Concept explainers
(a)
Interpretation:
The transferred heat has to be calculated.
Concept Introduction:
Specific heat can be defined as quantity of heat required to raise the temperature of
Where
C is the Specific heat
(a)
Answer to Problem 67QRT
The heat transferred value is
Explanation of Solution
Mixing of two given solutions with change in temperature, the heat transferred is determined as follows,
The solution mass obtained by adding the two volumes is calculated as follows,
The heat transferred is calculated as shown below,
(b)
Interpretation:
The thermochemical expression has to be identified.
Concept Introduction:
The balanced chemical equation that also defines the enthalpy change is called thermochemical equation.
(b)
Answer to Problem 67QRT
The thermochemical expression is
Explanation of Solution
Addition of given acid and base will result in neutralization reaction as follows,
The acid moles and base moles consumed are determined by considering molarity and volume of the solution.
The reaction is carried under constant pressure conditions hence,
Hence, the thermochemical expression is obtained as follows,
Want to see more full solutions like this?
Chapter 4 Solutions
EBK CHEMISTRY: THE MOLECULAR SCIENCE
- A piece of lead of mass 121.6 g was heated by an electrical coil. From the resistance of the coil, the current, and the Time the current flowed, it was calculated that 235 J of heat was added to the lead. The temperature of the lead rose from 20.4C to 35.5C. What is the specific heat of the lead?arrow_forwardWhen solid iron burns in oxygen gas (at constant pressure) to produce Fe2O3(s), 1651 kJ of heat is released for every 4 mol of iron burned. How much heat is released when 10.3 g Fe2O3(s) is produced (at constant pressure)? What additional information would you need to calculate the heat released to produce this much Fe2O3(s) if you burned iron in ozone gas, O3(g), instead of O2(g)?arrow_forwardA 50-mL solution of a dilute AgNO3 solution is added to 100 mL of a base solution in a coffee-cup calorimeter. As Ag2O(s) precipitates, the temperature of the solution increases from 23.78 C to 25.19 C. Assuming that the mixture has the same specific heat as water and a mass of 150 g, calculate the heat q. Is the precipitation reaction exothermic or endothermic?arrow_forward
- How much heat is absorbed by a 44.7-g piece of leadwhen its temperature increases by 65.4°C?arrow_forwardThe temperature of the cooling water as it leaves the hot engine of an automobile is 240 F. After it passes through the radiator it has a temperature of 175 F. Calculate the amount of heat transferred from the engine to the surroundings by one gallon of water with a specific heat of 4.184 J/g oC.arrow_forwardInsoluble PbBr2(s) precipitates when solutions of Pb(NO3)2(aq) and NaBr(aq) are mixed. Pb(NO3)2(aq) + 2 NaBr(aq) PbBr2(s) + 2 NaNO3(aq) rH = ? To measure the enthalpy change, 200. mL. of 0.75 M Pb(NO3)2(aq) and 200. mL of 1.5 M NaBr(aq) are mixed in a coffee-cup calorimeter. The temperature of the mixture rises by 2.44 C. Calculate the enthalpy change for the precipitation of PbBr2(s), in kJ/mol. (Assume the density of the solution is 1.0 g/mL., and its specific heat capacity is 4.2 J/g K.)arrow_forward
- Sulfur dioxide gas reacts with oxygen, O2(g), to produce SO3(g). This reaction releases 99.0 kJ of heat (at constant pressure) for each mole of sulfur dioxide that reacts. Write the thermochemical equation for the reaction of 2 mol of sulfur dioxide, and then also for the decomposition of 3 mol of sulfur trioxide gas into oxygen gas and sulfur dioxide gas. Do you need any other information to answer either question?arrow_forwardExplain the difference between heat capacity and specific heat of a substance.arrow_forwardA sample of sucrose, C12H22O11, is contaminated by sodium chloride. When the contaminated sample is burned in a bomb calorimeter, sodium chloride does not burn. What is the percentage of sucrose in the sample if a temperature increase of 1.67C is observed when 3.000 g of the sample are burned in the calorimeter? Sucrose gives off 5.64103kJ/mol when burned. The heat capacity of the calorimeter and water is 22.51 kJ/C.arrow_forward
- Chemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- General Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStax