Principles of Instrumental Analysis, 6th Edition
6th Edition
ISBN: 9788131525579
Author: Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher: Cenage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 27, Problem 27.24QAP
Interpretation Introduction
Interpretation:
The reason and the change in the retention times for the three compounds is to be stated.
Concept introduction:
Retention time is the amount of time that arises in between the sample introduction and the maximum of the response. It is the time taken by the solute to completely pass through the column. The retention time is less for non-polar solvents, whereas it is relatively large for polar solvents.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
(c) What is the minimum distribution ratio that permits removal of 99% of a solute from 50.0 mL of water with (i) two 20.0-mL extractions with an organic solvent; (ii) four 10.0-mL extractions with the organic solvent?
What is the minimum distribution constant that permits removal of 99% of a solute from 50.0 mL of water with five 10.0-mL extractions with toluene?
What is the minimum distribution constant that permits removal of 99% of a solute from 50.0 mL of water with
two 25.0-mL extractions with toluene?
five 10.0-mL extractions with toluene?
Chapter 27 Solutions
Principles of Instrumental Analysis, 6th Edition
Ch. 27 - Prob. 27.1QAPCh. 27 - Prob. 27.2QAPCh. 27 - Prob. 27.3QAPCh. 27 - Prob. 27.4QAPCh. 27 - Prob. 27.5QAPCh. 27 - Prob. 27.6QAPCh. 27 - Prob. 27.7QAPCh. 27 - Prob. 27.8QAPCh. 27 - Prob. 27.9QAPCh. 27 - What are hyphenated GC methods? Briefly describe...
Ch. 27 - Prob. 27.11QAPCh. 27 - Prob. 27.12QAPCh. 27 - Prob. 27.13QAPCh. 27 - Prob. 27.14QAPCh. 27 - Prob. 27.15QAPCh. 27 - Prob. 27.16QAPCh. 27 - Prob. 27.17QAPCh. 27 - Prob. 27.18QAPCh. 27 - Prob. 27.19QAPCh. 27 - The same polar compound is gas chromatographed on...Ch. 27 - Prob. 27.21QAPCh. 27 - Prob. 27.22QAPCh. 27 - Prob. 27.23QAPCh. 27 - Prob. 27.24QAPCh. 27 - Prob. 27.25QAPCh. 27 - Prob. 27.26QAPCh. 27 - Prob. 27.27QAPCh. 27 - Prob. 27.28QAPCh. 27 - Why is GSC not used nearly as extensively as GLC?Ch. 27 - Prob. 27.30QAP
Knowledge Booster
Similar questions
- The molar mass of an enzyme was determined by dissolving it in water, and measuring the height, h, of the resulting solution drawn up a capillary tube at 20 °C. The following data were obtained.C/(mg cm-3) 3.221 4.618 5.112 6.722h/cm 5.746 8.238 9.119 11.990The osmotic pressure may be calculated from the height of the column, ∏= hpg, taking the mass density of the solution as p = 1.000 g cm-3 and the acceleration of free fall as g = 9.81 m s-2. Determine the molar mass of the enzyme.arrow_forwardWhat is the strength of the ionic interactions between an ion with 1 positive charges and an ion with 2 negative charges, when the distance between them is 32.5 nanometers and the solvent is water, at 25 oC with a dielectric constant of 78.5? Calculate answer to 7 decimal places.specify units in the answer. Thank you very much for your assistance.arrow_forwardIn a reverse-phase separation, a solute was found to have a retention time of 19.6 min, while an unretained peak had a retention time of 1.45 min when the mobile phase was 20/80 v/v% methanol/water. (b) Calculate the k’ for the solute. (c) Calculate the new k’ if the mobile phase is changed to 60/40 methanol/water assuming identical void volume. (d) Calculate a solvent composition that would bring k’ from initial value to a value of 1.20 using tetrahydrofuran/water mobile phase rather than 20/80 v/v % methanol/water.arrow_forward
- 16) Which of the following(s) is/are correct? I- Selectivity factor is the amount of time a solute spends in the stationary phase relative to the time it spends in mobile phase II- The retention time for an analyte is the time interval between its injection onto a column and its appearance at the detector at the other end of the column. III- Distribution constant is the ratio of the total solute concentration in the stationary phase to that in the mobile phase. A) I, II and III B) Only II C) I and III D) II and III E) Only III for GC2arrow_forward4.columns with one million theoretical plates operating by slip flow. The figure shows the gradient separation of two forms of fluorescently labeled bovine serum albumin separated on a)50 x 2.1 mm UHPLC column of 1.7 µm C4 silica particles and b)10 mm x 75µm colloidal crystal column of 470 nm C4 silica nanoparticles. What are the main differences in the chromatogram? What is the reason for the difference? Why does the colloidal crystal column have such a high number of theoretical plates (N)? How is the problem of high pressures with very small particles overcome?arrow_forwardA student performed the fractional distillation of a cyclohexane/toluene mixture. The refractive index of the distillate was measured at 1.4301 with an ambient temperature of 22.0oC. What is the mole percentage of cyclohexane (to 3 sf)?arrow_forward
- Describe the differences between a Stober procedure and a water/oil emulsion procedure for the synthesis of colloidal silica particles.arrow_forward7 How is the variation in sample composition in a powder random mix influenced by the proportion of active ingredient particles and by the total number of particles in the sample?arrow_forward6. When we look at the retention times of the capsaicin and dihydrocapsaicin, they are about a half minute apart. Which of the compounds has a greater attraction to the column vs the mobile phase of 80:20 methanol-water.arrow_forward
- Describe the distillation of partial miscible liquid in terms of phase diagram.arrow_forward7. Draw the structure of ethyl acetate and propyl acetate. Which substance is expected to have the shortest retention time and therefore elute first? Explain your reasoning. esnyi acefate Iyrlte to sTutxim 0a\0A 9rt 169ri of 19mud nen8 6 szu 9w n .d bLobscestearrow_forwardThe liquid-liquid extraction is the classical technique in chemistry to isolate a target component from a mixture. Organic Solvent is the usual solvent being used along with water. TRUE or FALSEarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning
Physical ChemistryChemistryISBN:9781133958437Author:Ball, David W. (david Warren), BAER, TomasPublisher:Wadsworth Cengage Learning,
Principles of Instrumental Analysis
Chemistry
ISBN:9781305577213
Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher:Cengage Learning
Physical Chemistry
Chemistry
ISBN:9781133958437
Author:Ball, David W. (david Warren), BAER, Tomas
Publisher:Wadsworth Cengage Learning,