Concept explainers
Elliot & Hesse Inc. manufactures ergonomic devices for computer users. Some of its more popular products include anti-glare filters and privacy filters (for computer monitors) and keyboard stands with wrist rests. Over the past 5 years, it experienced rapid growth, with sales of all products increasing 20% to 50% each year.
Last year, some of the primary manufacturers of computers began introducing new products with some of the ergonomie designs, such as anti-glare filters and wrist rests, already built in. As a result, sales of Elliot & Hesse’s accessory devices have declined somewhat. The company believes that the privacy filters will probably continue to show growth, but that the other products will probably continue to decline. When the next war’s budget was prepared, increases were built into research and development so that replacement products could be developed or the company could expand into some other product line. Some product lines being considered are general-purpose ergonomie devices including back supports, foot rests, and sloped writing pads.
The most recent results have shown that sales decreased more than was expected for the anti-glare fitters. As a result, the company may have a shortage of funds. Top management has therefore asked that all expenses be reduced 10% to compensate for these reduced sales. Summary budget information is as follows.
Direct materials | $240,000 |
Direct labor | 110,000 |
Insurance | 50,000 |
90,000 | |
Machine repairs | 30,000 |
Sales salaries | 50,000 |
Office salaries | 80,000 |
Factory salaries (indirect labor) | 50,000 |
Total | $700,000 |
Instructions
Using the information above, answer the following questions.
(a) What are the implications of reducing each of the costs? For example, if the company reduces direct materials costs, it may have to do so by purchasing lower-quality materials. This may affect sales in the long run.
(b) Based on your analysis in (a), what do you think is the best way to obtain the $70,000 in cost savings requested? Be specific. Are there any costs that cannot or should not be reduced? Why?
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
Managerial Accounting: Tools for Business Decision Making 7e + WileyPLUS Registration Card
- Sigma Company produces high-quality PCs using the just-in-time (JIT) production method. The market has grown significantly overthe pastfew years and is expected to grow continuously. They are planning to launch a new model called “Epic”. The introduction of Epic will have no impact on sales of existing models as it is expected to appeal to a different segment of themarket. The company has already spent Rs.2 million on marketing the new model further requires an investment of Rs.20 million in production equipment. The project has a life of five years and the depreciation is calculated using the straight-line method. Sales and production of the Epic over its lifecycle are expected to be as follows. Year 01 02 03 04 05Units of sales 200 400 500 650 800 The selling price in Year 1 and Year 2 will be Rs. 50,000 per unit. The selling price will be reduced to Rs. 40,000 from year 3. The total variable cost of the Epic, including…arrow_forwardJohnson and Gomez, Inc., is a small firm involved in the production and sale of electronic business products. The company is well known for its attention to quality and innovation. During the past 15 months, a new product has been under development that allows users improved access to e- mail and video images. Johnson and Gomez code named the product the Wireless Wizard and has been quietly designing two models: Basic and Enhanced. Development costs have amounted to $204,000 and $285,000, respectively. The total market demand for each model is expected to be 55,000 units, and management anticipates being able to obtain the following market shares: Basic, 30 percent; Enhanced, 25 percent. Forecasted data follow. Projected selling price Per-unit production costs: Direct material Direct labor Variable overhead Projected selling price Per-unit production costs: Direct material Direct labor Variable overhead Marketing and advertising (fixed but avoidable) Sales commissions Basic $ 420.00…arrow_forwardJohnson and Gomez, Inc., is a small firm involved in the production and sale of electronic business products. The company is well known for its attention to quality and innovation. During the past 15 months, a new product has been under development that allows users improved access to e-mail and video images. Johnson and Gomez code named the product the Wireless Wizard and has been quietly designing two models: Basic and Enhanced. Development costs have amounted to $207,000 and $288,000, respectively. The total market demand for each model is expected to be 57,000 units, and management anticipates being able to obtain the following market shares: Basic, 25 percent; Enhanced, 20 percent. Forecasted data follow. Projected selling price Per-unit production costs: Direct material Direct labor Variable overhead Marketing and advertising (fixed but avoidable) Sales commissions* Problem 14-46 Part 3 Req 3A *Computed on the basis of sales dollars. Since the start of development work on the…arrow_forward
- Johnson and Gomez, Incorporated, is a small firm involved in the production and sale of electronic business products. The company is well known for its attention to quality and innovation. During the past 15 months, a new product has been under development that allows users improved access to e-mail and video images. Johnson and Gomez code named the product the Wireless Wizard and has been quietly designing two models: Basic and Enhanced. Development costs have amounted to $189,000 and $270,000, respectively. The total market demand for each model is expected to be 45,000 units, and management anticipates being able to obtain the following market shares: Basic, 20 percent; Enhanced, 15 percent. Forecasted data follow. Projected selling price Per-unit production costs: Direct material Direct labor Variable overhead Basic $ 370.00 47.00 25.00 41.00 200,000 Enhanced $ 470.00 15% 75.00 35.00 53.00 325,000 Marketing and advertising (fixed but avoidable) Sales commissions" *Computed on the…arrow_forward[The following information applies to the questions displayed below.] Mears and Company has been operating for five years as an electronics component manufacturer specializing in cellular phone components. During this period, it has experienced rapid growth in sales revenue and in inventory. Mr. Mears and his associates have hired you as Mears's first corporate controller. You have put into place new purchasing and manufacturing procedures that are expected to reduce inventories by approximately one-third by year-end. You have gathered the following data related to the changes: Inventory (dollars in thousands) Beginning of Year $585,700 End of Year (projected) $392,310 Current Year Cost of goods sold P7-7 Part 1 (projected) $7,018,984 Required: 1. Compute the inventory turnover ratio based on two different assumptions: Note: Round your answers to 1 decimal place. a. Those presented in the above table (a decrease in the balance in inventory). b. No change from the beginning-of-the-year…arrow_forwardBendOR, Inc., manufactures control panels for the electronics industry and has just completed its first year of operations. The following discussion took place between the controller, Gordon Merrick, and the company president, Matt McCray: Matt: I’ve been looking over our first year’s performance by quarters. Our earnings have been increasing each quarter, even though our sales have been flat and our prices and costs have not changed. Why is this? Gordon: Our actual sales have stayed even throughout the year, but we’ve been increasing the utilization of our factory every quarter. By keeping our factory utilization high, we will keep our costs down by allocating the fixed plant costs over a greater number of units. Naturally, this causes our cost per unit to be lower than it would be otherwise. Matt: Yes, but what good is this if we are unable to sell everything that we make? Our inventory is also increasing. Gordon: This is true. However, our unit costs are lower because of the…arrow_forward
- [The following information applies to the questions displayed below.] Mears and Company has been operating for five years as an electronics component manufacturer specializing in cellular phone components. During this period, it has experienced rapid growth in sales revenue and in inventory. Mr. Mears and his associates have hired you as Mears's first corporate controller. You have put into place new purchasing and manufacturing procedures that are expected to reduce inventories by approximately one-third by year-end. You have gathered the following data related to the changes: Inventory Cost of goods sold (dollars in thousands) Beginning of Year $585,700 End of Year (projected) $392,310 Current Year (projected) $7,018,984 P7-7 Part 2 2. What is the effect of the projected change in the inventory balance on cash flow from operating activities for the year? Effect of change in inventoryarrow_forwardWildhorse Delivery is a rapidly growing delivery service. Last year, 80% of its revenue came from the delivery of mailing "pouches" and small, standardized delivery boxes (which provides a 20% contribution margin). The other 20% of its revenue came from delivering non-standardized boxes (which provides a 70% contribution margin). With the rapid growth of Internet retail sales, Wildhorse believes that there are great opportunities for growth in the delivery of non-standardized boxes. The company has fixed costs of $13,868,100. Sales mix is determined based upon total sales dollars. (a) What is the company's break-even point in total sales dollars? At the break-even point, how much of the company's sales are provided by each type of service? (Use Weighted-Average Contribution Margin Ratio rounded to 2 decimal places e.g. 0.22 and round final answers to O decimal places, e.g. 2,510.) Total break-even sales $ Sale of mail pouches and small boxes 24 Sale of non-standard boxes $arrow_forwardEthel Company manufactures and sells desk lamps for hotel and motel rooms. Last year, it sold 200,000 units of its model Y lamp for $53 per unit. The company estimates that this volume represents a 25 percent share of the current market. The market is expected to increase by 8 percent next year. Marketing specialists have determined that as a result of new competition, the company’s market share will fall to 20 percent (of this larger market). Due to changes in production costs and competitive models, the new price for the lamps will be $56 per unit. The revised volume estimates are based on the $56 price. Required: Estimate Ethel Company’s sales revenues from model Y lamps for the coming year.arrow_forward
- Techno Ltd manufactures components for laptop computers. One of its top selling products is the new solid-state drive, the Solix, which will offer improved speed and performance. Earlier this year, a Taiwanese company entered the market offering a similar drive at a price 10% below the Solix price of $400 per unit. Techno Ltd is currently achieving its target profit margin of 30% on all of its products. Required: 1. What target cost would have to be set for the Solix drive to remain competitive and meet the requirements of the company’s target profit margin? 2. Calculate the cost reduction objective. 3. Outline two cost management techniques Techno Ltd could apply to achieve the cost reduction objective.arrow_forwardPremium Corporation believes that there is a market for a portable electronic toothbrush that can be easily carried by business travelers. Premium's market research department has surveyed the features and prices of electronic brushes currently on the market. Based on this research, Premium believes that $75 would be about the right price. At this price, marketing believes that about 78,000 new portable brushes can be sold over the product's life cycle. It will cost about $1,170,000 to design and develop the portable brush. Premium has a target profit of 25% of sales. Requirement 1. Determine the total and unit target cost to manufacture, sell, distribute, and service the portable brushes. Requirement 1. Determine the total and unit target cost to manufacture, sell, distribute, and service the portable brushes. Begin by computing the total target cost to manufacture, sell, distribute, and service the portable brushes, then compute the unit target cost to manufacture, sell, distribute,…arrow_forwardBliss Bar is a company that sells deluxe chocolate and candy bars based in Illinois. The company is considering launching a new product line featuring protein bars coated with their deluxe chocolate flavors. Bliss Bar has spent $75,000 developing a new protein bar line as a part of the company’s product diversification plan. It also spent another $40,000 for market research on flavors to produce. Based on market research, Bliss Bar expects first year sales of 1,200,000 protein bars at a price of $2.45 per unit with an expected annual growth of 3% in sales volume each year of the six-year project. The variable costs per unit are $0.80, and the annual fixed costs are $30,000. Bliss Bar estimates that the net working capital will be 8% of next year’s sales. The launch of this new product line is expected to cannibalize the sales of an existing candy bar, Choco-O! by 10,000 units per year. Choco-O! is sold at a price of $2 per unit and has variable costs of $0.50 per unit. To expand…arrow_forward
- AccountingAccountingISBN:9781337272094Author:WARREN, Carl S., Reeve, James M., Duchac, Jonathan E.Publisher:Cengage Learning,Accounting Information SystemsAccountingISBN:9781337619202Author:Hall, James A.Publisher:Cengage Learning,
- Horngren's Cost Accounting: A Managerial Emphasis...AccountingISBN:9780134475585Author:Srikant M. Datar, Madhav V. RajanPublisher:PEARSONIntermediate AccountingAccountingISBN:9781259722660Author:J. David Spiceland, Mark W. Nelson, Wayne M ThomasPublisher:McGraw-Hill EducationFinancial and Managerial AccountingAccountingISBN:9781259726705Author:John J Wild, Ken W. Shaw, Barbara Chiappetta Fundamental Accounting PrinciplesPublisher:McGraw-Hill Education