Programmable Logic Controller (PLC): PLC is a specialized computer used in industrial segments to control machines and process. PLC is program that consists of a set of instructions which resembles the controlling functions needed to perform specific tasks. The function of PLC is similar to that of a relay and hence, in an industrial segment a relay is greatly replaced by a suitable PLC. When compared to general Personal Computer (PC), a PLC is available in small and tiny sizes. The basic architecture of a PLC consists of an input-output interface module and a small Central Processing Unit (CPU) that runs by controlling programming language. Given: The following motor control specifications must be satisfied by the ladder logic program. Each starter must operate from its own start/stop pushbutton station to wire three starters. A master stop station is included, which will trip out all of the starters when pushed. All pushbuttons must be wired by one set of Normally Open (NO) contacts. An overload on any one of the starters will automatically drop all the starters by programming overload relay contacts.

Question

Want to see the full answer?

Answer 1

Question

Chapter 6, Problem 8P

Program Plan Intro

Programmable Logic Controller (PLC):

PLC is a specialized computer used in industrial segments to control machines and process.

PLC is program that consists of a set of instructions which resembles the controlling functions needed to perform specific tasks.

The function of PLC is similar to that of a relay and hence, in an industrial segment a relay is greatly replaced by a suitable PLC.

When compared to general Personal Computer (PC), a PLC is available in small and tiny sizes.

The basic architecture of a PLC consists of an input-output interface module and a small Central Processing Unit (CPU) that runs by controlling programming language.

Given:

The following motor control specifications must be satisfied by the ladder logic program.

Each starter must operate from its own start/stop pushbutton station to wire three starters.

A master stop station is included, which will trip out all of the starters when pushed.

All pushbuttons must be wired by one set of Normally Open (NO) contacts.

An overload on any one of the starters will automatically drop all the starters by programming overload relay contacts.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Write a Ladder Logic PLC program for each of the following scenarios. Label all contacts and coils in the PLC program. Scenario 1 Turn on a light when either one of two switches (I1, I2) is toggled on (construct an OR Gate). Turn on a second light when both switches (Same inputs I1, I2) are toggled on (construct an AND Gate). Turn on a third light when both switches (Same inputs I1, I2) are toggled off (construct a NOR Gate). Turn on a fourth light when either switch (Same inputs I1, I2) is toggled off (construct a NAND Gate). Print a copy of the program showing the construction of the four gate configurations. Also, submit a truth table for the four input configurations. Then modify your program so, only one light turns on at a time as you toggle the four truth table states. Scenario 2 Construct a seal-in circuit using a stop-and-start pushbutton and an internal coil to seal in. Turn on a light for 10 seconds when the start button is pushed then turn it off automatically or…

Design a PLC program and prepare a typical I/O connection diagram and ladder logic program for the airplane ( or aircraft ).

Draw a plc ladder diagram for blinking lights with start and stop button. Please help me with this. Thank you in advanced.