Answered: Consider a semiconductor bar with w-0.1…

Consider a semiconductor bar with w-0.1 mm, d-10 um and L-5 mm. for B-104 Wb/cm2, and a current of 1 mA, we have VH-2mV, Vapplied 100 mV. The mobility of the majority carrier is (cm2. (V.s)').

Modern Physics

3rd Edition

ISBN:9781111794378

Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Publisher:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Chapter12: The Solid State

Section: Chapter Questions

Problem 16P

See similar textbooks

Related questions

Q: Now we substitute this expression for AQ = IAt. The current density %3D J=nqvd. If there is more…

A: We consider a short cylinder with an axis parallel to the drift velocity and it has a…

Q: An intrinsic semiconductor has 2×1016/m³ was doped with 1018 /m? acceptor impurities. If the…

A: Given-n=2×1016/m3p=1018/m3Mobility of the electron μn=0.13 m2/V.sMobility of the hole μp= 0.04…

Q: An unknown semiconductor has a band gap, Eg =1.1 eV and NC = NV where NC and NV are effective…

A: The data given in the question is as follows: 1. Band gap, Eg=1.1 eV 2. NC=NV 3. Donor level,…

Q: The maximum power dissipation of a transistor is 100mW. If VCE = 20V, what is the maximum collector…

Q: Germanium doped with 1024 m Al atoms is a semi-conductor at room temperature and each Al atom…

A: Electrical Conductivity of this material = 2.4 × 104 per ohm per meter

Q: What is the hole diffusion constant (cm2/s) in a piece of silicon doped with 3x1015cm-3 of donors…

Q: In a p-n junction diode, the current I can be expressed as eV 1=1, exp 2k„T where I, is called the…

A: In the given question , We have to determine the forward current at a given forward voltage.

Q: if the energy gap is between( 1.2 and 5) eV this is a conductor: semiconductor: insulator If the…

A: Energy gap between (1.2 and 5 )ev Insulator Diode current is 0.08386mA

Q: Q1/ At 300K, the intrinsic concentration of Ge is 2.5 x 1019 m-3. Given thet the mobility of…

A: Here at given temperature at 300 k the intrinsic concentration of th Ge is 2.5 × 10¹⁹ m-³. It also…

Q: Assume that Fermi energy level is 0.33eV above valance band energy. Calculate the electrons…

A: Given, Fermi energy level in 0.33eV abovevalance bondEF-EV=0.33 eVwhere EF is fermi energy levelEV…

Q: How does the resistance of: i) a semiconductor ii) an alloy vary with temperature?

A: i) The resistance of semiconductor decreases with increase in the temperature. The resistance is…

Q: Q.1: A transistor has a collector current of 10 mA and a base current of 40 micro-A. What is the…

A: Solution:

Q: Calculate the concentration of the electrons and the holes (in electrons/m?) for intrinsic silicon…

Q: Consider a silicon crystal at 27° C doped with atoms at a concentration of Na = 10" cm 1- Calculate…

Q: | Find the resistivity at 300 K for a Si sample doped with 1.0x10 cm' of phosphorous atoms, 8.5x 102…

A: Write the given value of this problem. Phosphorus atom=1×1014 cm-3Arsenic atom=8.5×1012 cm-3Boron…

Q: For faithful amplification by a transistor circuit, the value of VcEShould for silicon transistor А.…

A: In the given question we have to discuss about the value of voltage of common emitter transistor…

Q: What is the probability of an electron being thermally promoted to the conduction band in silicon…

A: Given Data : The value of Eg for silicon is given as Eg = 1.07 eV. The room temperature is given as…

Q: Consider a silicon pn junction at T 300 K. Assume the doping concentration in the n region is 1020…

A: GivenT=300 KDoping concentration in n region ,Nn=1020 cm-3Doping concentration in p region ,Np=1019…

Q: The GaAs sample at T= 300 K with doping concentrations of [Na=0 and Na- 10¹6 cm-³]. Assume complete…

Q: Calculate the drift current density in (mA/m2) for the silicon at room temperature. If the intrinsic…

A: First of all, we have to write down the given conditions, ni = 2×1016 electrons/m3Np = 3×1016…

Q: Calculate the amount of gate-to- source voltage necessary to regulate a JFET's drain current at a…

Q: Determine the thermal-equilibrium concentrations of electrons and holes in silicon at T =300 K if…

A: Given : Temperature →T=300 K Fermi energy →Ef=0.2 eV Band gap→Eg=1 eV C.B concentration→Nc=2×1019…

Q: For a certain semiconductor, the Fermi energy is in the middle of its band gap. If the temperature…

A: Given The temperature of semiconductor is T=285 K. The energy in the bandgap is Eg=0.005 eV. The…

Q: Consider a silicon pn junction at T 300K with acceptor doping concentrations of 10t cm- and donor…

Q: calculate the thermal equilibriumi concentrutin of electron and holes Fora given fermi enersy…

A: The change in the Fermi level is a function of a donor and acceptor impurity concentration that are…

Q: Calculate the thermal-equilibrium of electron concentrations per cubic centimeter in a compensated…

A: GIVEN: Temperature T = 270C OR 300k impurity doping concentration Na =2×1015cm-3 Nd=5×1014cm-3

Q: Consider a silicon pn junction at T = 300 K. Assume the doping concentration in the n region is 1020…

Q: O 3/ A / A doped semiconductor has 10 billion silicon atoms and 15 million pentavlent atoms. If the…

A: Semiconductors are materials whose conductivity falls in between conductors and insulators. Charge…

Q: At 300K, the intrinsic concentration of Ge is 2.5 × 1019 m-3. Given thet m? m2 the mobility of…

A: Intrinsic concentration of Ge at 300 K n=2.5*1019/m3, mobility of electron ue=0.38 m2/V.s, mobility…

Q: Consider a 2-dimensional sheet of the dichalcogenide semiconductor, MoSz, with an exciton binding…

A: Given data The energy is, E=90 meV The number of state is n=1 The energy in joules is,…

Q: In the given figure, assuming all transistors are minimum size with channel resistance R-8kN and…

Q: For a BJT transistor if VCC=8V, VCE= 8V, the transistor will operate in region O cutoff active…

A: For BJT transistor , VCE = VCC - ICRC

Q: Consider silicon at T-300 k. A Hall Effect device is fabricated with the following parameters:…

A: in this question we use electron carrier mobility equation.

Q: What is the hole diffusion constant (cm2/s) in a piece of silicon doped with 3x1015cm-3 of donors…

Q: Problem 5.16 The density of copper is 8.96 gm/cm, and its atomic weight is 63.5 gm/mole. (a)…

Q: The transfer characteristic curve of a transistor, having input and output resistance 100 Q and 100…

Q: Calculate the gain at the onset of coherent light generation for a GaAs diode. Assume a = 15 cm',…

Q: At 25°C, the electrical resistivity of an intrinsic Gallium Arsenide (GaAs) is 0.042 ohms.cm and the…

A: The electrical conductivity of GaAs at 25oC can be determined as, Here, ρ represents the electrical…

Q: Consider a silicon pn junction at T = 300 K with an acceptor doping concentration (1 x 101cm-3) and…

A: Write the expression for the built-in potential barrier. Here, k represents the Boltzmann constant,…

Question

I need the answer as soon as possible

Consider a semiconductor bar with w-0.1 mm, d=10 um and L-5 mm. for B-10-4 Wb/cm2,
and a current of 1 mA, we have VH-2mV, Vaplied 100 mV. The mobility of the majority
carrier is (cm2. (V.s)').

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Why does the horizontal Line in the graph in Figure 9.12 suddenly stop at the Fermi energy? Figure 9.12 (a) Density of state for a free electron gas; (b) probability that a state is occupied at T = 0 K; (c) density if occupied states at T = 0 k.
The measured density of a KCl crystal is 1.984 g/cm3. What is the equilibrium separation distance of K+ and Cl- ions?
The measured density of a CsCl crystal is 3.988 g/cm3. What is the equilibrium separate distance of Cs+ and Cl- ions?
Q.1: A transistor has a collector current of 10 mA and a base current of 40 micro-A. What is the current gain of the transistor? A transistor has a current gain of 175. If the base current is 0.1 mA, what is the collector current? A transistor has a collector current of 100 mA and the current gain is 65, What is the emitter current? Q.2: Suppose you measure a VBE of 1v. What is the collector-emitter voltage? What is the collector-emitter voltage in the three preceding examples if the base supply voltage is 5v?
Consider a n-type Si crystal at room temperature (300K) doped with 6 x1016 cm-3 arsenic impurity atoms and with certain number of shallowholes. Find out the equilibrium electron concentration, hole concentrationand Fermi level EF with respect to Ei, and the conduction band edge EC.For Si at 300K, the value of ni is 1.45 x 1010 cm-3 and k = 1.38 x 10-23 J/K,1eV = 1.60 x 10-19J. The band gap energy, Eg, of Si is 1.2eV.Solution:n @ Nd = 6 x 1016 cm-3.In equilibrium condition, hole concentration = 3.5 x 103 cm-3.EF – EI = 0.396eVEC – EF = 0.164eV.
the carrier distribution in the conduction band is:nc(E) = gc(E) . f(E) a) For a non-degenerate semiconductor, show that nc(E) has a maximum at E = Ec + ½ kT b) What is the ratio of carrier distribution at E = Ec + kT to that of the max value ?
For silicon at T = 500 K with donor density N_D = 5* 10^{13} cm^ and acceptor density N_A = 0 calculate the equilibrium hole concentration in cm^{-3}. In this problem, you can assume the bandgap energy and effective masses are independent of temperature and use the room temperature values for them. Values within 5% error will be considered correct.
For silicon at T = 300 K with donor density N_D = 1 * 10^9 cm^{-3} and acceptor density N_A = 0, calculate the equilibrium hole concentration in cm^{-3}. Values within 5% error will be considered correct.
For silicon at T = 300 K, calculate the equilibrium electron concentration in cm^{-3} if EC−EF=0.3eV. Values within 5% error will be considered correct.
Since the Fermi energy level of zinc is EF = 9.47 eV, what is the number of electrons per unit energy per unit volume at this energy level? Since the resistivity of zinc is 5.90 x 10^-8 ohm.m, calculate the average time interval between collisions of electrons.
Suppose a pure Si crystal has 5 × 1028 atoms m-3. It is doped by 1 ppm concentration of pentavalent As. Calculate the number of electrons and holes. Given that ni =1.5 × 1016 m-3.