Concept explainers
(a)
Interpretation:
The number of moles of oxalic acid in the
Concept introduction:
Molarity is the ratio of the number of moles of solute to the volume of the solution in liters.
The molarity is calculated by the formula,
(b)
Interpretation:
The molarity of the oxalic acid solution is to be determined.
Concept introduction:
Molarity is the ratio of the number of moles of solute to the volume of the solution in liters.
The molarity is calculated by the formula,
(c)
Interpretation:
The number of grams of oxalic acid in the
Concept introduction:
The formula to calculate number of moles is,
Where,
•
•
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
Chemistry for Today: General, Organic, and Biochemistry
- Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.arrow_forwardDescribe how the amount of sodium hydroxide in a mixture can be determined by titration with hydrochloric acid of known molarity.arrow_forwardA monoprotic organic acid that has a molar mass of 176.1 g/mol is synthesized. Unfortunately, the acid produced is not completely pure. In addition, it is not soluble in water. A chemist weighs a 1.8451-g sample of the impure acid and adds it to 100.0 mL of 0.1050 M NaOH. The acid is soluble in the NaOH solution and reacts to consume most of the NaOH. The amount of excess NaOH is determined by titration: It takes 3.28 mL of 0.0970 M HCl to neutralize the excess NaOH. What is the purity of the original acid, in percent?arrow_forward
- Consider the following two acids: In two separate experiments the pH was measured during the titration of 5.00 mmol of each acid with 0.200 M NaOH. Each experiment showed only one stoichiometric point when the data were plotted. In one experiment the stoichiometric point was at 25.00 mL added NaOH, and in the other experiment the stoichiometric point was at 50.00 mL NaOH. Explain these results. (See Exercise 113.)arrow_forwardA 5.36-g sample of NH4Cl was added to 25.0 mL of 1.00 M NaOH and the resulting solution diluted to 0.100 L.. (a) What is the pH of this buffer solution?. (b) Is the solution acidic or basic?. (c) What is the pH of a solution that results when 3.00 mL of 0.034 M HCl is added to the solution?arrow_forward12.17 Which of the following is more likely to precipitate sulfate ions? PbSO4(s) Pb*+(aq) + SO42’(aq) K = 1.8 X IO"8 CaSO4(s) i=i Ca2+(aq) + SO42'(aq) K = 9.1 X 10-6arrow_forward
- Consider the titration curve in Exercise 115 for the titration of Na2Cr3 with HCl. a. If a mixture of NaHCO3 and Na2CO3 was titrated, what would be the relative sizes of V1, and V2? b. If a mixture of NaOH and Na2CO3 was titrated, what would be the relative sizes of V1 and V2? c. A sample contains a mixture of NaHCO3 and Na2CO3. When this sample was titrated with 0.100 M HCl, it took 18.9 mL to reach the first stoichiometric point and an additional 36.7 mL to reach the second stoichiometric point. What is the composition in mass percent of the sample?arrow_forwardConsider the nanoscale-level representations for Question 110 of the titration of the aqueous weak acid HX with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: After a very small volume of titrant has been added to the initial HX solution? When enough titrant has been added to take the solution just past the equivalence point? Halfway to the equivalence point? At the equivalence point? Nanoscale representations for Question 110.arrow_forwardA solution is prepared by dissolving 10.8 g ammonium sulfate in enough water to make 100.0 mL of stock solution. A 10.00- mL sample of this stock solution is added to 50.00 mL of water. Calculate the concentration of ammonium ions and sulfate ions in the final solution.arrow_forward
- Which of the following is more likely to precipitate the hydroxide ion? Cu(OH)2(s) *=» Ctr+(aq) + 2 OH’(aq) K = 1.6 X IO-19 Ca(OH)2(s) *=» Ca2+(aq) + 2 OH’(aq) K = 7.9 X 10"6arrow_forwardThe weak base ethanolamine. HOCH2CH2NH2, can be titrated with HCl. HOCH2CH2NH2(aq)+H3O+(aq)HOCH2CH2NH3+(aq)+H2O(l) Assume you have 25.0 mL of a 0.010 M solution of ethanolamine and titrate it with 0.0095 M HCl. (Kb for ethanolamine is 3.2 107.) (a) What is the pH of the ethanolamine solution before the titration begins? (b) What is the pH at the equivalence point? (c) What is the pH at the halfway point of the titration? (d) Which indicator in Figure 17.11 would be the best choice to detect the equivalence point? (e) Calculate the pH of the solution after adding 5.00, 10.0, 20.0, and 30.0 mL of the acid. (f) Combine the information in parts (a), (b), (c), and (e), and plot an approximate titration curve.arrow_forwardAn acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.arrow_forward
- Chemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStaxChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning
- Chemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning