(a)
Interpretation:
The name of a laser diffraction instrument, its operation and uses is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique. Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles. soil and its steadiness when wet.
Answer to Problem 34.15QAP
The instrument Partica LA-950 Laser Diffraction Particle size Distribution Analyzer. is built up by Horiba. Have very close tolerances. It is quite automatic in terms of functioning. The accuracy of the instrument is
Explanation of Solution
There is a instrument in the market developed by the company Horiba named as Partica LA-950 Laser Diffraction Particle size Distribution Analyzer.
The material for which test has to be performed, placed in the sample cell. The two laser beams, depending upon the size of the test sample are scattered at an angle. This angle is proportional to the particle size. The scattered light is detected by the photodiode.
The software which controls the instrument correlates the scattered light with particle size.
The instrument is consisting of
(b)
Interpretation:
The range of particle size which instrument can measure is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique. Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles. soil and its steadiness when wet.
Answer to Problem 34.15QAP
The instrument can measure particle size from
Explanation of Solution
The instrument has wide range of measurement of particle size. The range of the instrument is
(c)
Interpretation:
The sampling accessories of Partica LA-950 Laser Diffraction Particle size Distribution Analyzeris to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique.Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles. soil and its steadiness when wet.
Answer to Problem 34.15QAP
The instrument has powder jet dry feeder, miniflow and slurry sampler as the accessories.
Explanation of Solution
The sampling accessories are used for preparation of sample. They had pre-defined dimensions of sample like particle size etc. In the Partica LA-950 Laser Diffraction Particle size Distribution Analyzer there are following sampling accessories are available.
- Powder jet dry feeder
- Miniflow
- Slurry sampler
(d)
Interpretation:
The size of the Partica LA-950 Laser Diffraction Particle size Distribution Analyzer is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique.Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles. soil and its steadiness when wet.
Answer to Problem 34.15QAP
The dimensions of Partica LA-950 Laser Diffraction Particle size Distribution Analyzer is
Explanation of Solution
The size of the instrument is small comparatively.The dimensions of Partica LA-950 Laser Diffraction Particle size Distribution Analyzer is
(e)
Interpretation:
The model used by the software for measurement of particle size is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique.Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles. soil and its steadiness when wet.
Answer to Problem 34.15QAP
The models followed for analysis of particle size are as mentioned below.
- Mie scattering theory
- Fraunhofer diffraction theory
Explanation of Solution
The software helps to correlate the particle size with the scattering angle. There are numerous models available for analysis of particle size. The Partica LA-950 Laser Diffraction Particle size Distribution Analyzer uses the following two models based on the following theories.
- Mie scattering theory
- Fraunhofer diffraction theory
(f)
Interpretation:
The method of automation of particle size analysis is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique.Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles soil and its steadiness when wet.
Answer to Problem 34.15QAP
The method of automation of particle size analysis is fully automated.
Explanation of Solution
The automated analysis makes the particle size measurement more accurate. The Partica LA-950 Laser Diffraction Particle size Distribution Analyzer has auto sampler and built in automation. The slurry sampler is also there which is equipped with a robotic arm sampling system. Therefore in this instrument the analysis of particle size is fully automated.
(g)
Interpretation:
The research paper in which technique of laser diffraction is used for determination of particle size is to be stated.
Concept introduction:
The size of particle is measured by laser diffraction technique.Laser diffraction investigation is utilized here to contrast molecule size dispersions with the help in this case just as discover cycles of progress in estuaries that happen due to various particles soil and its steadiness when wet.
Answer to Problem 34.15QAP
In the paper G.Eshel, et al “2 Critical Evaluation of the use of Laser Diffraction for Particle size distribution Analysis” Soil Sci.Soc. Am. J.
Explanation of Solution
The reference of the paper in the literature is given below
G.Eshel, et al “2 Critical Evaluation of the use of Laser Diffraction for Particle size distribution Analysis” Soil Sci.Soc. Am. J.
In this work the relation between the particle size distribution obtained by the combined sieve-pipette method and similar obtained with laser diffraction method was studied. They used Beckam-Coutler LS-230.
Two different particle sizes were analysed. One set has shown good correlation and another set has shown poor correlation.
Want to see more full solutions like this?
Chapter 34 Solutions
PRINCIPLES OF INSTRUMENTAL ANALYSIS
- The validation process comprises four main steps that are : hardware validation, software validation, method validation and system suitability. To evaluate a spectrophotometer’s accuracy by measuring absorbance, a solution of 60.06 mg/L K2Cr2O7 in 0.0050M H2SO4 was carefully prepared together with a 0.0050 M H2SO4 as a reagent blank. If the spectrometer’s signal is properly calibrated, it has been reported that this solution should provide an absorbance of 0.640 +- 0.010 at wavelength 350 nm. Which one of the validations mentioned above had been involved in this process? Explain your choicearrow_forwardBased on the picture i) Calculate the limit of detection (LOD) and limit of quantitation (LOQ) for As. ii) Determine the dynamic range of the method. iii) A sample of water yielded an absorbance of 0.36. What is the concentration of As in the water?arrow_forwardSuppose a student is preparing a set of standard solutions for use in a spectrophotometric study. If percent transmittance, %T, were measured in the standard solutions before the color had a chance to fully develop, the measured value would be compared with solutions that have allowed the color to fully develop.arrow_forward
- (i) Write the specific type of instrument as shown in figure 1.? (ii) How are the ions produced in the ionization chamber accelerated? (iii) What two properties of the ions determine how much they are deflected by the magnetic field? (iv) Why is it important that there is a vacuum in the instrument? Storage chamber Gas inlet Manometer To vacuum lonising ´electron beam Collector Resolving slit Molecular- leak lon source 60° Oscillograph Accelerating - region DC |amplifier uhl Mass Magnet Analyser tube spectrographarrow_forwardWhen opening the cover of an analytical detector, which optical elements can help us to differentiate whether the instrument is a spectrofluorometer or a UV-Vis spectrophotometer. Justify your answer:arrow_forwarddetector Answer Bank emission monochromator excitation monochromator light source sample cell ^ex A em It is typically a grating, prism, or filter that selects a narrow wavelength band of radiation and passes it to the sample. It holds the sample and has a defined pathlength. It is typically a photomultiplier tube that generates an electric signal when struck by photons. It is positioned 90° to the incident light and selects a narrow wavelength band of radiation to pass toarrow_forward
- Please don't provide handwritten solution ....arrow_forwardPlease answer these questions!!arrow_forward5. How do you calculate the Numerical aperture of an Optic fiber? Find the numerical aperture '0' of a 1.5m plastic optical fiber, if the distance from tip to surface is 5cm and the light radius is 3.5cm?arrow_forward
- What are the main components of a spectrophotometer? Choose all that applies. radiation source sample compartment/holder monochromator detectorarrow_forward0.1040 g of a solid sample containing copper was dissolved by acid and transferred to a 250.00 mL volumetric flask and volume was made up with distilled water. The solution was then diluted by a factor of 20. The final solution was analyzed by atomic absorption spectrophotometry and the concentration was found be 3.109 ppm, What is the weight percentage of copper in the original solid sample? Keep four significant figures in your final answer. Do not try to include the "%" in your answer. e.g. if your final answer is 10.01%, only write 10.01 in the box.arrow_forwardMatch the items in the left-hand column to the items in the right-hand column by writing the appropriate letter in the blank. Each is used only once. (a) The intensity of light after having passed through a solution of an absorbing species. (b) A = abc (c) Molar absorptivity (d) Pathlength (c) I/I, (f) -log T _T Beer's law (g) The intensity of light after having passed through a blank solution. %T (h) Absorptivity (i) T × 100arrow_forward
- Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning