Concept explainers
Consider the raction between N2H4 and N2O4:
A reaction vessel initially contains 27.5g N2H4 and 74.9g of N2O4. Calculate the masses of N2H4, and H2O that will be in reaction vessel after the reactants have reacted as much as possible. Assume 100% yield. Hint: The limiting reactant is completely consumed, but the reactant in excess is not. Use the amount of limiting reactant to determine the amount of products that form and the amount of the reactant in excess that remains after complete reaction.
Want to see the full answer?
Check out a sample textbook solutionChapter 8 Solutions
INTRODUCTORY CHEM.(LL)-W/ACCESS>CUSTOM<
- A power plant is driven by the combustion of a complex fossil fuel having the formula C11H7S. Assume the air supply is composed of only N2 and O2 with a molar ratio of 3.76:1.00, and the N2 remains unreacted. In addition to the water produced, the fuels C is completely combusted to CO2 and its sulfur content is converted to SO2. In order to evaluate gases emitted at the exhaust stacks for environmental regulation purposes, the nitrogen supplied with the air must also be included in the balanced reactions. a Including the N2 supplied m the air, write a balanced combustion equation for the complex fuel assuming 100% stoichiometric combustion (i.e., when there is no excess oxygen in the products and the only C-containing product is CO2). Except in the case of N2, use only integer coefficients. b Including N2 supplied in the air, write a balanced combustion equation for the complex fuel assuming 120% stoichiometric combustion (i.e., when excess oxygen is present in the products and the only C-containing product is CO2). Except in the case of use only integer coefficients c Calculate the minimum mass (in kg) of air required to completely combust 1700 kg of C11H7S. d Calculate the air/fuel mass ratio, assuming 100% stoichiometric combustion. e Calculate the air/fuel mass ratio, assuming 120% stoichiometric combustion.arrow_forwarda. Write die balanced equation for the combustion of isooctane (C8H18) to produce water vapor and carbon dioxide gas. b. Assuming gasoline is 100.% isooctane, with a density of 0.692 g/mL, what is the theoretical yield of carbon dioxide produced by the combustion of 1.2 1010 gal of gasoline (the approximate annual consumption of gasoline in the United States)?arrow_forward3.50 A test of an automobile engine's exhaust revealed that g of NO2 was emitted in 10 minutes of operation. How many moles of NO2 would this engine release if it were used for a 45-minute commute, assuming that this mea- sured number is representative of the emission under all circumstances?arrow_forward
- 4.32 Hydrogen and oxygen are reacted and the water formed is collected at 25°C, where it has a density of 0.997 g/mL. If 36.8 g of H2 and 168 g of O2 are reacted, how many mL of water will be collected?arrow_forwardA 100.0-g mixture made up of NaCl03, Na2CO3, NaCl, and NaHCO3 is heated, producing 5.95 g of oxygen, 1.67 g of water, and 14.5 g of carbon dioxide. NaCl does not react under the conditions of the experiment. The equations for the reactions that take place are: 2NaClO3(s)2NaCl(s)+3O2(g)Na2CO3(s)2Na2O(s)+CO2(g)2NaHCO3(s)Na2O(s)+2CO2(g)+H2O Assuming 100% decomposition of NaClO3, Na2CO3, and NaHCO3, what is the composition of the mixture in grams?arrow_forwardMagnesium ribbon reacts with acid to produce hydro- gen gas and magnesium ions. Different masses of magnesium ribbon are added to 10 mL of the acid. The volume of the hydrogen gas obtained is a measure of the number of moles of hydrogen produced by the reaction. Various measurements are given in the table below. (a) Draw a graph of the results by plotting the mass of Mg versus the volume of the hydrogen gas. (b) What is the limiting reactant in experiment 1? (c) What is the limiting reactant in experiment 3? (d) What is the limiting reactant in experiment 6? (e) Which experiment uses stoichiometric amounts of each reactant? (f) What volume of gas would be obtained if 0.300 g of Mg ribbon were used? If 0.010 g were used?arrow_forward
- Many cereals are made with high moisture content so that the cereal can be formed into various shapes before it is dried. A cereal product containing 58% H2O by mass is produced at the rate of 1000. kg/h. What mass of water must be evaporated per hour if the final product contains only 20.% water?arrow_forwardMany cereals are made with high moisture content so that the cereal can be formed into various shapes before it is dried. A cereal product containing 58% H2O by mass is produced at the rate of 1000. kg/h. What mass of water must be evaporated per hour if the final product contains only 20.% water?arrow_forwardMethanol, CH3OH, can be prepared from carbon monoxide and hydrogen. CO(g) + 2 H2(g) CH3OH(l) What mass of hydrogen is required to produce 1.0 L of CH3OH (d = 0.791 g/mL) if this reaction has a 74% yield under certain conditions?arrow_forward
- 4.72 The picture shown depicts the species present at the start of a combustion reaction between methane, CH4 and oxygen, O2 (a) What is the limiting reactant? (b) Draw the resulting state after this set of reactants has reacted as far as possible.arrow_forward3.115 The average person exhales 1.0 kg of carbon dioxide in a day. Describe how you would estimate the number of CO2 molecules exhaled per breath for this average person.arrow_forward4.69 The pictures below show a molecular-scale view of a chemical reaction between H2 and CO to produce methanol, CH3OH. The box on the left represents the reactants at the instant of mixing, and the box on the right shows what is left once the reaction has gone to completion. Was there a limiting reactant in this reaction? If so, what was it? Write a balanced chemical equation for this reaction. As usual, your equation should use the smallest possible whole number coefficients for all substances.arrow_forward
- Chemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning
- Chemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningWorld of Chemistry, 3rd editionChemistryISBN:9781133109655Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCostePublisher:Brooks / Cole / Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning