A cylindrical tungsten filament 15.0 cm long with a diameter of 1.00 mm is to the used in a machine for which the temperature will range from room temperature (20°C) up to 120°C. It will carry a current of 12.5 A at all temperatures (consult Tables 25.1 and 25.2). (a) What will be the maximum electric field in this filament, and (b) what will be its resistance with that field? (c) What will be the maximum potential drop over the full length of the filament?
Want to see the full answer?
Check out a sample textbook solutionChapter 25 Solutions
University Physics with Modern Physics, Volume 1 (Chs. 1-20) and Mastering Physics with Pearson eText & ValuePack Access Card (14th Edition)
Additional Science Textbook Solutions
University Physics (14th Edition)
College Physics
The Cosmic Perspective Fundamentals (2nd Edition)
Essential University Physics: Volume 2 (3rd Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Essential University Physics: Volume 1 (3rd Edition)
- A potential difference of 1.00 V is maintained across a 10.0- resistor for a period of 20.0 s. What total charge passes by a point in one of the wires connected to the resistor in this time interval? (a) 200 C (b) 20.0 C (c) 2.00 C (d) 0.005 00 C (e) 0.050 0 Carrow_forwardThe student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71arrow_forwardIn the figure R1 - 4.78 0, R2 - 14.3 0, and the ideal battery has emf e - 11.8 V. (a) What is the magnitude of current i,? (b) How much energy is dissipated by all four resistors in 0.817 min? (a) Number i 0.41 Units A (b) Number 714.96 Unitsarrow_forward
- (a) A well-insulated electric water heater warms 125 kg of water from 20.0°C to 53.0°C in 33.0 min. Find the resistance (in Q2) of its heating element, which is connected across a 240 V potential difference. Ω (b) What If? How much additional time (in min) would it take the heater to raise the temperature of the water from 53.0°C to 100°C? min (c) What would be the total amount of time (in min) required to evaporate all of the water in the heater starting from 20.0°C? minarrow_forwardYour answer is partially correct. In the figure R1 = 4.31 0, R2 = 12.9 0, and the ideal battery has emf ɛ = 12.6 V. (a) What is the magnitude of current i? (b) How much energy is dissipated by all four resistors in 0.958 min? ww R R2 (a) Number i 0.424 Units A (b) Number i 2009.28 Units Jarrow_forwardWhale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a distance of 20 miles. A power link is to be established between them. The power link delivers a maximum power of 600 MW at full capacity with an operating voltage of 500 kV. Solve for the resistivity of the cable, assuming a conductor diameter of 1.5 cm. Express your answer in p0-m.arrow_forward
- A solar cell generates a potential difference of 0.17 V when a 550 resistor is connected across it, and a potential difference of 0.24 V when a 970 resistor is substituted. What are the (a) internal resistance and (b) emf of the solar cell? (c) The area of the cell is 1.2 cm² and the rate per unit area at which it receives energy from light is 4.9 mW/cm². What is the efficiency of the cell for converting light energy to thermal energy in the 970 2 external resistor? (a) Number (b) Number (c) Number i Units Units Units Ω V perarrow_forwardSuppose you have a rod of pure silicon with a diameter of 2.79cm and a length of 20.6cm. These rods are often used in experiments, such as the Large Hadron Collider in France/Switzerland to detect high-energy particles, and they have a very high resistivity of 2300Ω⋅m. What current, in amperes, flows through the rod when a potential difference of 1.23* 10^3 V is applied between its ends ?arrow_forwardIn the figure R1 = 6.53 Q, R2 = 19.6 Q, and the ideal battery has emf ɛ = 11.0 V. (a) What is the magnitude of current iq? (b) How much energy is dissipated by all four resistors in 2.21 min? R R2 ww R R2 ww (a) Number i Units (b) Number i Unitsarrow_forward
- A 12.0 V emf automobile battery has a terminal voltage of 14.0 V when being charged by a current of 10.8 A. a) What is the battery's internal resistance (in Ω)? b) What power (in W) is dissipated inside the battery? c) At what rate (in °C/min) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.360 kcal/(kg · °C), assuming no heat escapes?arrow_forwardWhale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a distance of 20 miles. A power link is to be established between them. The power link delivers a maximum power of 600 MW at full capacity with an operating voltage of 500 kV. Solve for the resistivity of the cable, assuming a conductor diameter of 1.5 cm. Express your answer in uQ-m.arrow_forwardCurrents of approximately 0.06 A can be potentially fatal. Currents in that range can make the heart fibrillate (beat in an uncontrolled manner). The resistance of a dry human body can be approximately 100 k Ω . (a) What voltage can cause 0.06 A through a dry human body? (b) When a human body is wet, the resistance can fall to 100 Ω . What voltage can cause harm to a wet body?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning