12 g of compound “Y” dissolves in 10 ml of acetone at 25 0C and 0.85 g of the same compound dissolves in 10 ml of boiling acetone. If 5.0 g of compound “Y” were to be recrystallized from 75 ml acetone, what will be the next maximum amount of “Y” that will be recrystallized?

Q: Cis-2- pentene and ethanol were added to an aqueous solution of bromine in two separate conical…

A: Alkenes react with a solution of bromine in CCl4 solution to form a dibromo alkane in this reaction…

Q: 1. If the freezing point of the solution is recorded 0.2°C lower than the actual freezing point,…

A: Qus-1   If calculated freezing point lowering is less than actual one then calculated molality will…

Q: . A mixture of two liquids with the boiling point of 65 oC and 73 oC has been subjected to…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A mixture of solvents contains 5 mol of solvent A and 10 mol of solvent B. Partial molar volume of…

A: Partial molar volume of components is categorized to be extensive property that changes with…

Q: A solution of cyclohexane-toluene mixture was distilling at 88 oC. The analysis of a sample of the…

A:

Q: 7.A student carried out a fractional distillation of an unknown binary (2-component) mixture from a…

A: Answer - According to the question - Given - We can see in the graph that we have shift in…

Q: A mixture of 5.0 g A, 5.0 g B, and 5.0 g C were separated by recrystallization using ethyl acetate…

A: Given, mass of A = 5 g, B = 5g and C = 5 g. table :  A : cold = 1.7,hot = 2.5              B: cold =…

Q: 4. Draw a boiling point-composition diagram for an ideal binary solution. With the aid of the…

A: Let a be the point where starting composition of the solution to be distilled. Let b be the vapor…

Q: How much sugar will dissolve in 1500 g water at 90C? If the saturated liquid solution in part (a) is…

A: Solubility is defined as the amount of solute present per unit amount of solution or solvent at a…

Q: State whether you would want to use a fractional or simple distillation for each of the cases below.…

A: A). We use fractional distillation when the difference between boiling points of components is less…

Q: Sodium chloride (NaCl) was isolated from SiO2 and CaCO3 by dissolving it in distilled water.…

A: It is mentioned that CaCO3 is slightly soluble in water to about 0.001g/100mL.

Q: The separation and purification processes given below and the method used against them are given.…

A: The process in which the separation of components from the mixture of liquid by using the…

Q: * Module 3: In his experiment, Mashiho wanted to determine the molar mass of his unknown sample.…

A:

Q: The vapor pressure of 2-propanol (60.096 g/mol) is 50.00 kPa at 338.8 °C, but it fell to 49.62 kPa…

A:

Q: The solubility is 12.8g in 100mL of ethanol at 0 degrees C, and 46.4 g in 100mL of ethanol at 60…

A: Given, the solubility is 12.8g in 100mL of ethanol at 0 degrees C and 46.4 g in 100mL of ethanol at…

Q: Calculate the molar mass of unknown that is nonvolatile and nonelectrolyte, which is dissolved 0.20g…

A: Mass of unknown = 0.20 gVolume of cyclohexane = 10 mLDensity of Cyclohexane = 0.779 g/mLMass of…

Q: In an alternate procedure, a 0.50 M nickel (II) nitrate solution was used to prepare the standard…

A: Given : Concentration of nickel (II) nitrate i.e Ni(NO3)2 stock solution = 0.50 M Volume of Ni(NO3)2…

Q: A mixture of 6.0 g acetinilide and 4.0 g aniline is to be separated using 100 mL of water as…

A: Amount of acetanilide in mixture before separation = 6.0 g        Amount of aniline in mixture…

Q: Is it true or false to say that X and Y will form an azeotrope? OFalse OTrue A solution with a mole…

A: An azeotrope is a mixture of two or more liquids which displays the same level of concentration in…

Q: Given that the molecular weight of glucose is 180.16, show how you would prepare 50ml of a 50mM…

A: Molecular weight = 180.16 g/mol

Q: Aniline and water can be treated as being immiscible. A mixture of these two liquids boiled at 98°C…

A: The partial vapor pressure of the phenylamine is; PTotal=Pwater+PAnilinePAniline=101.37 kPa-94.30…

Q: Describe how to prepare  100 mL of approximately 60% (w/v) NaOH from solid NaOH

A: Given :-  %(w/v) of NaOH solution = 60%  Volume of solution = 100 mL  To describe :-  Its…

Q: 11) A distillation is set up between molecule A (vapor pressure 0.781 atm) and molecule 8 (vapor…

A: Here we have to determine the mole fraction of A and B in the initial liquid mixture. It can be…

Q: Explain the simple distillation process in 10 sentences Enumerate all the apparatus used in the…

A: Simple distillation is the process in which two liquids can be separated out from the solution…

Q: 0.010 mL of 0.1M Fe(II) is mixed with 9.990 mL of 0.1M Fe(III). What is the mole fraction of Fe(II)?

A:

Q: What limitations are encountered in the application of sublimation as a general method of…

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: At 90°C, the vapor pressure of pure 1,2-dimethylbenzene (orthoxylene) is 20 kPa and that of pure…

A:

Q: A mixture of 5.0 g A, 5.0 g B, and 5.0 g C were separated by recrystallization using ethyl acetate…

A: To calculate percent purity and percent recovery of the purified crystal after one recrystallization

Q: While performing a distillation to separate two liquids , a small fraction was collected at 70-73°C,…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the ionic strength of the plasma-substituting 0.89% NaCl solution, the density of the…

A: We have to find ionic strength of NaCl

Q: An analyst wanted to separate an essential oil which is partially immiscible in water and a boiling…

A: When there is a difference between the boiling points of components present in the liquid mixture…

Q: In a lab test, a student in CHEM 2102 was provided with a solution of compound B (0.16 mol of B was…

A: Given information: Moles of B = 0.16 mol Density of solvent = 1.20 g/mL Volume of solvent = 100.0 mL…

Q: Suppose that you have a 1:1 mixture of compounds that is comprised of compound X and compound Y. You…

A: The amount of solute which can be dissolved in given amount of solvent is termed as its solubility.…

Q: How many milliliters of a 17% w/v concentrate of benzalkonium chloride should be used in preparing…

A:

Q: True or False: In this experiment, freezing point depression should be positive when the freezing…

A: The given expression is,                  ∆Tf  = f.p.pure solvent - f.p.solution Where, ∆Tf is the…

Q: Assume that the solubility of compound X in water is 4.0 g/100 mL and in ether it is 16.0 g/100 mL…

A: Nernst’s distribution law The Nernst’s distribution law suggests that the distribution of a solute…

Q: In the preparation of 1,200 mL of 70% alcohol from stock absolute alcohol solution, what is the…

A: Here we will consider v/v % concentration, i.e. 70 % alcohol solution implies out of 100 mL solution…

Q: An impure sample of 250 mg of adipic acid was recrystallized from 2.0 mL of boiling water. The…

A: The solubility of adipic acid at zero degree centigrade is 0.3 g of adipic acid required 100 mL of…

Q: Partial molar volumes of acetone and chloroform in their equimolar (0.5/0.5 molar fractions) mixture…

A: Given: Partial molar volume of acetone = 74.2 cm3 mol-1 Partial molar volume of chloroform = 80.2…

Q: A student dissolved 20 mg of caffeine in 20 mL of water. The student carried out two extractions…

A:

Q: Question 1. a) You think that you have isolated a substance A in the lab. It melts at 75 – 77C.…

A: Melting point of a compound is the temperature at which its liquid state and vapour state are in…

Q: A nearly saturated solution of 0.40 g L-ascorbic acid in 75 mL water is to be extracted into 75 mL…

A: Given the K value for the solubility of the compound in diethyl ether compared to water, K = 5…

Q: 1. You are given a substance that is equally soluble in water and hexane (two immiscible solvents).…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: When a solution of 1.00 g of ‘X’ in 100 ml of water was shaken with 10 ml of diethyl ether, 0.60 g…

A: Introduction: Extraction is a type of separation process used to separate the liquids or solids from…

Q: 1. Assuming that sand and sodium chloride are the impurities in a sample of benzoic acid, state…

A: A mixture is a substance that is made up by mixing more than two compounds or substances together.…

Q: Fractional distillation of the 50:50 mixture of two miscible liquids gave the following distillation…

A: Fractional distillation is a method to separate two miscible liquids which have boiling point close…

Q: 1. List the order of IMF's (lowest to highest) of the organic liquids you used in part 1. Explain…

A: IMF is intermolecular forces present in the molecules such as vanderwaal forces , hydrogen bonding,…

Q: Answer the following questions. If 50.0 mL of Thiosulfate solution are required to titrate the l2…

A:

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.