Apparatus

https://pubmed.ncbi.nlm.nih.gov/32521345/ In the literature review, they should present the system installed and the main results obtained. In other words, the enhancement due to the installed system. They have to define the system used in this study. (the report talking about ventilation) pls in briefly Don’t using chatgpt please urgent i will give u like

EXPERIMENT -1- TEMPERATURE MEASUREMENT AND CALIBRATION Discussion 1-What are type of thermocouple? 2-What is the difference between the alcoholic and the mercury thermometer? 3-Draw diagram to clarify a relationship between the temperature and a millivolemeter? 4-State any possible error source in the experiment? 5-State any suggestions to improve the experiment?

please help me answer this question with complete solution and figure. i promise to give high rating, thank you very much.

H.W 5: A thermometer is used for the range of 200 to 400-F, and it is stated that its accuracy is one-quarter of 1 percent. What does this mean in terms of temperature?

PLEASE ANSWER THEM ALL FOR AN UPVOTE. THANK YOU. Given: Pi constant to be used: 3.14159 Capillary tube: radius = 0.02 cm; length = 9 cm; pressure = 0.7 mmHg Liquid sample: density = 4 ml; time of flow = 4.5 seconds Ans. the ff questions. •What is the pressure in MKS unit? •What is the pressure in CGS unit? •What is the viscosity of the liquid? • If the weight was given as 8.5 grams, what will be the density of the liquid? •What is the kinematic viscosity of the liquid? •What is the fluidity of the liquid?

Suppose that you have designed a portable compressed-air supply system, as shown in the figure below,for filling scuba tanks and for driving pneumatics tools in garages and factories.The system consists of an electric motor, an air compressor, an air tank, a regulator and a pressure-reliefsafety valve.The regulator contains a pressure sensor connected to a power switch. The motor is switched on whenthe tank pressure drops bellow a fixed value and off at a slightly higher pressure. The pressure-reliefvalve is set to open at a higher pressure than the regulator motor off-pressure.Explosion of the tank is clearly a dangerous hazard. Three events are assumed to possibly lead to a tankexplosion:1. an internal tank defect such as poor welding2. an external cause such as a plant vehicle colliding with the tank3. Excess pressure in the tank. The excess pressure can occur only if both the control unit and thepressure-relief valve fail:The pressure sensor might fail to shut oof the motor because…

1.With a neat diagram ,explain about the working of liquid in glass Thermometer Sensor to measure the Temperature .

please write clearly if handwritten so that I could read and understand the solutions and steps taken

analyze the effect of the density of both liquids to the vertical height of the liquid B

can you help me with part b) please

from this video: https://youtu.be/UvMmfacVA24 COntext: From the first setup where there is no newspaper present, the ruler fell down easily as I do a quick karate chop. In the second setup where there a sheet of newspaper over the ruler that is on the table, the ruler broke as I karate chop the ruler because of the atmospheric pressure present below and above the paper. When the paper was suddenly forced up by the ruler. A low pressure forms under the paper like a vacuum sucking the paper down and resulted in the ruler cutting in half. Explain the difference in the results of the setups using concepts about fluids. Use schematic diagrams/FBD if needed.

Which thermometer would be better suited to measuring the temperature of molten lead at 650 K?  mercury, alchol, thermistor, or optical

2. draw a schematic for problem

Please write solution neatly and if scanning pages, please make sure the writing is distunguishable from the background. Please use graph attached. Thanks I'll give positive feedback

2- Describe and discuss the following using your own words (maximum of half a page for each): A-The importance, types, components, and advantages of pipelines B- International standards related to the pipelines C- Sizing and material selection of pipes D- Pump troubleshooting related to the cavity, recirculation, and air entrainment

i need the answer quickly

i need the answer quickly

https://us.humankinetics.com/blogs/excerpt/managing-air-pollution-for-athletes In the literature review, they should present the system installed and the main results obtained. In other words, the enhancement due to the installed system. They have to define the system used in this study. (the report talking about ventilation) pls in briefly Don’t using chatgpt please urgent

https://us.humankinetics.com/blogs/excerpt /managing-air-pollution-for-athletes In the literature review, they should present the system installed and the main results obtained. In other words, the enhancement due to the installed system. They have to define the system used in this study. (the report talking about ventilation) pls in briefly Don't using chatgpt please very urgent

3.3 What are the measurement units of noise? How can we measure the sound pressure level of the noise generated by a machine?

(B): Consider the measuring instrument of Anemometer shown in the Figure 4 and answer the following questions: 1. Identify the measured quantity, the physical effect and the opposing effect of the instrument of Anemometer. 2. Is the instrument of Anemometer considered as a passive or an active transducer? Clarify your answer with diagram. Note: the generator consists of coil and permanent magnetic field inside. Revolving Cups Generator Figure 4

can you help me with part a) please

Dont attempt if u have already attempted this question. Otherwise dislike. I need a new unique answer

What Will Happen If You Put Peeps in a Vacuum Chamber? - Easter Special. How is explaining why the PeepsTM get bigger in the vacuum chamber?  What gas law is demonstrated in this demo?  And just for fun do you love Peeps or do you hate them? https://www.youtube.com/watch?v=EYiIi5C-BfY

None

4 - What is the effect of the change in atmospheric pressure on the air temperatures of the air above a water surface? 5. What are the number of pressure measuring devices used in the field of refrigeration and air conditioning with the explanation? 6 - If we replaced water or air instead of mercury, how high would the column with water or air be?

Describe the concepts of independent, dependent, and extraneous variables using the illustration of a pressure measurement system.

On a cold winter day, you turn up the thermostat in your house. Assume that your house is well sealed and that no air enters or leaves the house. When the air temperature in your house rises a short while later, what statement is correct regarding the air pressure? Question 10 options:   The air pressure does not change at the higher temperature.   The air pressure increases at first but then decreases again as the temperature approaches its higher value.   The air pressure is lower at the higher temperature.   The air pressure decreases at first but then increases again as the temperature approaches its lower value.   The air pressure is higher at the higher temperature.

Three types of fluids stack in an open tank as shown in the plot.  Select the expression of the gage pressure at location 2, P2(gage)=______       A.     B.     C.     D. patm