass of Ca(PO3)2 in amu? 40.08 amu + 30.97 amu + 3(16.00 amu) 40.08 amu + 2(30.97 amu + 3(16.00 amu)) 40.08 amu + 30.97 amu + 6(16.00 amu) 40.08 amu + 2(30.97 amu) + 3(16.00 amu)arrow_forwardNote: Reference the Conversion factors for non-SI units and SI prefixes tables for additional Information. Part 1 of 2 4240. kl to cal. Be sure your answer has the correct number of significant figures. cal xarrow_forwardAccording to Aristotle’s density equation, if 3.161 grams of the sugar sucrose (C12H22O11) occupies a volume of 2.0 cubic centimeters, then sucrose must have a density of: 0.6327 grams/cm3 B. 1.5805 grams/cm3 2.322 grams/cm3 10.322 grams/cm3 25.288 grams/cm3arrow_forward
- A physician prescribes a prescription of Doriden, 325 mg, which requires you to prepare 30 capsules to be taken by a patient 1 hour before bedtime. Assuming that you will make a minimum of extra powder, how many tablets will you use to make this prescription? How many capsules will you calculate for? (Doriden is available in your pharmacy as a 500 mg tablet weighing 750 mg) Select one: a. 20 tablets, 30.77 capsules b. 19 tablets, 30 capsules c. 19 tablets, 32 capsules d. 20 tablets, 40 capsules What is the weight in grams of 1 Liter of alcohol (density, 0.816 g/mL? O O Oarrow_forwardConvert your data to the following units, please show how you got the answer 6.5g to kilogram (kg)arrow_forwardA friend breeds giant racing Rhosgobel rabbits. She is seeking your advice on how to breed faster rabbits. As per your request, she compared the mid-parent and mid-offspring running speeds. Look at the graph to the below, which of the following statements provides accurate information to your friend. 16 y = 0.0453x + 8.3165 R2 = 0.0028 14 12 10 10 15 20 Midoffspring running speed (m/s) O a. The slower rabbits will produce faster offspring than the faster rabbits in the current generation. O b.If your friend selectively breeds her fastest rabbits, you expect the next generation to be significantly faster. OC. The best way to increase running speed in the next generation would be to alter the environment, maybe increasing nutrient density of the food. O d. There is a higher degree of heritability in other populations of Rhosgobel rabbits. Midparent running speed (s/w)arrow_forward
- 1) What is the prefix that is used when we are expressing 1/1000 of the unit? 2) What is the unit of measurement for volume? 3) How many grams (g) are in 200 micrograms (ug)? 4) There are 2.54 cm in an inch. There are 12 inches in a foot. Calculate the height of a 6-foot 11-inch person in meters. 5) How many micrograms (ug) does 1 ul of water weigh? 6) Convert the following numbers: a. 1 ul = ml b. 1.534 cm = mm c. 46.8 ul = dl d. 6.9732 ug = kg 7) A drug is given at a dosage of 25 mg / kg body weight. a. Convert this dosage to ug per kg (ug/kg). b. How many ug of the drug in question a should be administered to a person who weighs 77 kg? 8) At rest the left ventricle of the heart pumps 5.0 liters of blood per minute (this is known as the cardiac output). Blood flow to the kidneys is approximately 1,220 ml per min at rest. a. What percentage (%) of the cardiac output do the kidneys receive at rest? b. Assume that the kidneys will receive the same percent of the cardiac output that was…arrow_forwardUsing the figure, answer the following questions.a. What is the molar composition of the vapor in equilibrium with a boilingliquid that has a composition of 60% A and 40% B?b. A sample of vapor has the composition 50% A and 50% B. What is the composition of the boiling liquid that produced this vapor?arrow_forwardSvedberg units direct correspond to molecular weight. True Falsearrow_forward
- Nutrition Through The Life CycleHealth & NutritionISBN:9781337919333Author:Brown, Judith E.Publisher:Cengage Learning,Cardiopulmonary Anatomy & PhysiologyBiologyISBN:9781337794909Author:Des Jardins, Terry.Publisher:Cengage Learning,