Consider a homogeneously doped n-type semiconductor at 300K. The electron concentration is equal to 105 cm, n= 10"cm³, H,= 1000 cm/V-sec, u,= 500 cm²/V-sec, Tno=2×10's, Tpo=1×10's and the applied electric field is zero. A light beam in x-direction was applied to the sample resulting excess e-h pair of 3×10² cm³ at x-0 (edge of the sample). Assuming steady state, then hole concentration at x=20um is . .×10"cm³. (use kT=0.025eV at 300K) a) b) 3.4 c) 5.1 d) 10.1 e) 15.2

Consider a homogeneously doped n-type semiconductor at 300K. The electron concentration is equal to 105 cm, n= 10"cm³, H,= 1000 cm/V-sec, u,= 500 cm²/V-sec, Tno=2×10's, Tpo=1×10's and the applied electric field is zero. A light beam in x-direction was applied to the sample resulting excess e-h pair of 3×10² cm³ at x-0 (edge of the sample). Assuming steady state, then hole concentration at x=20um is . .×10"cm³. (use kT=0.025eV at 300K) a) b) 3.4 c) 5.1 d) 10.1 e) 15.2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An ideal photo-diode of unit quantum efficiency, at room temperature, is illuminated with 8 mW of radiation at 0.65 µm wavelength. Calculate the current and voltage output when the detector is used in the photo-conductive and photovoltaic modes respectively. The reverse saturation current (Is) is 9 nA
A silicon sample at room temperature is doped with gallium (Ga) from one side such that Ndoping=38.85x1015e−x/α , α = 0.5 µm, and Ndoping >> ni. Calculate the electric field at x= 1µm.
Calculate the drift current in silicon at room temperature. If the intrinsic carrier concentration of (1×1016electron/m³) with the doping concentration of (2×1016atoms/m³) of the phosphorus and (1×1016atoms/m³) of Boron. Given the mobility for the electrons (0.15m2/V.s), the mobility for the holes (0.05m2/V.s), the electric field (100V/m), and the cross section area is 1mm?.
Consider a pure Sn crystal that has εr = 24 and the number of Sn atoms per unit volume, N = 2.39 × 1028 m-3. What is the electronic polarizability due tovalance electrons per Sn atom? Suppose that a Sn crystal sample is electroded on opposite faces and has a voltage applied across it. By how much is the local field greater than the applied field? Given, εo= 8.85 × 10-12 F/m.
You are given an intrinsic silicon at "some" temperature. Assume that the intrinsic Fermi level, E, is exactly at the middle of the of the conduction band edge, Ec, and the valence band edge, Ev. It is known that the Fermi-Dirac probability for electrons at the conduction band edge is fe(E) = 5×102 at the unknown temperature. 1. What is the probability to find holes fh(Ec) at the conduction band edge?2. What is the Fermi-Dirac probability for electrons at the valence band edge, fe(Ev)?3. What is the Fermi-Dirac probability for holes at the valence band edge, fh(Ev)?
Given a Si sample of unknown doping, Hall measurement has been made and thefollowing information obtained: W = 0.05 cm, A = 1.6 x 10-3 cm2, I = 2.5 mA, and themagnetic field is 30 nT (1T = 104 Wb/cm2). If a Hall voltage of +10 mV is measured, findthe Hall coefficient, conductivity type, majority carrier concentration resistivity, and mobilityof the semiconductor sample.
Silicon cylinder of radius r = 1 cm carries a current of 100 mA at roomtemperature.What is the intrinsic carrier (electrons n and holes p) drift speed?
Silicon wafers are made to create the most groundbreaking invention of mankind - microprocessors. If two silicon wafers (assume dipoles), both with masses of 125grams, radii of 10cm and thickness of 7μm are placed close to each other, separated by distance of 3cm, what is the electric field strength experienced by an electron placed on the surface of the negatively charged wafer? What is the final velocity of the electron upon reaching the positively charged plate? How much power is generated by the electron in its travel?
A silicon sample is supporting an electric ﬁeld of −1500 V/cm, and the mobilities of electrons and holes are 1000 and 400 cm2/V·s, respectively. What are the electron and hole velocities? If p=1017/cm3 and n=103/cm3, what are the electron and hole current densities?
A 10KQ resistor is made of two strips connected in parallel, each one has 40µm thick, and 6mm long, one strip is of intrinsic germanium and has 0.5mm wide. Determine the width of other strip if it made of Ge., doped with 10 21 donor atom/cm ,at the working temperature. The intrinsic carrier density of Ge is 2.5 x 1019 m3, and the electron and hole mobilities are 0.4 m2 N.sec. and 0.2 m? N.sec. respectively.
You are given an intrinsic silicon at "some" temperature. Assume that the intrinsic Fermi level, E, is exactly at the middle of the of the conduction band edge, Ec, and the valence band edge, Ev. It is known that the Fermi-Dirac probability for electrons at the conduction band edge is fe(E) = 5×102 at the unknown temperature. 1.What is the Fermi-Dirac probability for electrons at the intrinsic Fermi level, fe(Ei)?
A diffused silicon PN junction has a linearly graded junction in the P-side with ?=10^19cm−3, and a uniform doping of 3×10^14 cm−3on the N-side. If the depletion layer width of the P-side is 0.8μm at zero bias, find the total depletion layer width, built-in potential, maximum field at zero bias and sketch the potential distribution.