Traffic and Highway Engineering - With Mindtap
5th Edition
ISBN: 9781305360990
Author: Garber
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Question
Chapter 7, Problem 27P
To determine
Sight distance leg along the railroad tracks to permit a vehicle travelling at the design speed to safety cross the tracks when a train is observed at a distance equal to the sight distance leg.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
The design speed of a multilane highway is 60 mi/h. What is the minimum stopping sight distance that should be provided on the road if (a) the road is level and (b) the road has a maximum grade of 4%? Assume the perception-reaction time = 2.5 sec.
Calculate the minimum length of overtaking
zone of a one way traffic road if the velocity
of the overtaking and the overtaken vehicles
are 110 and 60 kph, and the acceleration of
the vehicle is 1.2 m/s^2. (Hint: overtaking
sight distance is just a third of minimum
length of overtaking zone).
Compute the passing sight distance for a road section with the following conditions time for initial maneuver of 5 sec average acceleration rate of 2.6 km/hr/sec time in which the passing vehicle travels over left lane is 10 sec average of passing vehicle speed is 70 kph
Chapter 7 Solutions
Traffic and Highway Engineering - With Mindtap
Ch. 7 - Prob. 1PCh. 7 - Prob. 2PCh. 7 - Prob. 3PCh. 7 - Prob. 4PCh. 7 - Prob. 5PCh. 7 - Prob. 6PCh. 7 - Prob. 7PCh. 7 - Prob. 8PCh. 7 - Prob. 9PCh. 7 - Prob. 10P
Ch. 7 - Prob. 11PCh. 7 - Prob. 12PCh. 7 - Prob. 13PCh. 7 - Prob. 14PCh. 7 - Prob. 15PCh. 7 - Prob. 16PCh. 7 - Prob. 17PCh. 7 - Prob. 18PCh. 7 - Prob. 19PCh. 7 - Prob. 20PCh. 7 - Prob. 21PCh. 7 - Prob. 22PCh. 7 - Prob. 23PCh. 7 - Prob. 24PCh. 7 - Prob. 25PCh. 7 - Prob. 26PCh. 7 - Prob. 27PCh. 7 - Prob. 28P
Knowledge Booster
Similar questions
- The intersection at the northern part of Sohar University is having a short sight distance (Figures Q2-A1 and Q2-A2). What will be the proper speed to drive safely from the two points A and B approaching the intersection? Learning Reourca Centre Figure Q2-A1: Sohar University northern intersection Sight Line 6,5 m 33 m 52 m 12 35 marrow_forward(TRAFFIC AND HIGHWAY ENGINEERING) A tall building is located 13.5 m from the centerline of the right lane of a local road and 19.5 m from the centerline of the right lane of an intersecting road in figure below. If the maximum speed limit on the intersecting road is 56 km/h, what should the speed limit on the local road be such that the minimum sight distance is provided to allow the drivers of approaching vehicles to avoid imminent collision by adjusting their speeds? Approach grades are 2 percent.arrow_forwardBecause of a visible obstruction along a horizontal curve drivers can only see a stop sign until they are at 250 feet upstream of the sign. Can vehicle stop before the stop line if the perception reaction time is 2.5 seconds and deceleration rate is 11.2 ft./s^2 what should be a reasonable posted speed limitarrow_forward
- A minor two-lane road (lane width = 3.4 m) intersects a four-lane divided highway (lane width = 3.5 m) at 90° forming a T-intersection. The median width on the major road is 1.75 m. The design speeds on the major and minor roads are 90 and 60 km/h, respectively. (a) Determine the minimum sight distance required for a single-unit truck on the minor road to depart from a stopped position and turn left onto the major road. (b) Determine the sight distance required by the minor-road a single-unit truck to safely complete a right turn onto the major road.arrow_forwardThe design speed of a multilane is 55kph. What is the minimum stopping sight distance that should be provided on the road if the road is level.arrow_forward2 A slight bend prior to a curve means that a 65 km/h curve advisory speed sign is not visible to drivers until 95 m before the start of the curve. The 85th percentile speed of vehicles on this approach, prior to reaction and braking, has been measured by survey as 88 km/h. If it is assumed that it is desirable for vehicles to slow down to the posted 65 km/h-advisory speed before reaching the curve, what is the required distance to achieve this? Is the available sight distance adequate for this?arrow_forward
- QI: A traffic signal control is being designed for a four-leg intersection on a divided highway with the characteristics shown in the table below. Determine an appropriate length of all red interval for this intersection. N-S Approaches E-W Approaches Median width (m) 5.5 3 Number of 3.6 m lanes on each approach Design speed (km/h) Assume the length of design vehicle is 6 m. 72 56arrow_forward6) (6 points) A two-lane minor road stops at major road with a design speed of 45 mph and 12 ft lanes. The major road does not stop. Using the AASHTO method, determine the required sight distance along the major road for left-turn movements for the following scenarios: combination-truck, 2-lane major road (undivided) Single unit truck, 3-lane major road (one lane in each direction with a 12 ft. center two-way left turn lane) Passenger car, 4-lane major road divided by an 12 ft. median.arrow_forwardMaximum permissible speed on a railway track (BG track) is 100 kmph. calculate radius of the curve and degree of the curve?arrow_forward
- b) Figure 2 indicates the layout of the unsignalised intersection between a major road and a minor road. If the stopping sight distance of vehicle ‘A’ on the minor road is 60m at a speed of 50km/h and that of vehicle ‘B’ on the major road is 80m at a speed of 60km/h, determine the adequacy of the intersection sight distance provided that will ensure that vehicle ‘A’ safely crosses the major road without colliding with vehicle ‘B’. The distance of vehicle ‘A’ to the building is 15m represented by ‘x’ in the figure.arrow_forwardA two-lane minor road intersects a two-lane major road at 90° forming a four-leg intersection with traffic on the minor road controlled by a yield sign. A building is located 125 ft from the centerline of the outside lane of the major road and 35 ft from the centerline of the nearest lane of the minor road. Determine the maximum speed that can be allowed on the minor road if the speed limit on the major road is 45 mi/h.arrow_forwardFor the STOP-controlled intersection show below, is the sight distance sufficient for safe operations? If not, what do you recommend? Again, you may assume that a traffic signal is not warranted at this location. All grades are level, and the standard reaction time of 2.5 s may be used. Lane widths on the E-W street are 12 ft. 45 mi/h 45 mi/h 30 ft : 30 mi/h 50 ft 35 ft 28 ft Building Buildingarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning