Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
5th Edition
ISBN: 9781305084766
Author: Saeed Moaveni
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 9, Problem 46P
To determine
Find the average air speed in the exit duct and express it in ft/min and m/s.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
A rectangular duct with dimensions of 12 in. × 14 in. delivers conditioned air with a density of 1.2 kg/m3 to a room at a rate of 1000 ft3/min. What is the mass-flow rate of air in lbm/h? What is the average air speed in the duct? Express your answer in m/s and ft/s.
A barometer is used to measure the height of a building by recording reading at the bottom and at the top of the building. The height of the building is to be determined in (m) .
The density of air is given to be as 1.18 kg/m3. The density of mercury is 13,600 kg/m3.
Atmospheric pressures at the top and at the bottom of the building are p1= 73 cm and p2 = 75.395 cm , respectively
Calculate the mass flow rate of air in g/min.
Chapter 9 Solutions
Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)
Ch. 9.3 - Prob. 1BYGCh. 9.3 - Prob. 2BYGCh. 9.3 - Prob. 3BYGCh. 9.3 - Prob. BYGVCh. 9.6 - Prob. 1BYGCh. 9.6 - Prob. 2BYGCh. 9.6 - Prob. 3BYGCh. 9.6 - Prob. BYGVCh. 9 - Prob. 1PCh. 9 - Prob. 2P
Ch. 9 - Determine the specific gravity of the following...Ch. 9 - Prob. 4PCh. 9 - Prob. 5PCh. 9 - Prob. 9PCh. 9 - Prob. 10PCh. 9 - Prob. 12PCh. 9 - Prob. 13PCh. 9 - Prob. 14PCh. 9 - Prob. 17PCh. 9 - Prob. 19PCh. 9 - Prob. 22PCh. 9 - Prob. 24PCh. 9 - Prob. 25PCh. 9 - Prob. 26PCh. 9 - Prob. 27PCh. 9 - Prob. 28PCh. 9 - Prob. 29PCh. 9 - Prob. 30PCh. 9 - Prob. 31PCh. 9 - Prob. 32PCh. 9 - Prob. 33PCh. 9 - Prob. 34PCh. 9 - Prob. 35PCh. 9 - A plugged dishwasher sink with the dimensions of...Ch. 9 - Prob. 37PCh. 9 - Prob. 38PCh. 9 - Prob. 39PCh. 9 - Prob. 40PCh. 9 - Prob. 41PCh. 9 - Prob. 42PCh. 9 - Prob. 43PCh. 9 - Lake Mead, near the Hoover Dam, which is the...Ch. 9 - Prob. 45PCh. 9 - Prob. 46PCh. 9 - Prob. 47PCh. 9 - Prob. 48PCh. 9 - Prob. 49P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- Using the information given in Table 10.4, determine the ratio of local pressure and density to sea-level values. Estimate the value of air density at the cruising altitude of most commercial airliners. Altitude (m) sealevel PPsealevel 0 (sea level) 1000 3000 5000 8000 10,000 12,000 14,000 15,000arrow_forwardA rectangular duct with dimensions of 1 m × 110 cm delivers conditioned air with a density of 1.2 kg⁄m3 to a room at a rate of 45 m3 /min. What is the mass-flow rate of air? What is the average air speed in the duct?arrow_forwardCalculate the capillary effect in millimeters in a glass tube of 4mm diameter, when immersed in Water Mercury the temperature of the liquid is 200C in contact with air are 0.073575 N/m and 0.51 N/m respectively. The angle of contact for water is zero and that for mercury is 1300. Take density of water at 200C as equal to 998 kg/m3. Explain the ways of describing the fluid motionarrow_forward
- There are two identical 316 stainless steel tanks that are 2.5 m long and have an inside diameter of 60 cm . One of the tanks is filled with air and the other tank is filled with water at 20 ° C . Complete the following table using the given density for air and waterarrow_forwardThe air entering a compressor has a density of 1.2 kg∙m−3 and a velocity of 5 m∙s−1, the area of the intake being 20 cm2. Calculate the mass flow rate. If air leaves the compressor through a 25 mm diameter pipe with a velocity of 4 m∙s−1, what will be its mass density?arrow_forward4. The water in a tank on the right is pressurized by air, and the pressure is measured by a multifluid manometer as shown in figure. Determine the gage pressure (kPa) of air in the tank if h₁ = 0.4 m, h2 = 0.6 m, and h3 = 0.8 m. Take the densities of water, oil, and mercury to be 1000 kg/m³, 850 kg/m³, and 13,600 kg/m³, respectively. (2 decimal)arrow_forward
- Calculate the energy required to lift an elevator and its occupants with amass of 2000 kg for the following situations: (a) between the first and thesecond floor, (b) between the third and the fourth floor, (c) between the firstand the fourth floor. (as shown .) The vertical distance between eachfloor is 4.5 m. We can use as shown to analyze this problem; the energy required to lift the elevator is equal to the change in its potential energy, starting witharrow_forward3. A conical tank shown in the figure has a diameter of 3 meters and an altitude of 5 meters. Find the volume of the liquid when the tank is full in cubic meters? Find volume "A" when the tank is filled to a depth of 3 meters in gallons. What is the surface area covered by volume "A" (or the wet surface area) in sauare meters?arrow_forwardWater flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?arrow_forward
- A tank initially contains 100 gallons of water. A salt solution containing 2lbs of salt per gallon flows in at the rate of 3 gallons per minute and the well stirred mixture flows cut at the same rate. When will the tank have 100 lbs of salt?a. 23.6 minutesb. 24.5 minutesc.23.1 minutes d. 20.5 minutessolve using the application of differential equationarrow_forwardDetermine the specific volume in m3/kg of a fluid with specific gravity of 2.5arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning