Concept explainers
(a)
The magnitude and direction of the magnetic field at point
(a)
Answer to Problem 76PQ
The magnitude of magnetic field at point
Explanation of Solution
Write the expression for the magnetic field due to a current carrying wire as.
Here,
The direction of magnetic field on the point is given by the Right hand rule. When thumb is kept in the direction of the current then the direction of curling of the finger gives the direction of the magnetic field at that point.
The magnetic field on the point
Write the expression for the net field at the point
Here,
Conclusion:
Substitute
Substitute
Substitute
Thus, the magnitude of magnetic field at point
(b)
The magnitude and direction of the magnetic field at point
(b)
Answer to Problem 76PQ
The magnitude of magnetic field at point
Explanation of Solution
The magnetic field due to a current carrying wire is given by.
Here,
The direction of magnetic field on the point is given by the simple Right hand rule. When the thumb is kept in the direction of the current and the palm faces the point then the direction of curling of the finger gives the direction of the magnetic field at that point.
The magnetic field on the point
The field
The net field at the point
Here,
The direction of the magnetic field at point B is,
Conclusion:
Substitute
Substitute
The net field at point B is resolved into following components.
Substitute
Substitute
Substitute
Thus, the magnitude of magnetic field at point
Want to see more full solutions like this?
Chapter 30 Solutions
Physics For Scientists And Engineers: Foundations And Connections, Advance Edition, Volume 1
- Two infinitely long current-carrying wires run parallel in the xy plane and are each a distance d = 11.0 cm from the y axis (Fig. P30.83). The current in both wires is I = 5.00 A in the negative y direction. a. Draw a sketch of the magnetic field pattern in the xz plane due to the two wires. What is the magnitude of the magnetic field due to the two wires b. at the origin and c. as a function of z along the z axis, at x = y = 0? FIGURE P30.83arrow_forwardFigure P30.10 shows a circular current-carrying wire. Using the coordinate system indicated (with the z axis out of the page), state the direction of the magnetic field at points A and B.arrow_forwardA circular coil 15.0 cm in radius and composed of 145 tightly wound turns carries a current of 2.50 A in the counterclockwise direction, where the plane of the coil makes an angle of 15.0 with the y axis (Fig. P30.73). The coil is free to rotate about the z axis and is placed in a region with a uniform magnetic field given by B=1.35jT. a. What is the magnitude of the magnetic torque on the coil? b. In what direction will the coil rotate? FIGURE P30.73arrow_forward
- A uniform magnetic field B=5.44104iT passes through a closed surface with a slanted top as shown in Figure P31.59. a. Given the dimensions and orientation of the closed surface shown, what is the magnetic flux through the slanted top of the surface? b. What is the net magnetic flux through the entire closed surface?arrow_forwardOne common type of cosmic ray is a proton traveling at close to the speed of light. If the proton is traveling downward, as shown in Figure P30.14, at a speed of 1.00 107 m/s, what are the magnitude and direction of the magnetic field at point B?arrow_forwardA toroid has a major radius R and a minor radius r and is tightly wound with N turns of wire on a hollow cardboard torus. Figure P31.6 shows half of this toroid, allowing us to see its cross section. If R r, the magnetic field in the region enclosed by the wire is essentially the same as the magnetic field of a solenoid that has been bent into a large circle of radius R. Modeling the field as the uniform field of a long solenoid, show that the inductance of such a toroid is approximately L=120N2r2R Figure P31.6arrow_forward
- A wire is bent in the form of a square loop with sides of length L (Fig. P30.24). If a steady current I flows in the loop, determine the magnitude of the magnetic field at point P in the center of the square. FIGURE P30.24arrow_forwardFor both sketches in Figure P30.56, there is a 3.54-A current, a magnetic field strength B 0.650 T. and the angle is 32.0. Find the magnetic force per unit length (magnitude and direction) exerted on the current-carrying conductor in both cases.arrow_forwardA Derive an expression for the magnetic field produced at point P due to the current-carrying wire shown in Figure P30.26. The curved parts of the wire are pieces of concentric circles. Point P is at their center.arrow_forward
- A strong magnet is placed under a horizontal conducting ring of radius r that carries current I as shown in Figure P28.27. If the magnetic field B makes an angle with the vertical at the rings location, what are (a) the magnitude and (b) the direction of the resultant magnetic force on the ring? Figure P28.27arrow_forwardA cube of edge length l=2.50 cm is positioned as shown in Figure P30.47. A uniform magnetic field given by B = (5 i + 4j + 3k) T exists throughout the region. (a) Calculate the magnetic flux through the shaded face. (b) What is the total flux through the six faces?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning