Connect with LearnSmart for Anderson: Fundamentals of Aerodynamics, 6e
6th Edition
ISBN: 9781259683268
Author: Anderson, John
Publisher: Mcgraw-hill Higher Education (us)
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 5, Problem 5.6P
Consider a finite wing with an aspect ratio of 6. Assume an elliptical lift distribution. The lift slope for the airfoil section is 0.1/degree. Calculate and compare the lift slopes for (a) a straight wing, and (b) a swept wing, with a half-chord line sweep of 45 degrees.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Consider a finite wing with an aspect ratio of 3. Assume an elliptical liftdistribution. The lift slope for the airfoil section is 0.1/degree. Calculateand compare the lift slopes for (a) a straight wing, and (b) a swept wing,with a half-chord line sweep of 45 degrees.
For the NACA 2412 airfoil, the lift coefficient and moment coefficient about the
quarter-chord at -6° angle of attack are -0.39 and -0.045, respectively. At 4°
angle of attack, these coefficients are 0.65 and -0.037, respectively. Calculate
the location of the aerodynamic center.
-
Consider a finite wing with an aspect ratio of 5. Assume an elliptical lift distribution. The lift slope for the airfoil section is
0.1/degree.
Calculate the lift slope (in 1/rad) for a swept wing, with a half-chord line sweep of 45 degrees. (Round the final answer to three decimal
places.)
The lift slope is
per radian.
Chapter 5 Solutions
Connect with LearnSmart for Anderson: Fundamentals of Aerodynamics, 6e
Ch. 5 - Consider a vortex filament of strength in the...Ch. 5 - Consider the same vortex filament as in Problem...Ch. 5 - The measured lift slope for the NACA 23012 airfoil...Ch. 5 - The Piper Cherokee (a light, single-engine general...Ch. 5 - Consider the airplane and flight conditions given...Ch. 5 - Consider a finite wing with an aspect ratio of 6....Ch. 5 - Repeat Problem 5.6, except for a lower aspect...Ch. 5 - In Problem 1.19 we noted that the Wright brothers,...Ch. 5 - Consider the Superrnarine Spitfire shown in Figure...Ch. 5 - If the elliptical wing of the Spitfire in Problem...
Additional Engineering Textbook Solutions
Find more solutions based on key concepts
Comprehension Check 7-14
The power absorbed by a resistor can be given by P = I2R, where P is power in units of...
Thinking Like an Engineer: An Active Learning Approach (3rd Edition)
23.23 A highly oxidized and uneven round bar is being turned on a lathe. Would you recommend a small or a large...
Manufacturing Engineering & Technology
A 20-lb force is applied to the control rod AB as shown. Knowing that the length of the rod is 9 in. and that t...
Statics and Mechanics of Materials
Locate the centroid of the area. Prob. 9-17
Engineering Mechanics: Statics
The moment of inertia Iy for the slender rod in terms of the rod’s total mass m .
Engineering Mechanics: Statics & Dynamics (14th Edition)
A pipe flowing light oil has a manometer attached, as shown in Fig, P1.52. What is the absolute pressure in pip...
Fundamentals Of Thermodynamics
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Consider a finite wing with an aspect ratio of 5. Assume an elliptical lift distribution. The lift slope for the airfoil section is 0.1/degree. Identify the correct statement about the lift slopes for the straight wing and the swept wing with a half-chord line sweep of 45 degrees. Multiple Choice A swept wing with a half-chord line sweep of 45 degrees has a slightly more lift slope than a straight wing. A swept wing with a half-chord line sweep of 45 degrees has a substantially more lift slope than a straight wing. A swept wing with a half-chord line sweep of 45 degrees has a slightly less lift slope than a straight wing. A swept wing with a half-chord line sweep of 45 degrees has a substantially less lift slope than a straight wing.arrow_forwardConsider a finite wing with an aspect ratio of 5. Assume an elliptical lift distribution. The lift slope for the airfoil section is 0.1/degree. Calculate the lift slope (in 1/rad) for a straight wing. (Round the final answer to three decimal places.) The lift slope for a straight wing is per radian.arrow_forwardConsider a thin, symmetric airfoil at 1.5◦ angle of attack. From the resultsof thin airfoil theory, calculate the lift coefficient and the momentcoefficient about the leading edge.arrow_forward
- Explain how the three wing planforms, have the same local lift distribution local lift coefficient. All wings twisted to have elliptic distribution of lift 1(y) root tip shown below, could while having different cl tip cl(y) cl root root root tip tiparrow_forwardA given symmetrical airfoil has a lift curve slope of 6 per radian. What is the angle of attack (in degrees) corresponding to a lift coefficient of 0.4? Round off answer to the nearest tenths. (for symmetrical airfoils zero-lift angle of attack is 0°)arrow_forward6. For a wing of aspect ratio AR, having an elliptical lift distribution, the induced drag coefficient is (where CL is the lift coefficient) (b) TAR CL 2TAR (d) TAR2 (a) TAR 7. Laminar flow airfoil is used to reduce the (a) pressure drag (b) induced drag (c) skin friction drag (d) wave drag 8. Set the aerofoil your chosen angle of incidence is gives a good installed pressure distribution. (a) twelve degree (b) ten degree (c) eight degree 9. The critical Mach number for a thick airfoil will be (a) lesser than a thin airfoil. (b) greater than a thin airfoil. (c) equal to a thin airfoil. (d) cannot be related to thin airfoil 10. What is the dimension for Lift coefficient? (a) N/s (b) kg/N (c) Dimensionlessarrow_forward
- A wing has a planform area S of 200 ft? and a total span b of 40 feet. The airfoils are symmetric all along the span. The airfoil has a 2-D lift curve slope of 27 per radian. The wing has a rectangular planform, and thus has zero taper. The wing is untwisted. a. Compute the lift coefficient C and the drag coefficient Coi at an angle of attack of 4 degrees. Use two terms in the series expansion for circulation. T= 2bV,[4, sin ø + A, sin 3ø] b. Repeat the above calculation, now with just one term T=2bVA1sino. Compare the lift drag coefficient C and Cp values to problem #2 above. c. Compare the results for drag coefficient from part (b) above with that for an elliptically loaded wing at this lift coefficient.arrow_forwardFor a 10 deg included angle wedge at 0 deg AOA, calculate the lift and drag coefficient (Cl = 0, Cd = 0.082). Then calculate the lift and drag at AOA=4 deg (Cl = 0.16, Cd = 0.093). Let M=2.arrow_forwardAn untwisted wing uses the same airfoil along the span and the lift distribution can be considered elliptical. Data: mo = 6.1/rad b = 30 ft; S = 150ft²; a = 4°; aoL = -2.5° Find: CL(a); Cpi; CL; and Induced angle of attack at y = 5 ftarrow_forward
- Consider the NACA 2412 airfoil discussed . The airfoil is flying at a velocity of 60 m/s at a standard altitude of 3 km . The chord length of the airfoil is 2 m. Calculate the lift per unit span when the angle of attack is 4◦.arrow_forwarding 16. Consider a finite wing with aspect ratio A-8 and elliptical planform. The aerofoil section is thin and symmetric. Calculate the lift and induced drag coefficients when angle of attack is five degrees.arrow_forwardProblem 06.025 - Calculate maximum velocity The Predator UAV has the following characteristics: wingspan = 14.85 m, wing area = 11.45 m², maximum weight = 1110 kgf, and fuel weight = 295 kgf. The power plant is a Rotax four- cylinder, four-stroke engine of 100 horsepower driving a two- blade, variable-pitch pusher propeller. Assume: the Oswald efficiency factor is 0.7; the zero-lift drag coefficient is 0.03; the propeller efficiency is 0.9; and the specific fuel consumption is 0.2 kgf of fuel per horsepower per hour. Calculate the maximum velocity of the Predator at sea level. The maximum velocity of the Predator UAV at sea level is m/s.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Heat Transfer (Activate Learning wi...Mechanical EngineeringISBN:9781305387102Author:Kreith, Frank; Manglik, Raj M.Publisher:Cengage Learning
Principles of Heat Transfer (Activate Learning wi...
Mechanical Engineering
ISBN:9781305387102
Author:Kreith, Frank; Manglik, Raj M.
Publisher:Cengage Learning
Ficks First and Second Law for diffusion (mass transport); Author: Taylor Sparks;https://www.youtube.com/watch?v=c3KMpkmZWyo;License: Standard Youtube License