Q1 Answer the following (True / False):1- The water jet force exerted on a vertical plate is half the jet force exerted on a 60 degreetilted plate. (True / False)2- Frances turbine casing has a spiral shape to increase water pressure (True / False)3- Bernoulli equation can be written as: P/pg+ v°/2g + Z, the second term of the equation isthe kinetic energy (True / False)4- Fans are type of fluid machines in which the work is done by the fluid (True / False)5- The purpose of the regulator in Pelton turbine is to control water pressure (True / False)6- The casing part of Pelton turbine affects the pressure of the flow (True /False)7- Frances turbine is used when little amount of water is available (True / False)8- The water at the inlet of Pelton turbine possess pressure and kinetic energy (True / False)9- Kaplan turbine is used when high head of water is available (True / False)10- The modern type Frances turbine is axial and radial flow turbine (True / False)

Note: Since you have posted a question with multiple sub-parts, we will solve the first three…

1- The water jet force exerted on a vertical plate is half the jet force exerted on a 60 degree tilted plate. (True / False) 2- Frances turbine casing has a spiral shape to increase water pressure (True / False) 3- Bernoulli equation can be written as: P/pg+ V/2g + Z, the second term of the equation is the kinetic energy (True / False)

1- The water jet force exerted on a vertical plate is half the jet force exerted on a 60 degree tilted plate. (True / False) 2- Frances turbine casing has a spiral shape to increase water pressure (True / False) 3- Bernoulli equation can be written as: P/pg+ V/2g + Z, the second term of the equation is the kinetic energy (True / False)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An incompressible fluid of density ? and viscosity ? flows through a curved duct that turns the flow 180°. The duct cross-sectional area remains constant. The average velocity, momentum flux correction factor, and gage pressure are known at the inlet (1) and outlet. (a) Write an expression for the horizontal force Fx of the fluid on the walls of the duct in terms of the given variables. (b) Verify your expression by plugging in the following values: ? = 998.2 kg/m3, ? = 1.003 × 10−3 kg/m·s, A1 = A2 = 0.025 m2, ?1 = 1.01, ?2 = 1.03, V 1= 10 m/s, P1,gage = 78.47 kPa, and P2,gage = 65.23 kPa
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. include your free body diagram A.12.74 m B.-4.67 m C.-2.72 m D.2.56
A pipe has a cross-sectional area of 16.5cm2 at point A, where the speed of the fluid (water) is 1.2 m/s and the pressure is 2.00 atm. The pipe ascends 3.00 m and narrows to 8.20 cm2 at point C. a) what's the speed of the fluid at point C. b) what's the absolute pressure at point C.
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. ( WITH FREE BODY DIAGRAM ) CHOIECES: A.2.56 B.-2.72 m C.12.74 m D.-4.67 m
1) A steady, incompressible fluid flow through two identical pumps in series, the volume flow rate through the two pumps is equal to V1˙+V2˙. True or False 2) When calculating efficiency, equations for pump and turbine are the same, and both efficiencies should be less than 1. True or False
A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1= 20.2 cm and the pressure is known to be P1= 7.00×104 N/m2 above atmospheric pressure. a. If the pipe carries the water 3.5 meters up hill without any change in diameter, what is the new absolute pressure within the pipe? b. After flowing up the hill described above, the pipe narrows to 80% of its original radius, what will be the new water velocity (v2) in the pipe? c. What will be the absolute pressure (P3) in the smaller pipe? d. What is the volume flow rate through the smaller pipe?
please I need an answer for this A water jet is deflected 180 degree in a curved vane with diameter of 25.5mm and velocity of jet of 6.5m/s. Determine the force that the jet exerts on the stationary vane Group of answer choices 234 23.4 43.2 34.2
Two pumps (Pump A and B) have performance curves which can be approximated by the following equations: H_A = 340 - (1.2(Q^2)), in feet H_B = 360 - (2.5(Q^2)), in feet where Q is in ft^3/s. If pumps A and B were to operate in parallel as depicted in the figure below, at what head (in ft.) should either pump be operated?
choose the correct answer Q1A- If the viscose force is dominate in Reynolds number, the flow will be: * a) Laminar flow b) Turbulent flow c) Transition flow d) All the answers Q1B- Chézy and manning equations are controlled in design of : * a) Water pipes network b) Open channels c) Water jet applications d) None of all above
A tank half full of water is accelerated to the right at 9.81 m/s^2. If the motion is laong the side with a length of 4 m, the water surface on the rear wall will: a. rise 2 m b. rise 1.5 m c. drop 2 m d. drop 1.5 m
(Just Question a.) A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1= 20.2 cm and the pressure is known to be P1= 7.00×104 N/m2 above atmospheric pressure. If the pipe carries the water 3.5 meters up hill without any change in diameter, what is the new absolute pressure within the pipe? After flowing up the hill described above, the pipe narrows to 80% of its original radius, what will be the new water velocity (v2) in the pipe? What will be the absolute pressure (P3) in the smaller pipe? a. What is the volume flow rate through the smaller pipe?
A 150 mm diameter open circular cylinder is 1 m long and contains water up to a height of 0.7 m. Estimate the speed at which the cylinder may be rotated about its vertical axis so that the axial depth becomes zero. a. 249. b. 163.93 c. 564 d. 296