A 60-Hz full-wave rectiﬁer is built with a transformer having an rms secondary voltage of 20 V and ﬁlter capacitance C =150,000 μF. What is the largest current that can be supplied by the rectiﬁer circuit if the ripple must be less than 0.3 V?

A 60-Hz full-wave rectiﬁer is built with a transformer having an rms secondary voltage of 20 V and ﬁlter capacitance C =150,000 μF. What is the largest current that can be supplied by the rectiﬁer circuit if the ripple must be less than 0.3 V?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 1PP: Inductive Circuits Fill in all the missing values. Refer to the following formulas:...

See similar textbooks

Related questions

Q: A three-phase bridge rectifier uses diodes rated at IdRMS = 145, VRRM =1000V and VD=0.7V. The…

A: Given: A three-phase bridge rectifier uses diodes rated at IdRMS=145 AVRRM=1000 VVD=0.7 V The…

Q: Q2) Design a CT-FWR to supply a load of (502) with a waveform of the following specifications: - •…

A: In this question we will find FWR parameters... Note:- due to bartleby policy , I will answer 3…

Q: 3) For the Half-Wave Rectifier circuit shown below, determine: the Transformer Turns ratio, n [ IEEE…

Q: A single-phase full-wave transistor rectifier feeds power to motor load. The source voltage is 230V,…

A: In this question we will find average value of output current for single phase full wave rectifier…

Q: A single-phase full-wave transistor rectifier power to motor load. The source feeds voltage is 230V,…

A: In this question, choose the correct option What is average load current Io ? This is single phase…

Q: Design a rectifier fed from 220-V line through a step-down transformer. The load requires an…

A: For the designing of rectifier fed from, supply through transformer. It is important to know the…

Q: A half wave rectifier feeds a load of 10ohms in series with inductance of 20mH. The input supply…

A: Given A half wave rectifier circuit along with its parameters.we need to determine the average dc…

Q: A full-wave rectifier is connected to a single-phase source and supplying an inductive load. For the…

A: Part (1): For the full-wave rectifier, four diodes are required in the bridge connection. To remove…

Q: A 100 kV, 50 Hz supply is fed to a rectifier ammeter (using a bridge rectifier) through a capacitor.…

Q: A thyristor used in a half wave rectifier used 220V , with firing angle 60°, total resistance load…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical…

A: In the Full bridge rectifier, two diodes conduct in a positive cycle and the other two diodes in a…

Q: Consider the circuit shown in Figure Q7. The full-wave bridge rectifier is supplied from a…

Q: In the full-wave rectifier circuit, the transformer has a turn ratio of 1:2. The transformer's…

Q: In a full wave bridge rectifier, the transformer secondary voltage of 15sin330t is connected to a…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A half-wave rectifier uses dio de, with internal resistance assumed to be constant at 402. If the…

Q: Electronic circuits Please show the step by step solution thank you. A Half-Wave rectifier…

A: Given data: C=4700F Iavg=1.4A Vavg=19.5V Data to be calculated: a) the ripple factor b) VLpk.

Q: The input impedance of the permanent magnet moving coil (PMMC) voltmeter is infinite. Assuming that…

A: Given circuit is - Input impedance of voltmeter is infinite.

Q: A sinusoidal voltage v,(t) = 20 sin wt is passed through half wave rectifier. Find 1) The period T.…

Q: (a) What value of filter capacitor is required to produce a 1% ripple factor for a full-wave…

A: For the given Full wave rectifier having RL = 1.5 K ohms V ripple = 1% of V peak V peak = 18 V…

Q: A full-wave rectifier produces an 60 V peak rectified voltage from a 60 Hz ac source. If a 10…

A: To charge a battery from AC supply or convert AC into DC rectifier (converter) circuits are used.…

Q: A three-phase bridge rectifier uses diodes rated at Idras (see Appendix A), VRRM =1000V and Vo=0.7V.…

A: It is given that: VRRM=1000 VVD=0.7 VL=0.5 mHIdrms=135 A

Q: A full-wave rectifier is connected to a 220V power supply through a transformator, which has a 40:1…

A: As per Bartleby guidelines we are allowed to solve only one question please ask the rest again.

Q: Question 2 It is required to use a full-wave rectifier with a centre-tapped transformer to design dc…

Q: 2. A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…

Q: Q2) Design a CT-FWR to supply a load of (50N) with a waveform of the following specifications: - Vdc…

A: In the question, Design a CT-FWR load resistance RL =50 ohm VDC = 12 V Ripple factor = 0.1% the…

Q: VIBO HaO Deg V vrdg = 24Vdo RL 120 Ohm c2

A: It is given Eripplepk-pk= 0.75V Standard average current diode rating : 1A, 2A, 3A, 4A, 5A…

Q: Design a DC power supply using FWR to perform the following requirements. Find V_dc, V_rms,…

Q: A full-bridge rectifier is supplied from a 220V AC source and operated at firing angle (a,)=60°.…

Q: 2.Design a rectifier fed from 220-V line through a step-down transformer. The load requires an…

A: We need to design a rectifier fed from 220 Volts line through a step-down transformer. The load…

Q: Design a full wave rectifier with capacitor filter, using a centrally tapped Trafo to supply a load…

A: To design full wave center tapped rectifier with capacitor 'C' first we have to calculate the…

Q: A 230 V, 20 Hp, 850 RPM, 73 A DC separately-excited DC Motor has an armature resistance of 0.176 Ohm…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

Q: single phase fully controlled bridge is operated with a resistive load R = 10 Ω, the input voltage…

A: In this question we have given single phase fully controlled bridge rectifier with R load....We have…

Q: Determine the output voltage for a bridge rectifier utilizing a transformer with a 110 Vrms primary…

A: In this question, Determine the output voltage for a bridge rectifier? a transformer with a 110…

Q: Which of the following indicates the correct rms value of the diode current for a 1-o full bridge…

Q: Determine the output voltage for a bridge rectifier utilizing a transformer with a 110 Vrms primary…

A: In this question, Find the output voltage of bridge rectifier if Secondary rms voltage = 18…

Q: Design a CT-FWR to supply a load of (50) with a waveform of the following specifications: - • Vdc =…

A: Vdc = 12 V

Q: single-phase full-wave uncontrolled bridge rectifier is supplying a h ductive load (L/R ratio is…

Q: Which of the following indicates the correct rms value of the diode current for a 1-o full bridge…

Q: A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal…

A: Given A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input…

Q: iv. Explain what carrier mobility is and elaborate on the factors that influence carrier mobility.…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: 5. In the full-wave controlled bridge rectifier has an ac input of 120 V rms at 60 Hz and a 10 2…

A: The power electronics problem can be solved easily

Q: Calculate the percent ripple for the voltage developed across a 120-microFarad filter capacitor when…

A: we need to calculate the percentage ripple for the voltage developed across a 120 microfarad filter…

Q: 20. The output of a single phase mid-point rectifier is 20 A, 150 V dc while the input supply…

Q: _1. A conductor carries a current that is equivalent to a 2.5 amp continuous current one direction…

A: The current in the conductor Idc=I1=2.5 A Full-wave rectifier Vavg=2VmπIavg=2Imaxπ opposite…

Q: ipping cults is vertically shifted of the output signal when a positive DC component applied to the…

A: We need to tell about whether the given statements are true or false.

Q: A conductor carries a current that is equivalent to a 2.5 amp continuous current in one direction…

A: Given, that the conductor carries a Dc-current of 2.5 A in one direction & a super-imposed…

Q: A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…

Q: The single-phase bridge rectifier is supplied from a 120-V, 60-Hz source. The load resistance is R =…

Q: In a DC power supply unit, a. the transformer steps up the input voltage b. the rectifier converts…

A: We need to select correct option for a rectifier .

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
What is the impedance of a transformer coil that has 340' of #18 copper wire and an inductance of 70mH at 60Hz? 1000’ of #18 copper wire is 16 ohms.
A coil having an inductance of 0.2H and a resistance of 10 ohm is connected across a 100V a.c. supply, calculate the phase difference between the supply voltage and the current when the frequency 470Hz; (Give your answer in degrees)
A generating voltmeter is required to measure voltage between 15kV and 250kV. If the indicating meter reads a minimum current of 2uA and maximum of 35uA. Assume that the speed of driving synchronous motor is 1500rpm. Determine the capacitance of the generating voltmeter. A. 1,2 pF B. 6.5 pF C. 15,2pF D. 1 pF
Given: HW Rectifier; transformer secondary voltage=32V; Capacitance 4700 micro farads; average load voltage is 18V. Determine the ripple factor and average load current.
Two reactors are connected in series across a 10 V, 10 kHz source. They are spaced so that there is no interaction between their electromagnetic fields. Coil 1 has an effective resistance of 200 Ω and an inductance of 200 mH. Coil 2 has an effective resistance of 300 Ω and an inductance of 10 mH. Determine: the total resistance, in ohms. the total inductive reactance, in ohms. the total impedance, in ohms. the current, in milliamperes. the total true power expended in the series circuit, in watts
A voltage v = 311 sin (377t + 600) is applied across a circuit having an inductance of 0.34 H. What is the magnitude of the impedance in ohms?
The impedance coil absorbs 250 watts when connected across 220 V, 60 Hz mains, it is then connected across 110 V, 25 Hz mains and also absorbs 250 watts. What is the inductance of the coil? Show complete solution.
A 3-phase, 60 Hz, 2200 V, induction motor develops 500 hp, 0.8 lagging pf and efficiency of 0.94. The power factor is raised to 0.90 lagging by connecting a bank of condensers in delta across the lines. If each of the capacitance unit is built up of four similar 550 V condensers, find the required capacitance of each condenser.