# 3.2. Calculate densities in lbm/ft3 of the following substances: (a) a liquid with density of 995 kg/m3. Use (i) conversion factors from the table on the inside front cover and (ii) Equation 3.1-2 (b) a solid with a specific gravity of 5.7. What did you assume to come up with your answer? 2

Q: Convert a speed of 251 cm/s to units of inches per minute. Also, show the unit analysis by dragging…

A: We have to convert speed in inch/meter.

Q: A 5-gram sample was placed in a graduated cylinder filled with water, where a rise of 4.5 ml was…

A: When the sample was placed in the graduated cylinder then a 4.5 ml rise was observed. Hence the…

Q: 5. Ipil-ipil leaves will be dried in a moving train of tray dryers. The wet leaves containing 75%…

A: A question based on dimensional analysis that is to be accomplished.

Q: Q1. A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing…

A:

Q: Esall 0/50/ved its Volume (4L) His focusfooing Nagl from sodiumchloride it was related 3. by a daing…

A: Calculating the molarity of a diluted solution by using an equation given by dilution law: M1V1=M2V2…

Q: Hot mix asphalt (HMA) is commonly used in the construction of roadways in the United States at a…

A:

Q: ghs 68 kg is 45 years old and has severe hypomagnesaemia. m sulfate heptahydrate to be given…

A: According to the question, Jack who weighs 68 kg is 45 years old and has severe hypomagnesaemia. He…

Q: 3.3. The specific gravity of gasoline is approximately 0.70 (a) Estimate the mass (kg) of 50.0…

A: (a)Specific gravity of gasoline, d = 0.7 g /ccVolume of gasoline, V = 50 L = 50000 mL

Q: Q3/ The solubility of sodium chloride NaCl in water at 290 K is 35.8 kg / 100 kg of water. Express…

A:

Q: a) State TWO (2) differences between those two calibration curves. b) State THREE (3) limitations…

A: A calibration curve or standard curve is a technique that finds out the strength of any substance…

Q: The column was packed with 12 g of alumina. A 50:50 mixture of ferrocene and acetylferrocene was…

A: The experiment is about analyzing a mixture of ferrocene and acetylferrocene, quantitatively.

Q: Convert a speed of 751 cm/s to units of inches per minute. Also, show the unit analysis by dragging…

A:

Q: Amylum, commonly known as starch is a white powder with variable molecular formula due to the…

A: The number of moles of amylum, CO2, and water is determined as follows.…

Q: (c) The ore being placed on the heap has an average copper grade of 1.0% and the lixiviant addition…

A: The average recovery of the copper from the heap leaching is 90%.

Q: a tank is filled with 100 liters of pure water. Brine carrying six grams of salt per liter enters at…

A:

Q: A solution composed of 50% ethanol (ETOH), 10% methanol (MEOH), and 40% water (H20) is fed at the…

A: Given: 50% ethanol,10 % methanol and 40 % water assuming no reaction in=outso starting with the…

Q: 3-28 A 1.8-m3 rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and…

A: Introduction: In the above question two phases coexist in equilibrium ,thus we have a saturated…

Q: Convert a speed of 245 cm/s to units of inches per minute. Also, show the unit analysis by dragging…

A:

Q: The total amount excreted into urine as unchanged drug after an oral tablet (A) of 50 mg was 36.4…

A: The term bioavailability means the amount of concentration available in systemic circulation after…

Q: Trial 1 Trial 2 Trial 3 Mass of solution 29.824 g 29.855 g 29.816 g Volume of solution 25.00…

A: The relative average deviation (RAD) of a data set is defined as a percentage that shows the…

Q: Convert a speed of 129 cm/s to units of inches per minute. Also, show the unit analysis by dragging…

A: The unit conversion can be done by multiplying or dividing the given units by appropriate numbers.…

Q: 5ml of water is used to extract NO ‐1 from A wet soil sample weighing 10 grams. Another sample of…

A: IMPORTANT POINTS. The language of the question is a little ambiguous because of which the question…

Q: Convert a speed of 575 mi/h to units of feet per minute. Also, show the unit analysis by dragging…

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: If 35,000 kg of whole milk containing 4% fat is to be separated in a 6-hour period into skim milk…

A: Given, Mass of whole milk = 35000 kg. % of fat = 4 Time period = 6 hours Skim milk fat = 0.46 %…

Q: the injector is kept at higher temperature than the column so that it will move quickly. If the…

A: A multiple choice question based on analytical separations that is to be accomplished.

Q: Ethyl alcohol (C2H5OH) may be prepared by the fermentation of glucose (C6H12O6) as indicated by the…

A: Ethyl alcohol (C2H5OH) is prepared by the fermentation of glucose (C6H12O6) as indicated by the…

Q: Medicare does not cover the cost of this prescription medicine, which currently averages $297.78 per…

A: Given, Theoretical yield for the pure barium sulfate you were transferring was 500.00kg. The…

Q: 1. Estimate the density of a 25-API gravity dead oil at 100 F.

A: GIVEN:- Estimate the density of a 25-API gravity dead oil at 100 F.

Q: An orange juice processing plant now produces essential oil from orange peels. one It is known that…

A: Here, it is given that during the production of essential oil from orange peels, 250 kg of peel…

Q: What's 3 products available on the market where its specific gravity must be measured with picture…

A: 3 products available on the market where its specific gravity must be measured: 1) Gems (to decide…

Q: xample of the dilution of Drink #1 to give you a visual idea of this dilution step Some volume was…

A:

Q: Ethyl alcohol (C2H5OH) may be prepared by the fermentation of glucose (C6H12O6) as indicated by the…

A:

Q: An aqueous solution of sodium hydroxide contains 20.0% NaOH by mass. It is desired to produce an…

A:

Q: Some experts says that km can be calculated by saying Vmax from date divided by 2 and then they find…

A: We can calculate the approximate value of Km both from the graph and by solving the MM equation.

Q: For an ideal gas, classify the pairs of properties as dircctly or inversely proportional. Directly…

A:

Q: B'. Percent Water in a Hydrate [& # Waters per Formula Unit], Raw Data from Virtual Data Set Raw…

A: To determine the formula of hydrated salt we determine molar ratio of anhydrous salt and water.

Q: 4. Several process variables streams are shown below. Compute the indicated quantities in terms of…

A:

Q: Balancing Exit Ticket Fill in each blank with the appropriate coefficient. C + v H2S Au2S3 H2--> v…

A: A chemical reaction equation which contains same number of atoms on both reactant and product side…

Q: In the distillation of the mixture of acetic acid (MW=60.05 g/mole; d=1.05g/ml) and water (MW= 18.00…

A: Density of acetic acid = 1.05 g/ml Density of water = 1.00 gm/ml Molarity of NaOH = 1.00 M Volume…

Q: Q1. Amylum, commonly known as starch is a white powder with variable molecular formula due to the…

A: The empirical formula is the simplest ratio of the elements present in the molecular formula while…

Q: Coming homo after the end of the winter semostor, you find that your family's swimming pool has not…

A: Solution - According to the question - Given - take whole swimming pool as a control volume. given…

Q: the injector is kept at higher temperature than the column so that it will move quickly. If the…

A: In the given problem we have to check whether the given two statements are correct or not in…

Q: Convert a speed of 973 cm/s to units of inches per minute. Also, show the unit analysis by dragging…

A: The conversion units required are 1S = 160 min 1cm = 12.54 in

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

- Downvoted for wrong solution. A river is carrying water containing 2000 mg/l Magnesium Chloride into a small lake. The lake has a naturally occurring Magnesium Chloride of 50 mg/l. If the river flow is 2500 Lmin and the lake flow rate is 1.5 m³.sec¹, what is the concentration of MgCl2 in the lake after the discharge point? Assume that the flows in the river and lake are completely mixed, that the salt is a conservative substance, and the system is at steady state.You are absolutely the BEST. Finally someone that dosen't calculate this exercise as 836f66dgsffjgvkik!!!! I understand everything you did, but I have one question. Some experts says that km can be calculated by saying Vmax from date divided by 2 and then they find Km by going down on x-axis on the graph. But, you used the MM equation, to solve for Km. Is both method the same? Or is one of them more precise than the other? *And if theres no need to reply back after you answering my question, then I will thank you again for your help. I have more these types of exam questions that I will probably upload later, and I hope someone like you will look at it.1. Estimate the density of a 25-API gravity dead oil at 100 F.
- Ethyl alcohol (C2H5OH) may be prepared by the fermentation of glucose (C6H12O6) as indicated by the equation: yeastC6H12O6 ----> C2H5OH + CO2 74.12 mL of ethyl alcohol (specific gravity = 0.790) was collected by this fermentation pro- cess. What mass of glucose was used? SET-UP: Answer:4. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value.There's 1 drink (and you are asked to determine the glucose concentration in the drink in the units of g/100mL. (Why these units? Well, once you have the concentrations in g/100mL you will be able to compare your values with the nutritional values given on the drink bottles’ labels). The sample of the drink was diluted 1/100 (i.e. by a factor of 100). This was an essential step in the method because, without it, the machine used to analyse the glucose concentration (spectrophotometer) would have given an error as the concentration would have been too high for accurate detection. What this means for you is that the dilution factor will need to be taken into consideration in your calculations (remember the aim is to calculate the concentration in the original drink and not in the diluted drink). You measured the concentration of their diluted drink using the spectrophotometer and their results were provided to them in the units mM (millimolar). Glucose Concentration in mM of drink =…
- There's 1 drink (and you are asked to determine the glucose concentration in the drink in the units of g/100mL. (Why these units? Well, once you have the concentrations in g/100mL you will be able to compare your values with the nutritional values given on the drink bottles’ labels). The sample of the drink was diluted 1/100 (i.e. by a factor of 100). This was an essential step in the method because, without it, the machine used to analyse the glucose concentration (spectrophotometer) would have given an error as the concentration would have been too high for accurate detection. What this means for you is that the dilution factor will need to be taken into consideration in your calculations (remember the aim is to calculate the concentration in the original drink and not in the diluted drink). You measured the concentration of their diluted drink using the spectrophotometer and their results were provided to them in the units mM (millimolar). Glucose Concentration in mM of drink =…CALCULATE Vmax and KM values of the reaction as shown below ON LB PLOT Please don't provide handwriting solutionFind the Vm value by considering the following curve
- A mixture of ethanol (ethyl alcohol) and water contains 40.0% water by mass.(a) Assuming volume additivity of the components, estimate the specific gravity of themixture at 20°C. What volume (in liters) of this mixture is required to provide 150 mol ofethanol?(b) Repeat Part (a) with the additional information that the specific gravity of the mixture at20°C is 0.89045 (making it unnecessary to assume volume additivity). What percentage errorresults from the volume-additivity assumption?Hello, can someone please help me? I have already hand graphed 1 and 2 and found the v max, however I cannot find the Km value. I am confused because the plots on the linear weaver burk plot do not extend past the values that make up the line. So how am I supposed to estimate the value for the y-intercept in order to find the Km value1. You give your home health patient an unopened 500-mL bottle of guaifenesin and tellthem to take 2 teaspoons 4 times a day as ordered. They ask you how long the bottlewill last. 2. You are shadowing a nurse during a clinical who receives an order to adjust the infusionrate of a pump so that 1.6 mg of lidocaine are being delivered per minute. Hanging is a100 mL piggyback containing 0.4 grams lidocaine, a 0.4% solution. How many mL perhour should the piggyback be set to deliver? How long will the piggyback last? 3. Phenobarbital 180 mg/m 2 /24 hours given every eight hours is ordered for a childwhose BSA (body surface area) is 0.29 m 2 . How many mg will you need if the child willbe on the medication for 10 days? 4. You are going to mix a 1:10 bleach solution with water to make 500 mL of a 1:35 bleachsolution. How much 1:10 bleach solution should you use?(I recommend using the C1V1=C2V2 formula) 5. As a home health nurse you need to help a client make…

- SEE MORE QUESTIONS