Physics for Scientists and Engineers, Volume 2
10th Edition
ISBN: 9781337553582
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 7, Problem 17P
When different loads hang on a spring, the spring stretches to different lengths as shown in the following table. (a) Make a graph of the applied force versus the extension of the spring. (b) By least-squares fitting, determine the straight line that best fits the data. (c) To complete part (b), do you want to use all the data points, or should you ignore some of them? Explain. (d) From the slope of the best-fit line, find the spring constant k. (c) If the spring is extended to 105 mm, what force does it exert on the suspended object?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Solve the problem. PROVIDE THE GIVEN, REQUIRED, EQUATION, SOLUTION, AND FINAL ANSWER
A spring of k = 1972 N/m loses its elasticity if stretched more than 45 cm. What is the mass of the heaviest object the spring can support without being damaged?
If the modulus of the sum of two vectors is less than the modules of the two vectors, we can conclude that
a) The vectors point in the same direction, in opposite directions.
b) The vectors point in the same direction and in the same direction.
c) The scalar product of the two vectors is positive.
d) The scalar producer of the two vectors is negative.
e) None of the above.
Jum
The mass of the block depicted in the image is 2.94 kg. The spring has a spring
constant of 77.2 N/m. The coefficient of static friction between the block and the
floor is 0.735. Assume that the spring makes no contact with the floor and
therefore friction only acts on the block.
How far must the block and spring assembly be compressed to just barely
overcome the force of static friction acting on the block?
Report your result in meters.
Chapter 7 Solutions
Physics for Scientists and Engineers, Volume 2
Ch. 7.2 - Prob. 7.1QQCh. 7.2 - Figure 7.4 shows four situations in which a force...Ch. 7.3 - Which of the following statements is true about...Ch. 7.4 - A dart is inserted into a spring-loaded dart gun...Ch. 7.5 - A dart is inserted into a spring-loaded dart gun...Ch. 7.6 - Choose the correct answer. The gravitational...Ch. 7.6 - A ball is connected to a light spring suspended...Ch. 7.8 - What does the slope of a graph of U(x) versus x...Ch. 7 - A shopper in a supermarket pushes a cart with a...Ch. 7 - The record number of boat lifts, including the...
Ch. 7 - In 1990, Walter Arfeuille of Belgium lifted a...Ch. 7 - Spiderman, whose mass is 80.0 kg, is dangling on...Ch. 7 - Prob. 5PCh. 7 - Vector A has a magnitude of 5.00 units, and vector...Ch. 7 - Find the scalar product of the vectors in Figure...Ch. 7 - Using the definition of the scalar product, find...Ch. 7 - A particle is subject to a force Fx that varies...Ch. 7 - In a control system, an accelerometer consists of...Ch. 7 - When a 4.00-kg object is hung vertically on a...Ch. 7 - Express the units of the force constant of a...Ch. 7 - The tray dispenser in your cafeteria has broken...Ch. 7 - A light spring with force constant 3.85 N/m is...Ch. 7 - A small particle of mass m is pulled to the top of...Ch. 7 - The force acting on a particle is Fx = (8x 16),...Ch. 7 - When different loads hang on a spring, the spring...Ch. 7 - A 100-g bullet is fired from a rifle having a...Ch. 7 - (a) A force F=(4xi+3yj), where F is in newtons and...Ch. 7 - Review. The graph in Figure P7.20 specifies a...Ch. 7 - A 0.600-kg particle has a speed of 2.00 m/s at...Ch. 7 - A 4.00-kg particle is subject to a net force that...Ch. 7 - A 2 100-kg pile driver is used to drive a steel...Ch. 7 - Review. In an electron microscope, there is an...Ch. 7 - Review. You can think of the workkinetic energy...Ch. 7 - You are lying in your bedroom, resting after doing...Ch. 7 - Review. A 5.75-kg object passes through the origin...Ch. 7 - Review. A 7.80-g bullet moving at 575 m/s strikes...Ch. 7 - A 0.20-kg stone is held 1.3 m above the top edge...Ch. 7 - A 1 000-kg roller coaster car is initially at the...Ch. 7 - A 4.00-kg particle moves from the origin to...Ch. 7 - (a) Suppose a constant force acts on an object....Ch. 7 - A force acting on a particle moving in the xy...Ch. 7 - Why is the following situation impossible? A...Ch. 7 - A single conservative force acts on a 5.0-kg...Ch. 7 - A potential energy function for a system in which...Ch. 7 - Prob. 37PCh. 7 - For the potential energy curve shown in Figure...Ch. 7 - A right circular cone can theoretically be...Ch. 7 - The potential energy function for a system of...Ch. 7 - You have a new internship, where you are helping...Ch. 7 - When an object is displaced by an amount x from...Ch. 7 - A particle moves along the xaxis from x = 12.8 m...Ch. 7 - Why is the following situation impossible? In a...Ch. 7 - Prob. 45APCh. 7 - (a) Take U = 5 for a system with a particle at...Ch. 7 - An inclined plane of angle = 20.0 has a spring of...Ch. 7 - An inclined plane of angle has a spring of force...Ch. 7 - Over the Christmas break, you are making some...Ch. 7 - A particle of mass m = 1.18 kg is attached between...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A force of 40.0 N stretches a spring 20.0 cm. Find the spring constant (in .N/m). Show Working Equation with answer. Answer must be in metric units.arrow_forwardA uniform chain 24 m long and with mass 26 kg is hanging from the top of a building 24 m high. If a bucket filled with cement of mass 55 kg is attached to the end of the chain, how much work is required to pull the bucket and chain to the top of the building? (Use g = 9.8 N/kg.) (Use decimal notation. Give your answer to one decimal place.) Jarrow_forwardA spring suspended from a ceiling has a constant of 12 Ib/ft. An 8 Ib weight is placed on the spring, and when equilibrium is reached, the weight is raised 5 in. above the equilibrium position and dropped. Solve for the displacement (x) of the weight at any time (t). Type or paste an image of your solutions below:arrow_forward
- Problem 1: A) Energy Methods Look at the below system. Using the conservation of energy method, solve for the governing equation of motion for the system. Put a box around your final answer. Also, put a box around your equations for the potential and kinetic energy of the system. Assume the system’s springs are initially unstretched (i.e., assume that there is no gravity until t = 0 [s]). B) Numerical Methods Using ode45, your answer to problem 1, and the following initial conditions and system parameters, plot the response of the above system in MATLAB for at least 5 complete oscillations, and no more than 20 oscillations. m = 72 (if your last 2 digits are 00, than assume m = 1) [kg] k1 = 673 [N/m] k2 = 880 digits of your student ID [N/m] g = 9.81 [m/s2] x0 = 0 [m] v0 = 0 [m/s]arrow_forwardInstructions: 1. Wite the corresponding solutions and units for every part of the GIVEN, REQUIRED, SOLUTIONS and FINAL ANSWER. 2. Please do not shortcut the solutions, do it in a step-by-step way. and use only five (5) decimal places. 3. Box the final answer and use five (5) decimal places if applicable Problem: A spring in the weighing scale compresses in length by 0.14 inches for every 1.0lb, of applied force. Determine the mass of an object, in pound mass, that causes this spring to be compressed by 1.8inches. The local acceleration of gravity is 31 ft/s².arrow_forwardComputation. A spring is stretched 34.5 cm beyond its equilibrium length. How much energy has been transferred to the spring, if the spring constant is 86.8 N/cm? [Note the units!] E = J Record your numerical answer below assuming three significant figures. Remember to include a "-" if/when necessary. Searcharrow_forward
- For this question, you will need to show the work and submit the solution. Sending in only a solution will result in 0 (zero) points for this question. Using the density table provided in the directions or the density table in the unit's overview, find the following, to the nearest thousandth when appropriate. Remember to label units! Workers made a brick wall out of six-hundred fifty 12cm by 12 cm by 30 cm bricks. Find the total weight in kilograms of the wall. brick=2.1g/cm^3arrow_forwardAn object is placed on the end of a vertical spring, with a spring constant of 484.1 N/m. The spring is stretched by 0.09 m. Calculate the mass of object.arrow_forwardI included two pictures. Please show me how to approach the problem in the correct manner based on the feedback given. It is okay to completely change the answer if you need to. Please give a reasoning to why the claim is not reasonable and the work needed to back this up.arrow_forward
- Two identical springs are connected in series as shown, each spring has a spring constant of 98 N/m. What is the spring constant of the overall two-spring system, in N/m? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.arrow_forwardNow, calculate p. Again, -100000 means that we need further information. The parameters: •m = 300 grams • Yo = (equilibrium value) = 74 cm • k = (spring constant) = 0.01 N/cmarrow_forwardThe spring constantContext You do an internship in a mechanical component characterization company for your engineering degree. You are currently working on determining the spring constant of industrial springs. To do this, you measure the elongation of springs placed on a graduated inclined plane, to which you attach masses. Constraints One end of the spring is attached to a hook at the top of the inclined plane and the other end is attached to a mass.The spring is parallel to the plane, and the force it exerts on the mass is also parallel to the plane.The angle of inclination of the plane is known, as well as its uncertainty.There is no friction between the plane and the mass.The natural length of the spring and its uncertainty are known.By hooking a known mass (m ± delta m), you measure that the spring now has a length (L ± delta L).We use the value g=(9.81 ± 0.01)m/s^2 for our calculations. Schematization Draw a diagram of the object that interests us. Draw your x and y axes. Draw…arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
University Physics (14th Edition)
Physics
ISBN:9780133969290
Author:Hugh D. Young, Roger A. Freedman
Publisher:PEARSON
Introduction To Quantum Mechanics
Physics
ISBN:9781107189638
Author:Griffiths, David J., Schroeter, Darrell F.
Publisher:Cambridge University Press
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Lecture- Tutorials for Introductory Astronomy
Physics
ISBN:9780321820464
Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden
Publisher:Addison-Wesley
College Physics: A Strategic Approach (4th Editio...
Physics
ISBN:9780134609034
Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field
Publisher:PEARSON
Work and Energy - Physics 101 / AP Physics 1 Review with Dianna Cowern; Author: Physics Girl;https://www.youtube.com/watch?v=rKwK06stPS8;License: Standard YouTube License, CC-BY