GEN, ORG & BIOL CHEM: CUSTOM SSC
GEN, ORG & BIOL CHEM: CUSTOM SSC
5th Edition
ISBN: 9781307274448
Author: SMITH
Publisher: MCG CUSTOM
Question
Book Icon
Chapter 9, Problem 9.13P

(a)

Interpretation Introduction

Interpretation:

The effect of condensation temperature on the coefficient of performance is to be determined for different condensation temperatures assuming isentropic compression of vapor.

Concept introduction:

Below shown diagram represents vapor-compression refrigeration cycle on a TS diagram which include four steps of the cycle. Line 12 shows a liquid which is evaporating at constant pressure and providing a means for heat absorption at constant low temperature. The vapor thus produced is then compressed to a higher pressure. It is then cooled and condensed at higher temperature by heat rejection. By an expansion process, the liquid from the condenser is returned to its original pressure. This process is carried out by throttling through a partly open valve. Due to the fluid friction in the valve there is pressure drop in this irreversible process.

The line 41 represents throttling process which occurs at constant enthalpy. The path of isentropic compression is shown by line 23' and the actual compression is shown by the line 23 where the direction of slope is in increasing enthalpy which reflects inherent irreversibility.

GEN, ORG & BIOL CHEM: CUSTOM SSC, Chapter 9, Problem 9.13P , additional homework tip  1

The equations used to calculate the heat absorbed in evaporator and the heat rejected in condenser are:

|QC|=H2H1 ...... (1)

  |QH|=H3H4 ...... (2)

The work of compression is:

W=H3H2 ...... (3)

The coefficient of performance is:

ω=H2H1H3H2 ...... (4)

The rate of circulation of refrigerant, m˙ is determined from the rate of heat absorption in the evaporator given by the equation:

m˙=|Q˙C|H2H1 ...... (5)

For Carnot refrigeration cycle, highest possible value of ω is attained at the given values of TC and TH . Due to irreversible expansion in a throttle valve and irreversible compression in the vapor-compression cycle, lower values of ω is obtained.

(a)

Expert Solution
Check Mark

Answer to Problem 9.13P

The coefficient of performance for condensation temperature of 16C is 9.049 .

The coefficient of performance for condensation temperature of 28C is 5.729 .

The coefficient of performance for condensation temperature of 40C is 3.737 .

As the condensation temperature is increased, the coefficient of performance decreases.

Explanation of Solution

Given information:

In a refrigerator, tetrafluoroethene acts as a refrigerant and operates with an evaporation temperature of 12C . Different condensation temperature for the isentropic compression of vapor are 16C, 28C, and 40C .

From table 9.1, the values of H2, and S2 and the pressure for the saturated tetrafluoroethene at 12C are:

  H2=391.46 kJ/kgS2=1.735 kJ/(kgK)P2=1.852 bar

Assume that the compressor efficiency is η=1.00 , so,

  H3=H3

For condensation temperature of 16C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(16C) at this point is:

  Psat( 16C)=5.043 barH4( 16C)=221.87 kJ/kg

Also, H1(16C)=H4(16C)=221.87 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(16C) at pressure 5.043 bar as:

  H3(16C)=410.2 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 16C is calculated as:

  ω( 16C)=H2H1( 16 C)H3( 16 C)H2=391.46221.87410.2391.46=9.049

For condensation temperature of 28C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(28C) at this point is:

  Psat( 28C)=7.269 barH4( 28C)=238.84 kJ/kg

Also, H1(28C)=H4(28C)=238.84 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(28C) at pressure 7.269 bar as:

  H3(28C)=418.1 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 28C is calculated as:

  ω( 28C)=H2H1( 28 C)H3( 28 C)H2=391.46238.84418.1391.46=5.729

For condensation temperature of 40C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(40C) at this point is:

  Psat( 40C)=10.166 barH4( 40C)=256.41 kJ/kg

Also, H1(40C)=H4(40C)=256.41 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(40C) at pressure 10.166 bar as:

  H3(40C)=427.6 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 40C is calculated as:

  ω( 40C)=H2H1( 40 C)H3( 40 C)H2=391.46256.41427.6391.46=3.737

As the condensation temperature is increased, the coefficient of performance decreases.

(b)

Interpretation Introduction

Interpretation:

The effect of condensation temperature on the coefficient of performance is to be determined for different condensation temperatures assuming compressor efficiency of 75% .

Concept introduction:

Below shown diagram represents vapor-compression refrigeration cycle on a TS diagram which include four steps of the cycle. Line 12 shows a liquid which is evaporating at constant pressure and providing a means for heat absorption at constant low temperature. The vapor thus produced is then compressed to a higher pressure. It is then cooled and condensed at higher temperature by heat rejection. By an expansion process, the liquid from the condenser is returned to its original pressure. This process is carried out by throttling through a partly open valve. Due to the fluid friction in the valve there is pressure drop in this irreversible process.

The line 41 represents throttling process which occurs at constant enthalpy. The path of isentropic compression is shown by line 23' and the actual compression is shown by the line 23 where the direction of slope is in increasing enthalpy which reflects inherent irreversibility.

GEN, ORG & BIOL CHEM: CUSTOM SSC, Chapter 9, Problem 9.13P , additional homework tip  2

The equations used to calculate the heat absorbed in evaporator and the heat rejected in condenser are:

|QC|=H2H1 ...... (1)

  |QH|=H3H4 ...... (2)

The work of compression is:

W=H3H2 ...... (3)

The coefficient of performance is:

ω=H2H1H3H2 ...... (4)

The rate of circulation of refrigerant, m˙ is determined from the rate of heat absorption in the evaporator given by the equation:

m˙=|Q˙C|H2H1 ...... (5)

For Carnot refrigeration cycle, highest possible value of ω is attained at the given values of TC and TH . Due to irreversible expansion in a throttle valve and irreversible compression in the vapor-compression cycle, lower values of ω is obtained.

(b)

Expert Solution
Check Mark

Answer to Problem 9.13P

The coefficient of performance for condensation temperature of 16C is 6.786 .

The coefficient of performance for condensation temperature of 28C is 4.297 .

The coefficient of performance for condensation temperature of 40C is 2.802 .

As the condensation temperature is increased, the coefficient of performance decreases.

Explanation of Solution

Given information:

In a refrigerator, tetrafluoroethene acts as a refrigerant and operates with an evaporation temperature of 12C . Different condensation temperature for the compressor efficiency of 75% are 16C, 28C, and 40C .

From table 9.1, the values of H2, and S2 and the pressure for the saturated tetrafluoroethene at 12C are:

  H2=391.46 kJ/kgS2=1.735 kJ/(kgK)P2=1.852 bar

The compressor efficiency is given as, η=0.75 .

For condensation temperature of 16C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(16C) at this point is:

  Psat( 16C)=5.043 barH4( 16C)=221.87 kJ/kg

Also, H1(16C)=H4(16C)=221.87 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(16C) at pressure 5.043 bar as:

  H3(16C)=410.2 kJ/kg

Calculate ΔH23(16C) as:

  ΔH23( 16C)= H 3 ( 16 C)H2η=410.2391.460.75=24.99 kJ/kg

Now, calculate H3(16C) as:

  H3( 16C)=H2+ΔH23( 16C)=391.46+24.99=416.45 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 16C is calculated as:

  ω( 16C)=H2H1( 16 C)H3( 16 C)H2=391.46221.87416.45391.46=6.786

For condensation temperature of 28C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(28C) at this point is:

  Psat( 28C)=7.269 barH4( 28C)=238.84 kJ/kg

Also, H1(28C)=H4(28C)=238.84 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(28C) at pressure 7.269 bar as:

  H3(28C)=418.1 kJ/kg

Calculate ΔH23(28C) as:

  ΔH23( 28C)= H 3 ( 28 C)H2η=418.1391.460.75=35.52 kJ/kg

Now, calculate H3(28C) as:

  H3( 28C)=H2+ΔH23( 28C)=391.46+35.52=426.98 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 28C is calculated as:

  ω( 28C)=H2H1( 28 C)H3( 28 C)H2=391.46238.84426.98391.46=4.297

For condensation temperature of 40C .

The saturation pressure at point 4 is the pressure at which the vapor condenses and H4(40C) at this point is:

  Psat( 40C)=10.166 barH4( 40C)=256.41 kJ/kg

Also, H1(40C)=H4(40C)=256.41 kJ/kg

For isentropic compression,

  S3=S2=1.735 kJ/(kgK)

At point 3 , the thermodynamic state properties are defines using the saturation pressure. From figure F.2 of appendix F, follow the constant enthalpy curve of 1.735 kJ/(kgK) to get the enthalpy H3(40C) at pressure 10.166 bar as:

  H3(40C)=427.6 kJ/kg

Calculate ΔH23(40C) as:

  ΔH23( 40C)= H 3 ( 40 C)H2η=427.6391.460.75=48.19 kJ/kg

Now, calculate H3(40C) as:

  H3( 40C)=H2+ΔH23( 40C)=391.46+48.19=439.65 kJ/kg

Using equation (4), the coefficient of performance for condensation temperature of 40C is calculated as:

  ω( 40C)=H2H1( 40 C)H3( 40 C)H2=391.46256.41439.65391.46=2.802

As the condensation temperature is increased, the coefficient of performance decreases.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Knowledge Booster
Background pattern image
Recommended textbooks for you
Text book image
Introduction to Chemical Engineering Thermodynami...
Chemical Engineering
ISBN:9781259696527
Author:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart
Publisher:McGraw-Hill Education
Text book image
Elementary Principles of Chemical Processes, Bind...
Chemical Engineering
ISBN:9781118431221
Author:Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard
Publisher:WILEY
Text book image
Elements of Chemical Reaction Engineering (5th Ed...
Chemical Engineering
ISBN:9780133887518
Author:H. Scott Fogler
Publisher:Prentice Hall
Text book image
Process Dynamics and Control, 4e
Chemical Engineering
ISBN:9781119285915
Author:Seborg
Publisher:WILEY
Text book image
Industrial Plastics: Theory and Applications
Chemical Engineering
ISBN:9781285061238
Author:Lokensgard, Erik
Publisher:Delmar Cengage Learning
Text book image
Unit Operations of Chemical Engineering
Chemical Engineering
ISBN:9780072848236
Author:Warren McCabe, Julian C. Smith, Peter Harriott
Publisher:McGraw-Hill Companies, The