A+ Guide To It Technical Support
10th Edition
ISBN: 9780357108291
Author: ANDREWS, Jean.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Chapter 7, Problem 5TC
Explanation of Solution
Given:
The IP address 169.254.75.10 is reported on the Ethernet interface when ipconfig command is used on the computer.
To find: The device that assigned the 169...
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
I ran the ipconfig command on my computer and it reports an IP address 169.254.75.10 on the ethernet interface. Which device assigned this IP address to this interface?
A device on your network has an Ethernet NIC with a static IPv4 configuration. Which two of the following IPv4 parameters will be listed in the PC's IPv4 configuration? Traceroute server hostname DHCP Server address PC's private IP address DNS server address
Your network has a device with an Ethernet NIC that is set up with a static IPv4 address. Which two of the following IPv4 settings will be shown in the PC's IPv4 configuration? Traceroute address server DHCP Server address IP address of the PC DNS server address
Chapter 7 Solutions
A+ Guide To It Technical Support
Knowledge Booster
Similar questions
- Your Network Administrator has contacted you to assist in examining a workstation that has been showing network fluctuations time and again. It seems that someone spilled some hot water over the Ethernet ports. Which of the following addresses will you choose to check the functionality of the Ethernet card without worrying about corrupted hardware and to ensure that the workstation's TCP/IP services are running? ping -a 8.8.8.8 ping -a 0.0.0.0 ping 127.0.0.1 ping 192.168.1.1arrow_forwardYour network contains a device that has an Ethernet NIC and is set up with a static IPv4 configuration. Which two of the IPv4 parameters that are stated below will be included in the IPv4 setup of the personal computer? Traceroute server's Internet Protocol address DHCP Server address IP address that is private to the PC DNS server addressarrow_forwardYour network has a static IPv4-configured Ethernet NIC device. Which two IPv4 parameters below will be included in the PC's IPv4 setup? Traceroute server's IP. PC-private DHCP server address DNS server addressarrow_forward
- You as a network administrator want to protect the network from unauthorized traffic, and for this reason, you decide to change the native VLAN to an unused VLAN so that the untagged traffic is essentially directed toward a dead-end. Which of the following commands will you use to do this on a Cisco switch? a. set native-vlan-id b. set port-mode trunk c. switchport trunk native vlan d. ip dhcp snoopingarrow_forwardWhich two protocols manage neighbor discovery processes on IPv4 networks? ICMP and ARP IPv4 and IPv6 TCP and UDP NDP and Ethernet You’re getting a duplicate IP address error on your computer and need to figure out what other device on your network is using the IP address 192.168.1.56. What command will show you which MAC address is mapped to that IP address? telnet 192.168.1.56 tracert 192.168.1.56 arp -a netstat -narrow_forwardArriving at your university room, you plug into the wired Ethernet jack for the first time. The network admin has a record of your MAC address and your machine can join the network without further action on your part. Assume: Your laptop's Ethernet address is 0a:0b:0c:0d:0e:0f, DHCP server address is 131.111.7.3, your IPv4 address will be 131.111.7.121, the gateway's IP address is 131.111.7.1, and Ethernet address is 00:01:02:03:04:05, the network subnet mask is 255.255.255.0.Write the series of protocol/packet exchanges that occur on the wired Ethernet link, up until you can send a single packet to 128.232.0.20. You do not need to describe packets after this packet has left the link. Include ARP and DHCParrow_forward
- What command can you use to assign an ethernet interface eth0 the IP address 192.168.1.2?arrow_forwardFrom your laptop, you need to remote into a switch to make some configuration changes.Which Transport layer protocol and TCP/IP port should you open in Windows Firewall tomake this work using Telnet?a. UDP, port 23b. TCP, port 23c. UDP, port 22d. TCP, port 22e. UDP, port 21arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
- A+ Guide To It Technical SupportComputer ScienceISBN:9780357108291Author:ANDREWS, Jean.Publisher:Cengage,Comptia A+ Core 1 Exam: Guide To Computing Infras...Computer ScienceISBN:9780357108376Author:Jean Andrews, Joy Dark, Jill WestPublisher:Cengage LearningA+ Guide to Hardware (Standalone Book) (MindTap C...Computer ScienceISBN:9781305266452Author:Jean AndrewsPublisher:Cengage Learning
A+ Guide To It Technical Support
Computer Science
ISBN:9780357108291
Author:ANDREWS, Jean.
Publisher:Cengage,
Comptia A+ Core 1 Exam: Guide To Computing Infras...
Computer Science
ISBN:9780357108376
Author:Jean Andrews, Joy Dark, Jill West
Publisher:Cengage Learning
A+ Guide to Hardware (Standalone Book) (MindTap C...
Computer Science
ISBN:9781305266452
Author:Jean Andrews
Publisher:Cengage Learning