Concept explainers
The number of additional lanes required in each direction.
Answer to Problem 8P
The number of additional lanes required to maintain the level of service B is four.
Explanation of Solution
Given:
Length of the segment is
Sustained grade is
Design volume is
Percentage of trucks is
Percentage of buses is
Percentage of RV's is
Percent hour factor is
Free flow speed is
Right side lateral obstruction is
Design LOS is
Formula used:
Write the expression to calculate the
Here,
Find the number of lanes in each direction using the following relation.
Here,
Calculate the free flow speed by using the formula.
Here,
Write the expression to calculate the speed.
Here,
Write the expression to calculate the density using the formula.
Here,
Calculation:
Refer table 9.26, "PCE's for trucks and buses on upgrades, multilane highways and basic freeway sections".
The value of passenger car equivalent for trucks
The value of passenger car equivalent for recreational vehicles is
Substitute
Consider the driver population factor as
Consider
Substitute
Consider
Substitute
Consider
Substitute
Refer table 9.29, "Adjustment for lane width".
The value of
Refer table 9.30, "Adjustment for right shoulder lateral clearance".
At the right side lateral clearance, the value of reduction in free flow speed
For two lanes the value is
For three lanes the value is
For four lanes the value is
Refer table 9.31, "Adjustment for number of lanes" for the value of
For two lanes the value is
For three lanes the value is
For four lanes the value is
Refer table 9.32, "Adjustment for interchange density" for the value of
The value is
Consider
Substitute
Substitute
Substitute
Refer table 9.33, "Level of service criteria for multilane highways".
The level of service is D.
Consider
Substitute
Substitute
Substitute
Refer table 9.33, "Level of service criteria for multilane highways".
The level of service is C.
Consider
Substitute
Substitute
Substitute
Refer table 9.33, "Level of service criteria for multilane highways".
The level of service is B.
Conclusion:
Therefore, the number of additional lanes required to maintain the level of service B is four.
Want to see more full solutions like this?
Chapter 9 Solutions
TRAFFIC AND HIGHWAY ENG (LL) + WEBASSIG
- A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak- hour factor is 0.90, and all drivers are regular users. The lanes are 12 ft wide, there are no lateral obstructions within 10 ft of the roadway, and the total ramp density is 1.0 ramps per mile. A bus strike will eliminate all bus traffic, but it is estimated that for each bus removed from the roadway, seven additional passenger cars will be added as travelers seek other means of travel. a.) What is density, before the bus strike? b.) What is the volume-to-capacity ratio, before the bus strike? c.) What is the level of service of the upgrade segment before the bus strike? d.) What is density, after the bus strike? e.) What is the volume-to-capacity ratio, after the bus strike? f.) What is the level of service of the upgrade segment after the bus strike?arrow_forwardFind the service flow rate and service volume rate for an 8-lane-one direction urban freeway at level of service (A) with the following: 11-ft lane, 0-ft lane clearance, 2-per mile interchange density and 5% truck. The section is 4% upgrade for 1 mile. Use PHF = 0.85.arrow_forwardA particular roadway segment has a 6000-ft section of 3% upgrade, followed by a 5000-ft section of 5% upgrade. The traffic on the road includes 8% trucks and 4% recreational vehicles. Determine the PCEs.arrow_forward
- A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, b.) Determine vparrow_forwardA long segment of suburban freeway is to be designed on level terrain. The level segment, however, is followed by a 4.5% grade, 2.0 miles in length. If the DDHV is 2,500 vehicles per hour with 15% trucks (standard mix), how many lanes will be needed on the (A.) Upgrade, (B.) Downgrade, (C.) Level terrain segment to provide for level of service C? Lane widths and lateral clearances may be assumed to be 12 feet and 6 feet, respectively. Ramp density is expected to be 1.0 ramps per mile. The PHF is 0.92. Good weather, no incidents, no work zones, and regular users of the facility may be assumed.arrow_forwardAn eight-lane freeway section is designed to have a lane width of 10 ft, right-side shoulder width is 4 ft, and 5 ramps over a 2-mile-long centerline. What is the free-flow speed for this freeway section? a. 75 mph b. 70 mph c. 65 mph d. 60 mpharrow_forward
- A four-lane freeway (two lanes on each direction) is located on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, and a 3-ft left-side shoulder, and a 60- mph design speed. The freeway currently operates at capacity during the peak hour. If an additional 11-ft lane is added, and all other factors stay the same, what will the new level of service be?arrow_forwardA Class II two-lane highway needs to be redesigned for an area with rolling terrain. During the peak hour, 380 vehicles are traveling in the analysis direction and 300 vehicles are traveling in the opposing direction. The PHF is 0.92. The traffic stream includes 8% large trucks, 2% buses, and no recreational vehicles. What is the maximum percentage of no-passing zones that can be built into the design with LOS maintained?arrow_forwardA four-lane rural freeway segment has a 510 m grade length of 2% upgrade followed by a 630 m grade length of 3%. The freeway has 3.4-m lane, 1.5m left-shoulder lateral clearances and interchanges spaced at every 25 km. During the peak hour, there are 6% trucks, 2% buses, 2% recreational vehicles and the rest are passenger cars. Driver population adjustment is determined to be 0.90, peak hour factor is 0.90 and the BFFS is 110 km/h. At present, the freeway operates at capacity during the peak hour in the direction in question. If an additional 3.4 m lane is introduced, and all other factors stay the same, what will be the new level of service?arrow_forward
- A Class II two-lane highway needs to be redesigned for an area with rolling terrain. During the peak hour, 380 vehicles are traveling in the analysis direction and 300 vehicles are traveling in the opposing direction. The PHF is 0.92. The traffic stream includes 8% large trucks, 2% buses, and no recreational vehicles. What is the maximum percentage of no-passing zones that can be built into the design with LOS C maintained?arrow_forwardA six-lane freeway (three lanes in each direction) has regular weekday users and currently operates at maximum LOS C conditions. The lanes are 11 ft wide, the right-side shoulder is 4 ft wide, and there are two ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The highway is on rolling terrain with 10% large trucks and buses (no recreational vehicles), and the peak-hour factor is 0.90. b.) Determine the adjustment factor (f). (Express in three decimals)arrow_forwardA segment of rural freeway is being designed for a FFS of 65 mph using 11 ft lanes in a mountainous area. The lateral clearance is nominal (1 ft). The directional (i.e. one-way) design flow rate is expected to be 2,400 passenger cars per hour. How many lanes in one direction will be needed to provide at least a LOS B?arrow_forward
- Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning